Surface Modification of Bituminous Coal and Its Effects on Methane Adsorption

This paper studied the role of O‐containing groups over the coal surface in methane adsorption. The coal was modified with H₂SO₄, (NH₄)₂S₂O₈ or H₂SO₄/(NH₄)₂S₂O₈), respectively, to introduce O‐containing functional groups, and characterized by proximate analysis, ultimate analysis, Boehm titration, X‐ray photoelectron spectroscopy (XPS) and nitrogen adsorption. The results of ultimate analysis, Boehm titration and XPS indicate that there were increases in terms of both the content of oxygen and the quantities of O‐containing groups over the modified coals surface, especially for the carboxyl. Nitrogen adsorption shows that the modified coals possessed higher surface area and pore volume than that of 0‐XQ. The methane adsorption data were measured at 298 K at pressures up to 4.0 MPa by the volumetric method and fitted well by Langmuir model. Experimental results implied that O‐containing groups and pore structure affected methane adsorption. The adsorption capacities decreased as increasing quantities of O‐containing groups.     

含Co纳米介孔分子筛的制备与表征

用两步水热法合成出了含Co介孔分子筛,采用XRD,FT-IR,TPR,AFM,BET,B JH等方法对样品的物化性能进行了表征.结果表明合成出了纳米级具有介孔结构的CoMCM-41.样品在550℃焙烧可以将模板剂有效去除而不影响孔结构.所得CoMCM-41比表面积大于500 m2/g,平均孔径分布为3.57 nm,粒径分布在20~40 nm范围内.     

Particle scattering factor of pearl necklace chains

The particle scattering behaviour of a pearl necklace chain is derived. The chain is composed of sphere-like pearls, separated by rod-like segments of fixed length, which have no angular restrictions. By calculating several series of model scattering curves, the important structural features are retrieved. The model is believed to be useful in interpreting intermediate structures of collapsing macromolecules or polyelectrolytes. A first application to a shrinking polyelectrolyte coil generated by molecular dynamic simulations (Limbach and Holm, J.Phys.Chem. 2003) is presented and used to discuss the potentials and limits of the model.     

不同环大小分子筛对钼基分子筛催化剂上甲烷无氧芳构化反应的影响

 钼基分子筛催化剂，由于不同分子筛的孔道大小及孔道形状不同\r\n，对甲烷芳构化反应表现出不同的催化性能．具有8元环孔道结构的小\r\n孔ERS－7分子筛没有催化活性，说明甲烷的芳构化反应离不开分子筛孔\r\n道的择形作用，较小的孔道中不能生成苯等芳烃．具有10元环孔道结构\r\n的ZSM－5，ZSM－11和ZRP－1三种分子筛具有较好的催化性能，但由于\r\n其孔道大小及孔道形状的差别在催化行为上表现出一定的差异．具有1\r\n0元环和12元环孔道结构的MCM－22分子筛，尤其对苯等轻芳烃而言，催\r\n化性能最佳．具有12元环孔道结构的JQX－1以及中孔分子筛SBA－15，\r\n虽然具有一定的催化性能，但活性较低．研究结果表明，孔道大小与苯\r\n分子动态直径相近或孔道稍大的分子筛是催化甲烷芳构化反应的良好载\r\n体，孔道过大或过小都不利于苯和萘等芳烃的生成．     

碱性水蒸气处理的ZSM-5沸石酸性质及孔结构的影响

 采用XRD，NH3－TPD，比表面积和孔结构测定等研究了在不同温度下用含10％NH3的水蒸气处理时HZSM－5沸石n（Si）／n（Al）＝25）酸性质及孔结构的变化规律．结果表明，随着处理温度的提高，HZSM－5的结构未发生明显的变化；样品的总酸量下降很快，但弱酸分布量相对提高，而强酸分布量相对下降；提高处理温度，样品的比表面积和微孔体积减小，二次孔或中孔体积及外表面积有增大的趋势．     

