F／Cl比与Eu~（2＋）：BaFCl中F色心的浓度和光激励截面的关系

研究了Ｅｕ（２＋）：ＢａＦｘＣｌ２在紫外线辐照下的光激励发光。通过改变激励方式及激励光的扫描方向，给出了Ｅｕ（２＋）：ＢａＦｘＣｌ２－ｘ光激励发光过程中，两种Ｆ色心的浓度比值与光激励截面比值的测定方法。利用这种测定方法，进一步研究了两种Ｆ色心的浓度比值和光激励截面比值与Ｆ／ＣＩ比值的关系。     

Near-barrier fusion reactions induced by α on197Au,193Ir,191Ir,185Re,181Ta,121Sb and69Ga nuclei

Fusion-evaporation cross-sections for the α-induced reactions upon¹⁹⁷Au,¹⁹³Ir,¹⁹¹Ir,¹⁸⁵Re,¹⁸¹Ta,¹²¹Sb and⁶⁹Ga nuclei at bombarding energies near the Coulomb barrier have been measured by off-line observation of the γ-rays emitted in the radioactive decay of the residual nuclei using stacked foil technique. The total fusion cross-section for the systems have been compared with simple statistical model calculations using the code ALICE/91 as well as with the coupled channel calculations that include the β₂ and ν₄ slatic deformations and dynamic couplings of the vibrational/rotational states of the target and the projet tile using the code CCDEF.     

A branching process model for sand avalanches

An analytically solvable model for sand avalanches of noninteracting grains of sand, based on the Chapman-Kolmogorov equations, is presented. For a single avalanche, distributions of lifetimes, sizes of overflows and avalanches, and correlation functions are calculated. Some of these are exponentials, some are power laws. Spatially homogeneous distributions of avalanches are also studied. Computer simulations of avalanches of interacting grains of sand are compared to the solutions to the Chapman-Kolmogorov equations. We find that within the range of parameters explored in the simulation, the approximation of noninteracting grains of sand is a good one.     

锰结核中硅,铝,铁,镁,磷,钾,锰,钛的XRFA

本文叙述了用XRF分析锰结核中Si、Al、Fe、Mg、P、K、Mn和Ti的方法。按照通常锰结核的主次成分制备6个人工合成标准,根据Sherman方程计算了已知成分(二元系统)的相对强度。用L-T方求得了互致元素校正的理论α系数(基本的、混合的、修正的),用DATAFLEX151B计算机以BASIC语言汇了“PRA,APU”计算机程序。然后进行非线性回归分析了锰结核样品得到了满意的结果。     

Si1－xGex/Si量子阱发光材料的分子束外延生长及其结构研究

采用固源Si分子束外延,在较高的生长温度于Si(100)衬底上制备出Si1－xGex/Si量子阱发光材料。发光样品的质量和特性通过卢瑟福背散射、X射线双晶衍射及光致发光评估。背散射实验中观察到应变超晶格的反常沟道效应;X射线分析表明材料的生长是共度的、无应力释放的,结晶完整性好。低温光致发光主要是外延合金量子阱中带边激子的无声发射和横光学声子参与的激子复合。并讨论了生长温度对量于阱发光的影响。     

Effect of borohydride as reducing agent on the structures and electrochemical properties of Pt/C catalyst

In this paper, we found that boron deposited on the surface of support when sodium borohydride used as reducing agent during the preparation of Pt/C catalyst. The deposition of boron markedly reduces particle size of Pt, raises electrochemical active surface (EAS) area of catalyst and electrochemical activity for hydrogen evolution or oxygen reduction reaction (ORR) compared with which prepared using other reducing agents (hydrogen and formaldehyde).     

Effect of oxygen exposure on the magnetic properties of ultrathin Co/Ge(1 1 1) films

Influences of oxygen exposure on the magnetic properties of Co/Ge(1 1 1) ultrathin films have been investigated by surface magneto-optic Kerr effect technique. As the oxygen exposure increases on Co/Ge(1 1 1) films, their magnetic properties could be modified. As an example for 15 ML Co/Ge(1 1 1) films, the coercivity increases from 730 to 920 Oe and the remanence Kerr intensity is reduced for 500 Langmuir (L) of oxygen exposure. Corresponding compositions analyzed by Auger electron spectroscopy measurement shows that the amount of oxygen on the surface layers increases with increasing the oxygen exposure time. Oxygen distributes on the topmost layers of the film. The adsorbed oxygen influences the electronic density of states of Co and results in the changes of the magnetic properties. Besides, the appearance of O/Co/Ge interface could modify the stress anisotropy, and as a result the coercivity of ultrathin Co/Ge(1 1 1) film is enhanced.     

Structural and magnetic properties of RF sputtered FePt/Fe multilayers

Series of [FePt(4min)/Fe(t_Fe)]₁₀ multilayers have been prepared by RF magnetron sputtering and post-annealing in order to optimize their magnetic properties by structural designs. The structure, surface morphology, composition and magnetic properties of the deposited films have been characterized by X-ray diffractometer (XRD), Rutherford backscattering (RBS), scanning electron microscope (SEM), energy dispersive X-ray spectroscope (EDX) and vibrating sample magnetometer (VSM). It is found that after annealing at temperatures above 500 °C, FePt phase undergoes a phase transition from disordered FCC to ordered FCT structure, and becomes a hard magnetic phase. X-ray diffraction studies on the series of [FePt/Fe]_n multilayer with varying Fe layer thickness annealed at 500 and 600 °C show that lattice constants change with Fe layer thickness and annealing temperature. Both lattice constants a and c are smaller than those of standard ones, and lattice constant a decreases as Fe layer deposition time increases. Only a slight increase in grain size was observed as Fe layer decreased in samples annealed at 500 °C. However, the increase in grain size is large in samples annealed at 600 °C. The coercivities of [FePt/Fe]_n multilayers decrease with Fe layer deposition time, and the energy product (BH)_max reaches a maximum in the samples with Fe layer deposition time of 3 min. Comparison of magnetic properties with structure showed an almost linear relationship between the lattice constant a and the coercivities of the FePt phase.     

A new insight into the understanding of the collapsed form of poly(N-isopropylacrylamide) molecules

Possible collapsed forms of poly(N-isopropylacrylamide) molecules are reviewed on the basis of first principle calculations. Various configurations and associated conformations are detailed. The calculated optimized structures exhibit different possibilities of creating networks of intra-molecular bonds of the hydrogen type. We show that the most remarkable one is able to form a local, self-saturated and well ordered helix. We also indicate in which direction the synthesis of the molecule should be oriented to improve its global behavior in term of hydrophobic/hydrophilic behavior.