Assembly of MOF Microcapsules with Size‐Selective Permeability on Cell Walls

The assembly of metal–organic frameworks (MOFs) into microcapsules has attracted great interest because of their unique properties. However, it remains a challenge to obtain MOF microcapsules with size selectivity at the molecular scale. In this report, we used cell walls from natural biomaterials as non‐toxic, stable, and inexpensive support materials to assemble MOF/cell wall (CW) microcapsules with size‐selective permeability. By making use of the hollow structure, small pores, and high density of heterogeneous nucleation sites of the cell walls, uniform and continuous MOF layers could be easily obtained by inside/outside interfacial crystallization. The prepared MOF/CW microcapsules have excellent stability and enable the steady, slow, and size‐selective release of small molecules. Moreover, the size selectivity of the microcapsules can be adjusted by changing the type of deposited MOF.     

Sulfonated poly(ether ether ketone)-based silica nanocomposite membranes for direct ethanol fuel cells

This paper reports on the preparation and characterization of sulfonated poly(ether ether ketone) (sPEEK)-based mixed matrix membranes. The inorganic matrix consisted of silica: Aerosil^®380, tetraethoxysilane (TEOS) or a combination of both to obtain an interconnected silica network. The behavior of these membranes in ethanol–water systems was studied for application in a direct ethanol fuel cell (DEFC). Uptake measurements showed that the converted TEOS content had a strong influence on the hydrophilicity of the membranes. Proton conductivity was strongly related to the water content in the membrane, but the proton diffusion coefficients of membranes with various Aerosil^®380–TEOS combinations were similar. Dynamic measurements in liquid–liquid (L–L) and liquid–gas (L–G) systems were performed to study the ethanol transport through the membrane. No reduction in ethanol permeability was obtained in the L–L system, but a remarkable reduction was obtained in the L–G system when 2 M ethanol was applied. The reinforcing characteristic of the combined Aerosil^®380–TEOS-system were best observed at 40 °C with 4 M ethanol. The fuel cell performance prediction based on the selectivity of proton diffusion coefficient to ethanol permeability coefficient showed for nearly all composite membranes an improvement with respect to the polymeric reference. The presence of an inorganic phase led to relatively constant proton diffusion coefficients and lower ethanol permeability coefficients in comparison with the polymeric reference.     

浓悬浮液中纳米SiO_2团聚体的渗透率

本文基于悬浮液中渗透性颗粒的短时扩散动力学理论,采用低相干光纤动态光散射方法,测量了相同粒径的纳米SiO_2团聚体在不同体积分数时的扩散系数,利用扩散系数随渗透率的变化关系得到纳米SiO_2团聚体的渗透率.结果表明:恒温条件下,具有一定渗透率的团聚体颗粒扩散得比硬球颗粒快.实验测量得到的团聚体渗透率与采用photoshop CS6对团聚体SEM图像进行处理计算得到的渗透率符合较好.     

Dynamic Docking and Undocking Processes Addressing Selectively the Outside and Inside of Polymersomes

Increasing complexity and diversity of polymersomes and their compartments is a key issue for mimicking cellular functions and protocells. Thus, new challenges arise in terms of achieving tunable membrane permeability and combining it with control over the membrane diffusion process, and thus enabling a localized and dynamic control of functionality and docking possibilities within or on the surface of polymeric compartments. This study reports the concept of polymersomes with pH‐tunable membrane permeability for controlling sequential docking and undocking processes of small molecules and nanometer‐sized protein mimics selectively on the inside and outside of the polymersome membrane as a further step toward the design of intelligent multifunctional compartments for use in synthetic biology and as protocells. Host–guest interactions between adamantane and β‐cyclodextrin as well as noncovalent interactions between poly(ethylene glycol) tails and β‐cyclodextrin are used to achieve selective and dynamic functionalization of the inner and outer spheres of the polymersome membrane.     

锆镁磷脂膜色谱固定相的制备及其在评价药物-膜相互作用中的应用

基于锆基质与磷脂之间强烈的路易斯酸碱作用,制备了锆镁磷脂膜色谱固定相,并使用红外光谱、X射线光电子能谱对该色谱固定相进行了表征;使用与体内环境类似的生理缓冲液体系为流动相,评价了该模拟生物膜色谱固定相预测药物膜渗透性的能力,结果表明药物在锆镁磷脂膜色谱中的保留(log Kmbm)与表观渗透率(log Papp)在预测药物的膜渗透性、跨膜吸收等方面具有非常好的相关性,相关系数为0.970,斜率接近1。通过理论推导,引入了直观、方便的热力学指标吉布斯自由能差值（Δ(ΔG°)）对药物-膜之间的相互作用强弱进行了评价。     

Mixed-conducting dense ceramic membranes for air separation and natural gas conversion

