VA族元素对阳极铅(Ⅱ)氧化物膜半导体性质的影响(Ⅱ)

用光电化学电流法研究了铅、铅砷、铅锑和铅铋合金在4．5mol·L－1H2SO4溶液（22℃）中，以0．9V（vs．Hg／Hg2SO4）极化7h而形成的阳极膜中的氧化铅的半导体性质，合金添加剂砷、锑和铋对t－PbO（四方氧化铝）和o-PbO（斜方氧化铝）的禁带宽度没有影响，从量子效率和电位的关系可求Pb，Pb－lat％As（at％表示原子百分比，全文同），Pb-lat％Sb和Sb－lat％Bi上膜中t－Pbo的施主密度（ND）分别为9．3×1015，1．0×1016，3．1×1016和1．3×1017cm-3，平带位分别为-0．20，－0．22，－0．28和-0．08V（vs．Hg／Hg2SO4）．比较VA元素砷、锑和铋对上述膜中t－Pbo的ND（从而自由电子密度）和膜中t－Pbo的生长速率的影响，可认为法添加剂砷、锑和铋对阳极膜中t-Pbo的作用符合Hauffe规则．     

壳聚糖-聚羟基丁酸酯共混膜的制备与性质

以乙酸为共溶剂,制备了壳聚糖-聚羟基丁酸酯(CTS-PHB)共混膜,利用红外光谱(FT-IR)、广角X粉末衍射(WAXD)、扫描电镜(SEM)及差热分析(DTA)表征了共混膜的化学组成、晶形、形貌和热稳定性能。研究表明:CTS和PHB可在体积百分数为62.5%的乙酸溶液中共混,形成表面光滑、不透明的膜,干态共混膜具备一定的力学强度。各比例的CTS-PHB共混膜有相同的热分解温度,共混膜的形貌特征随两组分质量配比变化,其中mPHB/mCTS=1/1的共混膜显示出良好的有序结构。     

Donor-acceptor properties, catalytic activity, and negative charge exoemission from the alumina surface modified with lithium cations

Donor-acceptor properties of alumina modified with lithium cations were studied by ESR of paramagnetic complexes of adsorbed anthraquinone. The results were compared with the data on negative ion emission (exoemission) accompanying the decomposition of isopropyl alcohol in the adsorption layer. The data on the activity measured by the pulse microcatalytic technique in isopropyl alcohol decomposition are discussed. Small additives of lithium were found to promote catalytic activity of the samples. The role of acid and basic sites in isopropyl alcohol decomposition was discussed. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 4, pp. 616–621, April, 2006.     

ESR study of products of transformation of 3,6-tert-butylpyrocatechol on alumina, zinca, silica, and titania

The formation of semiquinone and phenoxazyl radicals and metallocomplexes with semiquinone ligands was observed by ESR during the interaction of di-tert-butylpyrocatechol with Al₂O₃, ZnO, SiO₂, and TiO₂. In the case of different modifications of SiO₂, admixtures of TiO₂ exhibit a higher reactivity in complex formation with the organic substrate. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 10, pp. 1975–1978, October, 1998.     

有机硅耐磨透明涂层的固化分析

ＦＴＩＲ、ＴＧ、ＴＢＡ等对有机硅耐磨涂料（有机硅溶胶）的热固化过程研究表明有机硅胶体中缔合羟基间的脱水缩合速率很高；羟基脱水程度与固化温度有关，温度越高，达平衡时羟基的浓度越低，在１０５～１３０℃间羟基的浓度变化最大，加入适当的固化剂，对羟基的脱水交联有促进作用，在较高的固化温度下，反应体系中出现了环氧环异构化产生的酮羰基的吸收峰     

Preparation and Properties of Anti-Reflection/Anti-Static Thin Films for Cathode Ray Tubes Prepared by Sol-Gel Method Using Photoirradiation

A new technique for preparing anti-reflection/anti-static thin films for CRTs at low temperature has been developed. Double-layered films of SiO₂/SnO₂ were formed on a CRT panel surface by the sol-gel method using photoirradiation. The new method makes it possible to reduce heat treatment temperature (°C) by almost 50% and treatment time to approximately 33% of the conventional levels.     

催化裂化USY／ZnO／Al2O3脱硫添加剂的高温水热失活

 对USY／ZnO／Al2O3汽油催化裂化脱硫添加剂经高温水热老化处理前后的脱硫性能进行了考察，发现老化后添加剂的脱硫性能大幅度下降．采用XRD和IR等技术对USY／ZnO／Al2O3添加剂在高温和高温水热条件下失活的原因进行了研究．结果表明，在高温下，ZnO可与USY沸石中的铝发生固相反应生成ZnAl2O4尖晶石，从而造成USY晶体结构崩塌，转变成无定形状态．在ZnO含量较高的条件下，ZnO可继续与USY晶体结构崩塌后生成的无定形的硅和铝的氧化物反应，生成Zn2SiO4硅锌矿和ZnAl2O4尖晶石结构．这一方面使添加剂失去了可形成硫化物吸附中心的ZnO，另一方面破坏了硫化物的裂化活性组分USY，从而造成添加剂脱硫性能下降甚至失去脱硫活性．ZnO对USY的破坏作用主要与温度有关．在USY／ZnO／Al2O3体系中，ZnO被ZnO与Al2O3之间形成的锌铝尖晶石膜固定并与USY隔离，单纯的高温条件对添加剂的破坏不显著，而水蒸气可以促进ZnO的移动，有利于ZnO与USY的接触，因此在高温和有水蒸气存 在的条件下添加剂的结构易遭到破坏．     

Tribological properties of ormosil coatings

Transparent plastics are not scratch resistant. The damage leads to a loss of optical properties. Coatings prepared using either tetraethoxysilane or colloidal silica particles embedded in glymo is a way to avoid these disadvantages. Tribological experiments are carried out to better understand the surface modification due to a sliding friction. It is shown that the wear track is not directly related to usual mechanical properties such as Young's modulus and the hardness of the coating. The different stages leading to material loss are discussed in term of particle removal and debris circulation (accumulation or elimination) through the friction track. The mechanical properties of the film combined with the film to substrate adhesion are expected to play an important role as it can be deduced from results obtained as a function of the coating composition.     

SnO2-Nb2O5/MgAl2O4/α-Al2O3催化环氧乙烷水合制乙二醇

采用水热稳定的MgAl2O4尖晶石对-αAl2O3载体表面进行修饰,采用具有较强亲水性能的SnO2对活性组分Nb2O5进行修饰,制备了SnO2-Nb2O5/MgAl2O4/-αAl2O3催化剂,并用于环氧乙烷水合制乙二醇反应.采用X射线衍射、红外光谱和程序升温脱附研究了Sn/Nb摩尔比对催化剂酸性、环氧乙烷在催化剂表面的吸附状态和吸附强度以及催化剂性能的影响.结果表明,Sn/Nb摩尔比明显影响催化剂的组成和结构;催化剂的结构不同,环氧乙烷在催化剂表面的吸附强度存在明显差别,催化剂的催化性能明显不同.     

氧化钨薄膜微型电化学器件的研究

本文论述了WO_3薄膜氢离子敏器件的结构、原理、制备技术和测试分析。利用WO_3薄膜在H+溶液中由绝缘转化为导电特性,成功地研制成氢离子敏器件。这是一种简易而经济的微型pH敏器件技术。