密度比和吹风比对透平静叶气膜冷却的影响

燃气轮机中冷却空气和高温燃气的密度比和吹风比是影响透平叶片气膜冷却性能重要因素。本文采用压力敏感漆技术,对燃气轮机第一级静叶栅气膜冷却的冷却性能进行了实验研究。实验中测量了静叶栅在不同密度比（1．5／1．0）和不同吹风比条件下的冷却效率。密度比的改变射流的出口动量,造成射流出口的流动特征发生变化,从而影响冷却效率,影响...     

纵向冲击压缩下LY12铝合金圆环的塑性失稳

通过对铝合金圆环的纵向冲击压缩研究发现,一定条件下在试件的宏观塑性硬化阶段会出现明显的应力降过程。为揭示此应力降的发生机制,对润滑、细磨、粗磨3种端面粗糙条件下,外径、内径和高度比值为6:3:2的LY12铝合金圆环进行系统的Hopkinson压杆纵向冲击实验。结果表明:应力降主要发生在较大的应变和较高的应变率条件。进一步对实验样品的金相观察发现:应力降产生的内在机制为绝热剪切带的形成和发展,此现象是一种动态塑性失稳的过程。以上结果为金属材料在冲击条件下绝热剪切带产生的研究提供了参考。     

温压炸药爆炸性能实验研究

为研究温压炸药的爆炸特性,将25 g温压炸药在5.8 L的密闭爆炸罐中引爆,测试了真空和空气环境下的爆炸压力和爆炸温度,并通过气相色谱分析了爆炸后的气体产物。实验结果表明,温压炸药在空气环境下的平衡压力和平衡温度明显高于真空环境,并且空气中的氧气参与了炸药中铝粉的氧化反应,说明温压炸药在空气环境下存在后燃效应。     

Steering forces on undriven tractor wheel

The steering forces on an undriven, angled wheel mounting a 6-16 8PR tire were measured on a wheel test carriage at zero camber angle and at 1.5 km/h forward speed in a soil bin with sandy clay loam soil. The lateral force developed was found to be a function of slip angle, normal load, and inflation pressure for a particular soil condition. An exponential relationship could estimate the coefficient of lateral force of the 6-16 tire. The coefficients of this equation were found to be linearly related to inflation pressure. Rolling resistance of the wheel tested was found to be a function of slip angle, normal load, and inflation pressure for the soil condition tested. A linear relationship existed between the rolling resistance and slip angle, where the coefficients were found to be a function of inflation pressure and normal load. The generalized equations developed in the present study for estimating coefficients of lateral force and rolling resistance by taking both the tire and operating parameters into account, were found to be reasonably good by looking at the high coefficient of determination between experimental and estimated values.     

不同卸围压速率下花岗岩的力学性质及声发射特征

为了研究不同卸围压速率下花岗岩的力学性质,利用RMT-150B岩石力学试验系统对花岗岩试样进行恒轴压卸围压应力路径试验。试验结果表明:相同的初始围压下,随着卸围压速率增大,岩样的延性减小,表现为脆性破坏。卸围压速率越大,卸围压阶段的应变率越高,但总变形量小;当卸围压的速率相同时,初始围压越高,卸围压阶段岩样的应变率和总变形量越大。采用Mogi-Coulomb强度准则对试验结果进行拟合,结果显示:卸围压速率对花岗岩的黏聚力有劣化作用,对岩石的内摩擦角有强化作用;卸围压速率越小,振铃计数的活跃期越长,表明在低卸围压速率下,花岗岩岩样内部损伤发展缓慢且完全。     

