基于新型长周期光纤光栅的掺铒光纤放大器

报道了基于高频CO₂激光脉冲写入的新型长周期光纤光栅的低噪音掺铒光纤放大器,这种新型长周期光纤光栅是用大约几千Hz的高频CO₂激光脉冲对光纤玻璃热冲击作用而形成的.在铒纤中插入一个长周期光纤光栅,会明显减少掺铒光纤放大器的放大自发辐射(ASE)噪音.报道了两种低噪音掺铒光纤放大器,作为前置放大器和线路放大器,它们的ASE噪音指数分别从4.0 dB减少到3.5 dB和从4.8 dB减少到4.3 dB,并且在作为线放时,其小信号增益从30 dB提高到37 dB,降噪及提高增益效应十分显著.     

Preparation and properties of homogeneous V2O5-SiO2 xerogel composite based on interpenetrating polymer network

In this paper, we report the conducting and electrochemical properties of a homogeneous V₂O₅-SiO₂ xerogel composite obtained from the simultaneous polymerization in both inorganic components (Si-O and V-O based polymers) forming an interpenetrating polymer network, where a mutual “solubility” due to cross-links and entanglements was observed. The presence of V₂O₅ inside the silica matrix has a strong effect on electrical conductivity; measurements showed room temperature conductivity almost 1000 times higher than what is found in the literature. In addition, the electrochemical behavior is quite similar to that found in V₂O₅ xerogel. Moreover, the effects of thermal treatment on the conducting and electrochemical properties were investigated. It was found that both properties were improved with no significant effect on V₂O₅ xerogel layered structure.     

Fiber-Optic Backscattering Profile Measurements for Determination of the Optical Coefficients of Turbid Media

The necessity of using anisotropic approximation in techniques for determining optical parameters from the backscattered radiation profile is shown. A fiber-optic technique for simultaneous determination of the anisotropy parameter as well as the scattering and absorption coefficients of turbid media is proposed. It is based on the comparison of the experimental backscattered radiation profiles and those obtained by the numerical Monte Carlo method.     

一种控制掺铒光纤激光器超混沌的方法——非线性延时反馈参数调制法

提出一种非线性延时反馈参数调制法来控制混沌/超混沌，给出了利用这种方法控制处于超混沌状态的双环掺铒光纤激光器的方案.数值模拟表明，只要延时时间和反馈强度合适就可以把双环掺铒光纤激光器从超混沌状态成功地控制到不同的周期状态. 关键词： 掺铒光纤激光器 超混沌 非线性延时反馈参数调制 混沌控制     

Synthesis and adsorption properties of gold nanoparticles within pores of surface‐functional porous polymer microspheres

Mesoporous polymer microspheres with gold (Au) nanoparticles inside their pores were prepared considering their surface functionality and porosity. The Au/polymer composite microspheres prepared were characterized by transmission electron microscope (TEM), X‐ray diffraction (XRD), and Brunauer–Emmett–Teller (BET) techniques. The results showed that the adsorption of Au nanoparticles could be increased by imparting the pore structure and surface‐functional groups into the supporting polymer microspheres (in this study, poly (ethylene glycol dimethacrylate‐co‐acrylonitrile) and poly (EGDMA‐co‐AN) system). Above all, from this study, it was established that the porosity of the polymer microspheres is the most important factor that determines the distribution and adsorption amount of face‐centered cubic (fcc) Au nanoparticles in the final products. Our study showed that the continuous adsorption of Au nanoparticles with the aid of the large surface area and surface interaction sites formed more favorably the Au/polymer composite microspheres. The BET measurements of Au/poly(EGDMA‐co‐AN) composite microspheres reveals that the adsorption of Au nanoparticles into the pores kept the pore structure intact and made it more porous. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 5627–5635, 2004     