Non-perovskite SrFeCo_0.5O _x (SFC2) was found to have high electronic and ionic conductivities as well as structural stability. At 800°C in air, total and ionic conductivities of 17 and 7 S·cm⁻¹ were measured, respectively; the ionic transference number was calculated to be ≈0.4. This material is unique because of its high electronic conductivity and comparable electronic and ionic transference numbers. X-ray diffraction analysis showed that air-sintered SFC2 consists of three phase components, ≈75 wt% , ≈20 wt% perovskite , and ≈5 wt% rock salt CoO. Argon-annealed SFC2 contains brownmillerite Sr₂(Fe_1−x Co _x )₂O₅ and rock salt CoO. Dense SFC2 membranes were able to withstand large pO₂ gradients and retain mechanical strength. A 2.9-mm-thick disk membrane was tested in a gas-tight electrochemical cell at 900°C; an oxygen permeation flux rate ≈2.5 cm³(STP)·cm⁻²·min⁻¹ was measured. A dense thin-wall tubular membrane of 0.75-mm thickness was tested in a methane conversion reactor for over 1,000 h. At 950°C, the oxygen permeation flux rate was ≈10 cm³(STP)·cm⁻²·min⁻¹ when the SFC2 thin-wall membrane was exposed with one side to air and the other side to 80% methane balanced with inert gas. Results from these two independent experiments agreed well. The SFC2 material is a good candidate as dense ceramic membranes for oxygen separation from air or for use in methane conversion reactors.     

测定真空磁导率μ_0的一种简便方法

在自制的密绕螺线管上接通交流电源后，利用互感现象可测定真空中的磁导率μ０，其方法简便实用．     

Influence of magnetic layer thickness on[Fe_(80)Ni_(20) O/SiO_2]_n multilayer thin films

In the present work, a series of [Fe80Ni20–O/SiO2]n multilayer thin films is fabricated using a reactive magnetron sputtering equipment. The thickness of SiO2 interlayer is fixed at 3 nm, while the thickness values of Fe80Ni20–O magnetic films range from 10 nm to 30 nm. All films present obvious in-plane uniaxial magnetic anisotropy. With increasing the Fe80Ni20–O layer thickness, the saturation magnetization increases slightly and the coercivity becomes larger due to the enlarged grain size, which could weaken the soft magnetic property. The results of high frequency magnetic permeability characterization show that films with thin magnetic layer are more suitable for practical applications. When the thickness of Fe80Ni20–O layer is 10 nm, the multilayer film exhibits the most comprehensive high-frequency magnetic property with a real permeability of 300 in gigahertz range.     

Confined crystallization of PVDF and a PVDF‐TFE copolymer in nanolayered films

Layer‐multiplying coextrusion was used in conjunction with isothermal recrystallization to study the confined crystallization of polyvinylidene fluoride (PVDF) and polyvinylidene fluoride‐tetrafluoroethylene (PVDF‐TFE) using polycarbonate (PC) and polysulfone (PSF) as confining materials. Three layered systems were produced (PC/PVDF, PSF/PVDF, and PC/PVDF‐TFE) with layer thicknesses ranging from 525 to 28 nm. The crystal morphology was affected by both layer thickness and recrystallization temperature. Specifically, increased recrystallization temperature and decreased layer thickness facilitated the formation of high aspect ratio in‐plane crystals in both PVDF based polymers. On the other side of the spectrum, thicker layers and lower recrystallization temperatures produced on‐edge PVDF crystals and isotropic PVDF‐TFE crystals. The morphology was correlated with oxygen permeability, which decreased by almost two orders of magnitude compared with the bulk. A variety of crystal structures were obtained and explained with nucleation and diffusion theory. © 2011 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys, 2011     

On hydraulic permeability of random packs of monodisperse spheres: Direct flow simulations versus correlations

Hydraulic permeability is studied in porous media consisting of randomly distributed monodisperse spheres by means of computational fluid dynamics (CFD) simulations. The packing of spheres is generated by inserting a certain number of nonoverlapping spherical particles inside a cubic box at both low and high packing fractions using proper algorithms. Fluid flow simulations are performed within the interparticulate porous space by solving Navier-Stokes equations in a low-Reynolds laminar flow regime. The hydraulic permeability is calculated from the Darcy equation once the mean values of velocity and pressure gradient are calculated across the particle packing. The simulation results for the pressure drop across the packing are verified by the Ergun equation for the lower range of porosities (<0.75), and the Stokes equation for higher porosities (∼1). Using the results of simulations, the effects of porosity and particle diameters on the hydraulic permeability are investigated. Simulations precisely specified the range of applicability of empirical or semi-empirical correlations for hydraulic permeability, namely the Carman-Kozeny, Rumpf-Gupte, and Howells-Hinch formulas. The number of spheres in the model is gradually decreased from 2000 to 20 to discover the finite-size effect of pores on the hydraulic permeability of spherical packing, which has not been clearly addressed in the literature. In addition, the scale dependence of hydraulic permeability is studied via simulations of the packing of spheres shrunk to lower scales. The results of this work not only reveal the validity range of the aforementioned correlations, but also show the finite-size effect of pores and the scale-independence of direct CFD simulations for hydraulic permeability.