Damage monitor and life prediction of carbon fiber-reinforced ceramic-matrix composites at room and elevated temperatures using hysteresis dissipated energy-based damage parameter

In this paper, the damage monitor and life prediction of carbon fiber-reinforced ceramic-matrix composites (C/SiC CMCs) have been investigated using the hysteresis dissipated energy-based damage parameter. The evolution of the interface shear stress, hysteresis dissipated energy, hysteresis dissipated energy-based damage parameter and the broken fibers fraction vs. cycle number, the fatigue life S?N curves of unidirectional, cross-ply and 2.5D C/SiC composites at room temperature and 800 °C in air atmosphere have been analyzed. For unidirectional C/SiC, the hysteresis dissipated energy and hysteresis dissipated energy-based damage parameter first increase and then decrease with cycle number, and the fatigue limit stress decreases from 88% tensile strength at room temperature to 20% of the tensile strength at 800 °C in air atmosphere; for cross-ply C/SiC, the hysteresis dissipated energy and hysteresis dissipated energy-based damage parameter decrease with increasing applied cycles, and the fatigue limit stress decreases from 85% tensile strength at room temperature to 22% tensile strength at 800 °C in air; and for 2.5D C/SiC, the hysteresis dissipated energy and hysteresis dissipated energy-based damage parameter increases with cycle number, and the fatigue limit stress decreases from 70% tensile strength at room temperature to 25% tensile strength at 800 °C in air.     

Photoluminescence and gamma-ray irradiation of SrAl2O4:Euand Y2O3:Eu phosphors

Y₂O₃:Eu³⁺ phosphor is a very attractive material for use as a red phosphor in many fields. SrAl₂O₄:Eu²⁺ belongs to long lasting phosphor (LLP) and it is a useful bluish-green luminescence material, which can also be a promising candidate as a simple and easy-to-use radiation detection element for visual display of two dimensional radiation distributions. In the present study, both these two kinds of phosphors were synthesized using high temperature solid state reactions. In our work, the influence of gamma-ray irradiation on the properties of these two kinds of phosphors was studied by comparing photoluminescence, brightness and the decay curve of unirradiated and gamma-ray-irradiated samples. Conclusions from the present work can be briefly summarized as follows. In irradiated samples, the brightness is decreased without sensible change in the wavelength distribution of the luminescence spectrum and in the decay kinetic upon gamma exposure. Moreover, the emission due to Eu³⁺→Eu²⁺ conversion in Y₂O₃:Eu³⁺ phosphors was not observed in our sample after irradiation to high exposure. Also the brightness of SrAl₂O₄:Eu²⁺ phosphor turned out to decrease after the exposition to ionizing radiation while the luminescence wavelength distribution remained unchanged. The reason for the effect of gamma-ray irradiation on the properties of phosphors is also discussed in the paper.     

MSM结构GaAs探测器的抗辐照性能

研究一种双金属接触的GaAs半导体探测器在14MeV中子辐照下的性能.测量了探测器经过10¹²n/cm²中子辐照剂量后的反向漏电流、电荷收集效率和最小电离粒子能谱,并且与⁶⁰Co 1.25MeV光子辐照的测量结果相比较.对中子辐照引起探测器时间性能变化和辐照损伤机制进行了探讨.并根据实验结果提出了这种双金属接触GaAs探测器灵敏层分布的一种假设,理论计算和实验数据相符合.     

塑料闪烁体的辐照特性

利用⁶⁰Co放射源分别对3种塑料闪烁体(BC-408, EJ-200, BC-404)进行辐照损伤研究, 比较辐照前后的透射谱、发射谱及光产额的变化, 发现3种闪烁体在低剂量具有较好的抗辐照性能; 当照射剂量超过1.44×10⁴Gy时,透射谱明显变坏, 光输出减少很严重, 但发射谱却保持不变.     

对晶体光损伤阈值测量的一种新方法的研究

提出一种测量晶体光损伤阈值的新方法,即确定激光横向功率密度的空间分布,利用晶体的激光损伤斑点半径,直接计算出晶体光损伤阈值,并给出入射激光为高斯光束时晶体损伤阈值与其损斑半径的关系。以提拉法生长的掺镁铌酸锂(MgO：LiNbO3)晶体为研究对象,用该方法测量其损伤阈值,得到了定量结果且所得数据与文献已报道的规律相符。分析得出同样激光条件下．损斑半径越大的晶体其光损伤阈值越小的结论,指出该方法同样适用于其他晶体或非高斯光束条件下光损伤阈值的测量并对具体作法进行了讨论。该测量方法弥补了常用测量方法只能定性或半定量的不足,可用于晶体抗光损伤阈值的精确测量。     