三包层WⅠ和WⅡ型单模光纤波导色散特性的研究

研究了三包层WⅠ和WⅡ型单模光纤的波导色散特性。结果发现在相同条件下，三包层WⅠ和WⅡ型单模光纤零色散点的调节范围比传统的双包层W型单模光纤明显增大。详细分析了几何参量P、Q和光学参量R1、R2对单模传输时的波导色散特性和低次模截止频率的影响。所得的研究结果为获得更为理想的色散补偿、色散平坦光纤及设计新型无源光器件提供了重要的依据。计算波导色散的方法可推广到多包层光纤。     

新型AFM探针的制备及应用

采用熔拉 -腐蚀复合方法 ,将普通单模石英光纤制成直锥形光纤探针。利用自制工具将探针打弯 ,制成悬臂式光纤探针 ,在AFM上取得了较理想的测试结果。将自制光纤探针和商用硅材料探针获得的两种扫描图像进行了对比 ,分析了悬臂式光纤探针的特点     

Synthesis and characterization of white‐light‐emitting polyfluorenes containing orange phosphorescent moieties in the side chain

Two orange phosphorescent iridium complex monomers, 9‐hexyl‐9‐(iridium (III)bis(2‐(4′‐fluorophenyl)‐4‐phenylquinoline‐N,C^2′)(tetradecanedionate‐11,13))‐2,7‐dibromofluorene (Br‐PIr) and 9‐hexyl‐9‐(iridium(III)bis(2‐(4′‐fluorophenyl)‐4‐methylquinoline‐N,C^2′)(tetradecanedionate‐11,13))‐2,7‐dibromofluorene (Br‐MIr), were successfully synthesized. The Suzuki polycondensation of 2,7‐bis(trimethylene boronate)‐9,9‐dioctylfluorene with 2,7‐dibromo‐9,9‐dioctylfluorene and Br‐PIr or Br‐MIr afforded two series of copolymers, PIrPFs and MIrPFs, in good yields, in which the concentrations of the phosphorescent moieties were kept small (0.5–3 mol % feed ratio) to realize incomplete energy transfer. The photoluminescence (PL) of the copolymers showed blue‐ and orange‐emission peaks. A white‐light‐emitting diode with a configuration of indium tin oxide/poly(3,4‐ethylenedioxythiophene):poly(styrenesulfonate)/PIr05PF (0.5 mol % feed ratio of Br‐PIr)/Ca/Al exhibited a luminous efficiency of 4.49 cd/A and a power efficiency of 2.35 lm/W at 6.0 V with Commission Internationale de L'Eclairage (CIE) coordinates of (0.46, 0.33). The CIE coordinates were improved to (0.34, 0.33) when copolymer MIr10PF (1.0 mol % feed ratio of Br‐MIr) was employed as the white‐emissive layer. The strong orange emission in the electroluminescence spectra in comparison with PL for these kinds of polymers was attributed to the additional contribution of charge trapping in the phosphorescent dopants. © 2007 Wiley Periodicals, Inc. JPolym Sci Part A: Polym Chem 45: 1746–1757, 2007     

Deformation of styrene—divinylbenzene copolymers and hypercrosslinked polystyrenes during solvent adsorption and desorption

An automated procedure was developed for monitoring fast changes in the size of spherical samples of polymers during their contact with a solvent or drying. The kinetics of bulk deformation in these processes was studied for a series of cross-linked polymers, viz., gel-type and porous styrene—divinylbenzene copolymers and poly(divinylbenzenes), and hypercrosslinked polystyrenes. Gel, macroporous, and hypercrosslinked polystyrenes are substantially different in the rate, mechanism, and degree of swelling, which is associated with the principal differences in their physical structures. An unusual effect of a sharp decrease followed by a temporary increase in the volume of porous polystyrene and poly(divinylbenzene) materials were observed during desorption (evaporation) of organic solvents. Water desorption is accompanied by an excessive bulk compression of porous granules giving rise to negative deformations, which gradually relax to the state equilibrium for the dry polymer. The results of dynamic desorption porometry (for water desorption) are indicative of a bimodal size distribution of micropores in hypercrosslinked polystyrene. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 3, pp. 467–476, March, 2007.