Extension rate of the straight jet in electrospinning of poly(N‐isopropyl acrylamide) solutions in dimethylformamide: Influences of flow rate and applied voltage

In the electrospinning process, the measurement of extension rate of the straight jet is not an easy task. In this study, the diameter profile of the tapering straight jet is determined with a laser light‐scattering technique. Afterwards, the jet extension rate () is derived and used to compare with the solution‐intrinsic rates, for example, the terminal relaxation rate and the Rouse relaxation rate. The extension rate of the straight jet depends on position: it is highest near the cone apex (region I) and decays to a constant value in the major jet (region II) until approaching the jet end (region III), at which the extension rate abruptly drops to nearly zero, that is, _I >_II ≫_III ∼ 0. The jet diameter in region III is independent of solution concentration and applied voltage, but is scaled to the flow rate with an exponent of ∼0.37. The derived exponent is consistent with a simple prediction based on the counterbalance between the stretching electric force and the compressive force induced by the air drag force. Provided that air friction becomes overwhelming at the straight jet end, the long electrified jet is likely to buckle, thereby triggering the instability of jet whipping. © 2017 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2018 , 56, 319–329     

Investigation of droplet size distribution for liquid-liquid emulsions in Taylor-Couette flows

In this paper, we investigate oil-in-water emulsions in a Taylor-Couette flow. A high-speed camera was employed to record the formation of those emulsions, and image processing was used to obtain the diameter of the droplets. No surfactants were added in order to study the pure effect of the fluid dynamical forces on the droplets. The results for three different oil-in-water emulsions show that the Sauter mean diameter considerably depends on the local shear rate and the material properties and that the droplet size distribution follows a log-normal distribution. We, therefore, propose to express the Sauter mean diameter normalized by Prandtl mixing length in terms of a correlation, which is based on the Kolmogorov turbulence theory. This correlation subsequently depends on the local shear rate and the material properties such as viscosity, density, and interfacial tension. The predictions of the correlation show fairly good agreement with the experimental measurement the Sauter mean diameter. Finally, comparing the predictions of the correlation to the data presented by Eskin et al. [Chem. Eng. Sci. 161 36–47; 2017] shows excellent agreement in the case, where the droplets are larger than the Kolmogorov length scale.     

Ageing of polyethylene at raised temperature in contact with chlorinated sanitary hot water. Part I - Chemical aspects

In France, hot water quality control inside buildings is occasionally assured by disinfection treatments using sodium hypochlorite (between 0.5 and 1 ppm residual free chlorine). This disinfectant is a strong oxidizer and it could interact with metallic and polymer pipes used in hot water systems. To assess the long-term performance of these pipes, it is then necessary to study the impact of these treatments on the material behaviour, in particular for polymeric materials, even at relatively low disinfectant concentrations as used in potable water treatments. The objective of this work was to study the influence of sodium hypochlorite concentration on PERT/Al/PERT (PolyEthylene Raised Temperature) pipe degradation. Pipe samples were filled with chlorinated water solutions (concentrations ranging between 0 and 100 ppm) and maintained in static conditions during 270 days at 70 °C. The antioxidant depletion profile through a PERT wall was monitored using the oxidation induction time (OIT) method, which is a conventional technique of Differential Scanning Calorimetry. Chemical changes on the aged polymer were checked by Infrared Spectrometry. OIT change showed that the PERT stabilizing system was rapidly chemically consumed by the action of chlorinated water at 25 and 100 ppm concentrations. However, PERT degradation was strictly confined to the immediate inner wall. Only a 0.3 mm thick layer (inner part of the pipe) showed significant antioxidant depletion. An increase of the OH and C-O-C infrared bands was also observed on inner part of any samples during ageing which characterize the oxidation of the PERT on the inner wall.     

The effect of capillary column diameter on the performance of thermal conductivity detectors

The concentration sensitivity of a thermal conductivity detector (TCD) depends, among other factors, on the amount of sample mixture in the detector's sensing cell. Since the cell volume has to be appropriately matched with column diameter, it makes the concentration sensitivity of a TCD dependent on column diameter and, therefore, on the speed of gas chromatography. Through reduction of column diameter, higher speed tends to lead to a reduction in the concentration sensitivity of the cell. The factor which the most directly affects the concentration sensitivity of a TCD cell is the heat power conducted through the cell. The higher the power, the greater the sensitivity. The limit of detection of a TCD depends on the concentration-sensitivity of its cell and on the level of statistical errors in the measurement. The errors increase with increasing analysis speed. As the column diameter is reduced, the errors cause additional worsening (on top of the decrease in concentration sensitivity) of the detection limit, dynamic range, and other performance characteristics of the TCD.     

