Interface-related effects on confined excitons in GaAs/AlxGa1−xAs single quantum wells

Confined excitons in non-abrupt GaAs/Al_xGa_1−xAs single quantum wells are studied. The graded interfaces are described taking into account fluctuations in their thickness a and positioning with respect to the abrupt interface picture. Numerical results for confined (0,0),(1,1) and (0,2) excitons in GaAs/Al_0.3Ga_0.7As quantum wells show that while the interfacial fluctuations produce small changes (<0.5 meV) in the exciton binding energies, the confined exciton energies can be red- or blue-shifted as much as 25 meV for wells with mean width of 50 Å and 2 ML wide interfaces.     

场协同理论在椭圆型流动中的数值验证

本文用数值模拟的方法，通过四个椭圆型流动传热的例子验证了场协同理论的正确性．结果表明，场协同理论不仅适合于抛物型流动，亦适合于复杂的有回流的椭圆型流动．     

机翼大攻角下失速颤振的气动弹性研究

本文采用流固耦合的数值方法研究了机翼在0°～50°攻角下的颤振。计算结果表明,随着来流攻角α0的增大,机翼的固有频率对颤振的影响越来越大,颤振由线性的强迫振动逐渐发展成为非线性的自激振动,而当α0增加到一定程度以后,大尺度分离流交替地从机翼头部和尾部产生,机翼和流场会发生共振,引起机翼的失速颤振。     

轴流风扇叶片端导叶作用的研究

本文采用数值方法研究了叶片端导叶对轴流风扇性能的影响。通过与普通开式轴流风扇比较,分析了叶片端导叶对内部流动作用的机理.数值计算结果表明:叶片端导叶的安装位置将影响轴流风扇气动效率,安装叶片端导叶不能提高风扇静压升,但是在压力面安装时能有效地减小风扇叶顶泄漏流与主流的掺混损失;在设计流量下,压力面安装叶片端导叶使泄漏涡的作用范围较小,涡核更靠近吸力面;吸力面安装叶片端导叶弱化了泄漏涡的强度但没有减小泄漏涡的作用范围。     

Numerical solution of the three‐dimensional parabolic equation with an integral condition

Developement of numerical methods for obtaining approximate solutions to the three dimensional diffusion equation with an integral condition will be carried out. The numerical techniques discussed are based on the fully explicit (1,7) finite difference technique and the fully implicit (7,1) finite difference method and the (7,7) Crank‐Nicolson type finite difference formula. The new developed methods are tested on a problem. Truncation error analysis and numerical examples are used to illustrate the accuracy of the new algorithms. The results of numerical testing show that the numerical methods based on the finite difference techniques discussed in the present article produce good results. © 2002 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq 18: 193–202, 2002; DOI 10.1002/num.1040     

叶型优化在非定常流动条件下效果的数值分析

本文对叶型优化在非定常流动条件下的效果进行数值研究。叶型优化基于比较成熟的在定常流动条件下的反问题解法，非定常流动则考虑到动静叶栅之间的相互作用，非定常流动的求解在Ｎ－Ｓ方程的基础上采用分区计算的方法来完成。数值计算的结果表明，定常流动条件下优化得到的叶型在非定常流动条件下同样具有较好的气动性能。     

Exciton energy broadening due to interface fluctuations in ZnSe/ZnSxSe1−x strained quantum wells

The excitonic properties of a ZnSe/ZnS_xSe_1−x strained quantum well (QW) are calculated taking into account interface effects. Numerical results obtained with ZnS_0.18Se_0.82/ZnSe QWs show that graded interfaces can be responsible for a strong broadening of excitonic spectra.     

微光像增强器图像传递信噪比的测试研究

图像传递信噪比是微光像增强器的重要特性参数．能够全面定量地表征像增强器在探测弱辐射图像时的综合性能，对于确定像增强器的图像探测灵敏闽具有重要意义。针对其测试原理．采用高灵敏度低噪声CCD器件作为像管输出图像的探测接收器．并引入数字图像处理技术。利用设计的测试系统实现了典型目标图像传递信噪比的自动测试．多次实验结果表明．陔测试系统具有测试过程自动快速及测试数据准确稳定的优点．相同测试条件下的不确定度优于±3%。     

Statistical Inference with Fractional Brownian Motion

We give a test between two complex hypothesis; namely we test whether a fractional Brownian motion (fBm) has a linear trend against a certain non-linear trend. We study some related questions, like goodness-of-fit test and volatility estimation in these models.     

Mathematical Modeling, Control, Computer Simulation and Laboratory Experiments of a Spatial Servopneumatic Parallel Robot

In this paper, the special construction of a parallel robot, called spatial servopneumatic multi-axis test facility, will be discussed. The investigations include the following aspects: (i) the laboratory set-up of the robot, (ii) various results obtained in laboratory experiments, taking into account quite different control algorithms and command-input signals, (iii) a comparison of the laboratory experiments with the computer simulations of Part I of this paper, and ({vi}) a quality check of the results compared with the cost of the different controller realizations. The results of both the computer simulations and the laboratory experiments show: (i) The dynamic behavior of the parallel structure can be tremendously improved by using sophisticated nonlinear control algorithms. (ii) This improvement has to be paid by a drastically increased amount of work for deriving the model equations and control algorithms, and by augmented hardware cost of the sensing elements and controller electronics. (iii) Carefully developed model equations and identified model parameters provide theoretical models of the complex parallel structure that are very close to reality. This enables the design engineer to systematically investigate constructive alternatives of the design parameters, sensor and actuator concepts, and control strategies of the MAP prior to their hardware realization.This work has been supported by the German Science Foundation (DFG) under Contract No. Ha 1666/6-3.