多脉冲激光对K9玻璃的表面损伤实验研究

 实验研究了波长为1 064 nm、脉宽为10 ns、重复频率为1 Hz的激光脉冲对K9玻璃的表面损伤特点,给出了脉冲透过能量随激光脉冲作用次数变化的规律。采用3维立体显微镜对损伤形貌进行观察,发现K9玻璃的损伤表面呈环状分布,分为烧蚀区、微裂纹区和断裂区。随着激光脉冲个数的增加,损伤由点状破坏演变为损伤区,微裂纹逐渐增长,损伤面积逐渐增大。基于激光支持的爆轰波理论分析,激光与脆性材料的相互作用可引起微裂纹的大量增长。在多脉冲激光的作用下,K9玻璃损伤的累积效应明显,表面损伤阈值明显降低,表面裂纹增长明显,损伤面积逐渐增大;但随着激光脉冲的继续增加,这种损伤趋于稳定。     

单甲基原位改性SiO2疏水减反膜的制备与性能研究

 在碱性条件下通过TEOS和MTES的共水解缩聚反应制备了单甲基原位改性的SiO₂溶胶，并使用提拉法在K9玻璃基片上镀制了疏水减反膜。通过透射电镜（TEM）考察了镀膜溶胶的微结构，分别使用红外光谱（FTIR）分析了薄膜的组分，用原子力显微镜（AFM）观察了薄膜的表面形貌和起伏状况，用紫外可见光谱（UV-vis）考察了薄膜的减反射性能，用接触角仪测量了薄膜对水的接触角。并使用“R-on-1”的方式测量了薄膜在Nd:YAG激光（1 064 nm，1 ns）作用下的损伤阈值。结果表明，通过共水解缩聚反应可以把甲基引入镀膜溶胶簇团中，改善了溶胶簇团的网络结构，使薄膜得到相当好的疏水性能和更好的抗激光损伤性能，同时薄膜能保持较好的减反射性能。     

Structure and optical damage resistance of near-stoichiometric Zn:Fe:LiNbO3 crystals

A series of near-stoichiometric Zn:Fe:LiNbO₃ crystals were grown by the high-temperature top-seed solution growth (HTTSSG) method from stoichiometric melts doped with 6 mol% K₂O. Infrared (IR) transmission spectra were measured and discussed in terms of the defect structure of the near-stoichiometric Zn:Fe:LiNbO₃ crystals. The results of the transmitted beam pattern distortion method show that the optical damage resistance of the near-stoichiometric Zn:Fe:LiNbO₃ crystals increases rapidly when the ZnO concentration exceeds a threshold value. The threshold value concentration of ZnO of the near-stoichiometric Zn:Fe:LiNbO₃ crystals is much lower than that of the congruent LiNbO₃ crystals. The dependence of the optical damage resistance on the defect structure of the near-stoichiometric Zn:Fe:LiNbO₃ crystals are discussed, and the holographic recording properties of the near-stoichiometric Zn:Fe:LiNbO₃ crystals are investigated.     

Effect of polyvinylpyrrolidone on the structure and laser damage resistance of sol–gel silica anti-reflective films

The effect of polyvinylpyrrolidone (PVP) on the structure and laser-induced damage threshold (LIDT) of sol–gel silica anti-reflective films is investigated. The results of dynamic light scattering, transmission electron microscopy, and small angle X-ray scattering, show that the PVP molecules surrounded the silica sol particles through the strong hydrogen bonds between Si-OH groups and the PVP. As a result, the growth of silica particles was restricted and thus the interface layer between the silica particles and the solvent become thickened with PVP content. Furthermore, the PVP reduced the porosity of the film, so the anti-reflection properties of the film were weakened. A multi-fractal analysis showed that the appropriate addition of PVP, 1 weight percent (wt%), could improve the surface fractal structure of the film, but that higher PVP content resulted in reduced surface uniformity. The addition of PVP lead to improved LIDT.     

ns脉冲激光对K9玻璃的破坏实验

 采用高速PIN光电探测器和高带宽的数字存储示波器，实时检测透射光脉冲和散射光脉冲的变化特征，并将之用作材料破坏的光学判据，测量得到K9玻璃在1.06μm纳秒脉冲激光作用下的能量损伤阈值约18mJ，相应的能量密度阈值为1.0kJ/cm²。通过分析透射光脉冲和散射光脉冲的特征，给出了材料的破坏时刻，并推断出K9玻璃所能承受的极限光强为10¹⁵W/m²。研究了能量透过率与泵浦能量的关系，并初步探讨了透明材料的破坏机理。结果表明：在多纵模激光的作用下，透明光学材料破坏是电离击穿与自聚焦效应综合作用的结果。