甲醇乳化柴油分散特性的研究

利用显微摄像技术及算术统计的方法表征了甲醇乳化柴油分散相-甲醇的平均粒径。研究了甲醇乳化柴油分散相（甲醇）的粒径分布随高速分散器转子转速、乳化时间、乳化剂用量和甲醇的质量分数等参数的变化。结果表明,甲醇乳化柴油分散相的平均粒径随转速、乳化剂用量的增加而减小,但随甲醇含量的增加而增大;当乳化时间为2min和转子转速为5×2800r/min,乳化剂的质量分数为5%和甲醇的质量分数为10%时,甲醇乳化柴油中分散相存在最佳的分散度,其值为16μm。
     

含Co纳米介孔分子筛的制备与表征

用两步水热法合成出了含Co介孔分子筛,采用XRD,FT-IR,TPR,AFM,BET,B JH等方法对样品的物化性能进行了表征.结果表明合成出了纳米级具有介孔结构的CoMCM-41.样品在550℃焙烧可以将模板剂有效去除而不影响孔结构.所得CoMCM-41比表面积大于500 m2/g,平均孔径分布为3.57 nm,粒径分布在20~40 nm范围内.     

Monte—Carlo model of the diffusion-limited reaction kinetics in microheterogeneous media. Comparison with the experimental plots of the forward and backward electron phototransfer kinetics on the pore diameter in silica gel

The kinetics of the diffusion-limited decay reaction A + B B was simulated by the Monte—Carlo method on a two-dimensional square lattice with defects presented by randomly distributed sites. The cases were considered where [B] [A] at the random initial distribution (quenching reaction) and [B] = [A] with the initial distribution of the A and B particles on neighboring sites (geminate recombination). The kinetic curves were approximated by the simplest analytical equation [A]/[A]₀ = (1 – )exp[–(kt)^1–h ] + (where k and are constants). The plots of the heterogeneity parameter (h) and time-averaged first-order rate constant vs. concentration of defects (p) or B particles (in the case of quenching) were obtained and compared with similar correlations obtained earlier by the experimental study of the kinetics of forward (quenching reaction) and backward (geminate recombination) electron phototransfer on the surface of different porous silica gels. The experimental plots of h vs. silica gel porosity are in satisfactory agreement with the plots of h vs. p in the model space, if the fraction of volume inaccessible for reactants, calculated from the free silica gel volume, is chosen as the p parameter for silica gel.Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 8, pp. 1536–1541, August, 2004.     

Open tubular capillary electrochromatography: A useful microreactor for collagen I glycation and interaction studies with low-density lipoprotein particles

Diabetes, a multifunctional disease and a major cause of morbidity and mortality in the industrialized countries, strongly associates with the development and progression of atherosclerosis. One of the consequences of high level of glucose in the blood circulation is glycation of long-lived proteins, such as collagen I, the most abundant component of the extracellular matrix (ECM) in the arterial wall. Glycation is a long-lasting process that involves the reaction between a carbonyl group of the sugar and an amino group of the protein, usually a lysine residue. This reaction generates an Amadori product that may evolve in advanced glycation end products (AGEs). AGEs, as reactive molecules, can provoke cross-linking of collagen I fibrils. Since binding of low-density lipoproteins (LDLs) to the ECM of the inner layer of the arterial wall, the intima, has been implicated to be involved in the onset of the development of an atherosclerotic plaque, collagen modifications, which can affect the affinity of native and oxidized LDL for collagen I, can promote the entrapment of LDLs in the intima and accelerate the progression of atherosclerosis.In this study, open tubular capillary electrochromatography is proposed as a new microreactor to study in situ glycation of collagen I. The kinetics of glycation was first investigated in a fused silica collagen I-coated capillary. Dimethyl sulphoxide, injected as an electroosmotic flow marker, gave information about the charge of coating. Native and oxidized LDL, and selected peptide fragments from apolipoprotein B-100, the protein covering LDL particles, were injected as marker compounds to clarify the interactions between LDLs and the glycated collagen I coating. The method proposed is simple and inexpensive, since only small amounts of collagen and LDL are required. Atomic force microscopy images complemented our studies, highlighting the difference between unmodified and glycated collagen I surfaces.     

北京地区大气颗粒物中不同功能区多环芳烃的分布特征

用撞击式分级采样器同步采集了北京市城乡结合部、郊区的2003年四个季节的不同粒径大气颗粒物样品,用气相色谱-质谱分析了其中的多环芳烃。两个功能区的PAHs总质量浓度分布趋势均为：冬季>秋季>春季>夏季;不同环数PAHs在不同粒径颗粒物中的分配比例比较显示,粗颗粒物中2 环或3环PAHs的分配比例比其在高环PAHs的比例要大。