铟(Ⅲ)-向红菲啰啉络合物极谱吸附波的研究

在pH=3.8的磷酸柠檬酸盐缓冲体系中,铟(Ⅲ)-向红菲(口罗)啉络合物在单扫描示波极谱仪上于-0.67 V(vs.SCE)处产生一灵敏的吸附还原波,其二阶导数波灵敏度高,波形好.峰电位Ⅰ~O_P与钢(Ⅲ)浓度在 2.0X10~(-8)~2.0X10~(-6)mol/L范围内呈良好的线性关系,其检测限为8X10~(-9)mol/L铟(Ⅲ).该法用于试剂氧化锌和镀膜玻璃中铟(Ⅲ)的恻定,结果较好.     

铌(V)-1-苯基-3-甲基-4-苯甲酰基-吡唑啉酮-5络合物吸附波的研究

在pH=5.0的HAc-NaAc介质中,Nb(V)与1-苯基-3-甲基-4-苯甲酰基-吡唑啉酮-5(PMBP)生成络合物,于-0.96V(us.SCE)出现一尖锐的极谱波.在滴汞电极上用示波极谱仪或在悬汞电极上测吸附伏安曲线.峰电流与Nb(V)浓度分别在0.0075~0.80μg/mL及0.000075~0.0075μg/mL范围内呈线性关系.实验了30多种离子的干扰影响,经苯肿酸分离后用于钢中Nb(V)的测定.检出限为0.00003μg/mL.溶液可稳定96h以上.用多种电化学方法研究了电极反应机理.     

The Employ of Multiple Voltammetric Pulses for the Study of the Adsorption of Bipyridilium Pesticides in River Sediment

The multiple square‐wave voltammetry (MSWV) allied to gold microelectrode (Au‐ME) was used to establish an electroanalytical procedure for the determination of the paraquat and diquat pesticides in river sediment samples. For both pesticides, two reduction peaks, at around ?0.70 V (peak 1) and around ?1.00 V vs. Ag/AgCl 3.00 mol L^?1 (peak 2), with profile of the totally reversible redox process, were observed. The experimental and voltammetric conditions showed that the best conditions to reduce paraquat and diquat were a pH of 6.0, a frequency of 250 s^?1, a scan increment 2 mV, a square‐wave amplitude of 50 mV and pulse number of 8 pulses of potential in each step of staircase of potential. Under such conditions, the detection limit of 0.044 μg L^?1 (0.044 ppb) and 0.360 μg L^?1 (0.360 ppb ) for peak 1 and peak 2 of paraquat and 0.159 μg L^?1 (0.159 ppb) and 0.533 μg L^?1 (0.533 ppb) for peak 1 and peak 2 of diquat, respectively, were obtained. These results are an order of magnitude of about two less than those obtained and published in the literature. Also, the electroanalytical procedure proposed was applied for the determination of adsorption isotherms of pesticides on river sediments samples collected from Mogi‐Guaçu River in Sao Paulo State, Brazil. The experimental data were fitted using the Langmuir and Freundlich isotherms models; and the results indicated low intensities of adsorption process of the pesticides in the samples employed with distribution coefficients (K_d) lower 5.0, and paraquat showed slightly higher affinity than diquat in the sediments. The increase in organic matter and organic carbon leads to an increase in the K_d values, and consequently an increase in the organic matter constant (K_OM) organic carbon constant (K_OC) values. All results demonstrated that isotherms “L” type in the Giles classification were obtained, indicating that sediments have a medium affinity for the pesticides, and no strong competition from the solvent used (in this case Na₂SO₄) for adsorption sites occurs.     

Nucleophilic Addition of Thiaproline to Electrochemically Derived o‐Quinone,Application to the Sensitive Voltammetric Detection of Thiaproline

The mechanism of electrochemical behavior of catechol in the presence of thiaproline is investigated by cyclic voltammetry, controlled‐potential coulometry and spectrophotometric tracing of the reaction coordinate. The results indicate that thiaproline participate in with an ECEC mechanism in a nucleophilic (Michael) addition to o‐quinone. Effect of pH of buffer solution on reaction pathway is studied and showed that addition of thiaproline to the o‐quinone is performed only in solutions with pHs higher than 5. These results indicate that the addition of thiaproline is occurred first from amine functional group. In the second step, the addition of carboxylate group of thiaproline to C‐5 of catechol results the final product with a lactone ring in its structure. Observation of two isosbestic point in absorption spectrum during the progress of the electrolysis together with the FT‐IR results for final product can be presented as evidence for two step addition of thiaproline to catechol. Final product, due to the electron donor property of thiaproline, more easily oxidized respect to the former catechol and as a result, a new redox couple is obtained for this compound in lower potentials. The easier anodic oxidation of addition product (relative to catechol) caused to an increase in anodic current for catechol, which is proportional to the thiaproline concentration. The differential pulse voltammetry (DPV) is applied as a sensitive voltammetric method for the detection of thiaproline. A linear range from 5×10^?8 to 5×10^?6 M with a detection limit of 1×10^?8 M is resulted for thiaproline. With respect to the reversibility of the electrochemical reactions in the mechanism, and also more facile oxidation of the addition products, the square‐wave voltammetry is presented as a method with considerably more sensitivity for the detection of sub‐micromolar amounts of thiaproline. The advantageous properties of the voltammetric method for thiaproline detection lie in its excellent catalytic activity, sensitivity and simplicity.     