高比表面积窄孔分布氧化铝的制备研究 Ⅰ.沉淀条件的影响

 以硫酸铝液为原料，以氨水、氢氧化钠和铝酸钠为碱沉淀剂，采用pH摆动法制备了高比表面积、大孔径、窄孔分布、大孔体积氧化铝，考察了沉淀剂、沉淀温度及沉淀时酸侧pH值对氧化铝物性的影响，并对pH摆动法与等pH沉淀法的结果进行了比较．结果表明，通过改变制备参数可以获得高比表面积、大孔体积的氧化铝，当沉淀温度为70℃，pH摆动3或4次时，氧化铝的孔体积可高达1．0ml／g，比表面积仍大于300m2／g．用pH摆动法制得的样品比用等pH沉淀法制得的样品容易酸溶，对挤压成型有利．不同样品在酸溶液中的分散性表明，用氨水沉淀剂可获得相对较小的沉淀粒子．改变沉淀时酸侧的pH值，可导致沉淀粒子的结构发生变化．     

Determination of Benzo(a)Pyrene and other Polynuclear Aromatic Hydrocarbons in Airborne Particulate Material by Ultrasonic Extraction and Reverse Phase High Pressure Liquid Chromatography

Abstract

Ultrasonic extraction of airborne particulate material on Hi-Vol filters is described. Almost all of the polar compounds are removed during the extraction by adsorption on the surface of the shredded glass fibers and controlled pore glass powder (CPG). The non-polar polynuclear aromatic hydrocarbons (PAH) in the extract are separated at room temperature by high pressure liquid chromatography (HPLC) on reverse phase Vydac using acetonitrile:water (70:30 v/v) as the chromatographic solvent. There is baseline separation of benzo(a)pyrene (BaP), benzo(k)fluoranthene (BkFt) and of benzo(e)pyrene (BeP), benzo(b)fluoranthene and perylene, the latter three present in one band. Extracts of airborne particulates show the same peaks. BaP elutes in approximately 14 minutes. Precision and accuracy measurements indicate full recovery of PAH and good extraction reproducibility. The detection limit of BaP at F 290/389 is less than 10 pg. Total analysis time is approximately 1 1/2 hr, most of which is waiting time.     

Monte—Carlo model of the diffusion-limited reaction kinetics in microheterogeneous media. Comparison with the experimental plots of the forward and backward electron phototransfer kinetics on the pore diameter in silica gel

The kinetics of the diffusion-limited decay reaction A + B B was simulated by the Monte—Carlo method on a two-dimensional square lattice with defects presented by randomly distributed sites. The cases were considered where [B] [A] at the random initial distribution (quenching reaction) and [B] = [A] with the initial distribution of the A and B particles on neighboring sites (geminate recombination). The kinetic curves were approximated by the simplest analytical equation [A]/[A]₀ = (1 – )exp[–(kt)^1–h ] + (where k and are constants). The plots of the heterogeneity parameter (h) and time-averaged first-order rate constant vs. concentration of defects (p) or B particles (in the case of quenching) were obtained and compared with similar correlations obtained earlier by the experimental study of the kinetics of forward (quenching reaction) and backward (geminate recombination) electron phototransfer on the surface of different porous silica gels. The experimental plots of h vs. silica gel porosity are in satisfactory agreement with the plots of h vs. p in the model space, if the fraction of volume inaccessible for reactants, calculated from the free silica gel volume, is chosen as the p parameter for silica gel.Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 8, pp. 1536–1541, August, 2004.     

金属-有机框架材料孔结构的初步理论评估

金属-有机框架材料在气体吸附/分离方面具有广泛的应用, 因而引起国内外学者的广泛关注。本文以6种代表性的MOFs为例简单介绍了利用理论工具研究MOFs孔结构的方法。     

Mesoporous Titanium-containing Silicas. Synthesis and geometrical characteristics

Mesoporous titanium-containing silicas with TiO₂ contents from 1 up to 70 mol% were prepared. The obtained samples have been characterized by the powder X-ray diffraction data, the diffuse reflectance infrared Fourier transform method, and nitrogen adsorption at 77 K. Specific surface area, total pore volume, distribution pore volume on pore sizes were determined from nitrogen adsorption isotherm for synthesized titanosilicas. This revised version was published online in August 2006 with corrections to the Cover Date.