微型超高压宝石喷嘴内部的空化与磨损

宝石喷嘴是影响超高压水射流切割系统工作效率的重要部件,而宝石内部的空化直接影响射流的形成,也是宝石磨损的重要原因之一。对400 MPa压力范围内宝石孔内部的空化两相流进行了数值模拟,阐述了射流在宝石内的形成过程,分析了长径比、压力和入口形状对宝石内空化的影响,并在相应压力下对宝石喷嘴的磨损进行了实验研究。结果表明:宝石内部的空化发展程度随着长径比的增大而减弱;在一定的长径比范围内,空化可以发展到喷嘴出口,并最终使射流的初始直径小于喷嘴直径,且在此条件下当压力升高时,射流的初始直径增大;良好的入口形线可以降低空化的发展程度;宝石入口的磨损较出口更显著,空蚀和高压水的冲蚀造成了宝石孔边缘形状的破坏,这种破坏随着压力的升高而加剧,选择合适的长径比是减少冲蚀磨损的有效途径。     

基于压电振荡原理的微阵列点样系统的研制

针对基于电磁微阀原理的非接触点样方式存在操作过程复杂、点样量偏大,以及压电喷墨原理的非接触点样方式存在点样针不易清洗、造价昂贵等不足,研制了一种基于压电振荡原理的新型非接触点样装置,实现了微量液体点样.在本装置中,毛细管点样针与压电驱动装置为两个独立单元,可以单独对毛细管点样针进行更换和清洗.采用激光拉制法制备的玻璃毛细管点样针具有内径可调、成本低等优点.此点样方式通过改变压电陶瓷的振幅和频率,可在10Symbolm@@_10～10Symbolm@@_9 L之间调控点样体积.以此为基础,结合三维精密位移控制技术,研制了一种基于压电振荡原理的微阵列生物芯片点样系统.对点样系统的点样体积、点样密度、点样精度等参数进行了测试,结果表明,此点样系统的最小点样体积可达320 pL,点样密度可达4000 点/cm2,并能够实现界面图案化制备.     

高聚物固体电解质聚氧化乙烯－溴化铜复阻抗谱及介电常数的静水压效应

采用分子量５００万的聚氧化乙烯和无水溴化铜，通过混溶蒸发法制备成高聚物固体电解质Ｐ（ＥＯ）ｎ－ＣｕＢｒ２薄膜，并在０．１～３００ＭＰａ范围不同的流体静水压下详细测量其复平面阻抗谱，分别得到在不同压力下离子电导率和介电常数与测量频率的关系．进一步解谱准确地求出Ｐ（ＥＯ）ｎ－ＣｕＢｒ２（ｎ＝１２、１６）薄膜离子电导率和介电常数的静水压效应，并结合Ｘ－光物相分析，根据离子迁移通道的物理图象和高聚物的极化机构进行了初步的讨论．添加２０％的增塑剂碳酸丙烯酯，较大改进了压力下的导电性．１２０～３００ＭＰａ的离子电导率提高一个数量级     

带阻尼项的三阶脉冲微分方程的振动性与渐近性

解决了一类带阻尼项的三阶脉冲微分方程的非振动解与其一阶、二阶导数的符号关系,用迭代法得到其振动性与渐近性的判别准则,并举例说明准则的有效性.     

Flow induced oscillation of two rigid rectangular plates in a side-by-side configuration

The present work is an experimental study of two oscillating rigid plates placed in side-by-side configuration, hinged at their leading edges, subjected to low subsonic flow. This problem is investigated using smoke-wire flow visualization, hot-wire anemometry, and time resolved particle image velocimetry. It is found that beyond a critical Reynolds number, the plates set into oscillatory motion. This critical Reynolds number depends on the gap between the plates. It is also seen that this value of Reynolds number, at lower values of gap to thickness ratio (<7) is significantly higher than that of the single plate configuration value. The frequency and amplitude of the oscillating plates at various gaps and Reynolds numbers have been studied and compared with the characteristics of an oscillating single plate. It is also found that depending on the gap and acceleration of the free-stream, there exist two modes of oscillation - (i) in-phase and (ii) out-of-phase. For gap to thickness ratio less than 10, only in-phase oscillations take place for all values of free-stream velocity considered in the present work, whereas, when this ratio is greater than 10, the mode of oscillation depends on the initial conditions up to a certain free-stream velocity, beyond which the plates switch to in-phase mode. Smoke wire flow visualization technique along with time resolved particle image velocimetry reveal that the vorticity distributions around the plates are responsible for the initiation of the two modes of oscillations.