Removal of H2S from Exhaust Gas by Use of Alkaline Activated Carbon

The purpose of this research was to select an activated carbon and alkaline solution blend that generated the best H₂S adsorption on alkaline-activated carbon. RB₂ (activated carbon) impregnated with NaOH solution was shown to have the optimum H₂S removal efficiency. The optimum NaOH concentration was 50 mg per gram of carbon. H₂S adsorption via RB₂-NaOH₅₀ was five times that of a corresponding fresh-activated carbon. The adsorption equivalent of H₂S is nearly 1 (mol-H₂S/mol-AOH), therefore, H₂S + AOH AHS + H₂O was the major reaction. The H₂S adsorption isotherm corresponded to the Freundlich isotherm.     

Resistance to Surfactant and Protein Fouling Effects at Conducting Diamond Electrodes

Boron‐doped diamond thin‐film electrodes display negligible fouling effects in the presence of high levels of surface‐active materials, including proteins. Dramatic improvements in the stability of the analyte response (compared to common glassy carbon and carbon paste electrodes) are illustrated using bovine serum albumin (BSA), gelatin, and Triton X‐100 in connection with repetitive square‐wave voltammetric (SWV) measurements. The voltammetric response of ascorbic acid at the diamond electrode exhibits negligible shifts in peak potentials and minimal depressions of current signals over a wide range of surfactant concentrations (0–750 ppm). For example, the diamond electrode exhibited 70, 50 and 60 mV potential shifts for 10 repetitive voltammetric scans in the presence of 100 ppm BSA, gelatin and Triton X‐100, respectively, compared to 120, 190, and 280 mV shifts observed at the glassy carbon electrode. Furthermore, only 4.3 and 6.2% of the initial current decays were observed in the presence of 100 ppm Triton X‐100 and gelatin, respectively (compared to 45.2 and 34.4% diminutions at the glassy carbon electrode). Such improved performance was also confirmed from the SWV measurements of uric acid, dihydroxyphenylacetic acid, and catechol. The greatly improved resistance to surfactant interference reflects the fact that the as‐grown diamond thin film, composed of oxide‐free and hydrogen‐terminated surface, has a relatively lower surface energy and minimal electrostatic attributes, either specific or general, so that little adsorption of surface‐active agents occurs. The topographic AFM images of the diamond electrode surface confirm a negligible BSA fouling effect after repetitive SWV measurements. Such enhanced antifouling features make diamond electrodes very attractive for numerous real‐life electroanalytical applications.     

Analytic expression of the second derivatives of electronic energy for full configuration interaction wave functions

Summary A new analytic second derivative expression of the electronic energy is derived for full configuration interaction (CI) wave functions. This formula is shown to be free from the derivative terms of both CI and MO coefficients. The second-order relationships between CI and MO coefficients for full CI wave functions are also presented.     

导数阴极溶出方波伏安法测定卡那霉素注射液含量

研究了汞 卡那霉素络合物的电化学行为 ,并建立了导数阴极溶出方波伏安法测定卡那霉素注射液含量的方法。在 pH 4 .7的HOAc NaOAc缓冲溶液中 ,在约 0 .12 6V (vs.SCE)处出现一个汞 卡那霉素络合物的还原峰 ,卡那霉素的浓度在 0 .0 2～ 1.5mg·ml- 1之间与导数方波伏安图的峰高存在良好的线性关系 ,回归方程ip(10 - 4A) =3.6C(mg·ml- 1) + 0 .4 6 ,相关系数为 0 .992 0。方法简便、灵敏、准确 ,可用于卡那霉素注射液含量测定     

氨-碘酸盐介质中白喉类毒素的平行催化氢波

在 0 .4mol/LNH3 NH4Cl (pH 8.3 1 )介质中 ,白喉类毒素 (DT)于 - 1 .89V(vs.SCE)处产生的极谱催化氢波可被碘酸钾进一步催化 ,峰电流明显增大 ,但峰电位不变 ,产生一种氢的新动力波 ,建议称其为平行催化氢波。在 0 .4mol/LNH3 NH4Cl(pH 8.3 1 ) - 5 .0× 1 0 - 3 mol/LKIO3介质中 ,DT平行催化氢波的二阶导数峰电流与其浓度在 0 .2 μg/mL～ 1 .0 μg/mL内呈线性关系 ,可用于生物制品中DT含量的测定。     

镓-铬蓝黑R络合吸附波的研究及应用

在0.012mol/L HAc-0.10mol/L NaAc缓冲溶液中pH5.60,铬蓝黑R于-0.34V(vs.SCE)处有一极谱波P_1,加入Ga(Ⅲ),在-0.55V(vs.SCE)处产生一灵敏的极谱波P_2。i_p_2与Ga(Ⅲ)浓度在0.20～15.0μg/25ml范围内呈线性关系。试验表明,该极谱波属络合吸附波。本法用于测定铝箔、铅锌矿中微量镓,结果满意。