Light‐induced degradation of PECVD aluminium oxide passivated silicon solar cells

Light‐induced degradation (LID) has been identified to be a critical issue for solar cells processed on boron‐doped silicon substrates. Typically, Czochralski‐grown silicon (Cz‐Si) has been reported to suffer from stronger LID than block‐cast multicrystalline silicon (mc‐Si) due to higher oxygen concentrations. This work investigates LID under conditions practically relevant under module operation on different cell types. It is shown that aluminium oxide (AlOx) passivated mc‐Si solar cells degrade more than a reference aluminium back surface field mc‐Si cell and, remarkably, an AlOx passivated Cz‐Si solar cell. The defect which is activated by illumination is shown to be doubtful a sole bulk effect while the AlOx passivation might play a certain role. This work may contribute to a re‐evaluation of the suitability of boron‐doped Cz‐ and mc‐Si for solar cells with very high efficiencies. (© 2015 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

Theoretical stability,thin film synthesis and transport properties of the Mon +1GaCn MAX phase

The phase stability of Mo_{n +1}GaC_n has been investigated using ab‐initio calculations. The results indicate stability for the Mo₂GaC phase only, with a formation enthalpy of –0.4 meV per atom. Subsequent thin film synthesis of Mo₂GaC was performed through magnetron sputtering from elemental targets onto Al₂O₃ [0001], 6H‐SiC [0001] and MgO [111] substrates within the temperature range of 500 °C and 750 °C. High structural quality films were obtained for synthesis on MgO [111] substrates at 590 ºC. Evaluation of transport properties showed a superconducting behavior with a critical temperature of approximately 7 K, reducing upon the application of an external magnetic field. The results point towards the first superconducting MAX phase in thin film form. (© 2015 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

Observation of insulating–insulating monoclinic structural transition in macro‐sized VO2 single crystals [Phys. Status Solidi RRL 5, No. 3, R107–R109 (2011)]

In our article, we reported the observation of monoclinic M2 to M1 structural phase transition in VO₂ single crystal near the temperature of ～49 °C. However, the re‐examination of Laue patterns reveals that previously defined monoclinic M1 and M2 phases can be interpreted as monoclinic M2 and triclinic T phases instead. Careful experimental geometry calibration and further refinement of the lattice parameter ratios and angles show that monoclinic M2 and triclinic T phases fit better with the experimental data. On the other hand, our previous misidentification of the insulating phases does NOT affect the conclusions of our article. (© 2015 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

Electroluminescence enhancement in ultraviolet organic light‐emitting diode with graded hole‐injection and ‐transporting structure

Electroluminescent intensity and external quantum efficiency (EQE) in ultraviolet organic light‐emitting diodes (UV OLEDs) have been remarkably enhanced by using a graded hole‐injection and ‐transporting (HIT) structure of MoO₃/N,N ′‐bis(naphthalen‐1‐yl)‐N,N ′‐bis(phenyl)‐benzidine/MoO₃/4,4′‐bis(carbazol‐9‐yl)biphenyl (CBP). The graded‐HIT based UV OLED shows superior short‐wavelength emis‐ sion with spectral peak of ～410 nm, maximum electroluminescent intensity of 2.2 mW/cm² at 215 mA/cm² and an EQE of 0.72% at 5.5 mA/cm². Impedance spectroscopy is employed to clarify the enhanced hole‐injection and ‐transporting capacity of the graded‐HIT structure. Our results provide a simple and effective approach for constructing efficient UV OLEDs. (© 2015 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

Extended X‐ray absorption fine structure and multiple‐scattering simulation of nickel dithiolene complexes Ni[S2C2(CF3)2]2n (n = −2, −1, 0) and an olefin adduct Ni[S2C2(CF3)2]2(1‐hexene)

A series of Ni dithiolene complexes Ni[S₂C₂(CF₃)]₂ⁿ (n = ?2, ?1, 0) ( 1 , 2 , 3 ) and a 1‐hexene adduct Ni[S₂C₂(CF₃)₂]₂(C₆H₁₂) ( 4 ) have been examined by Ni K‐edge X‐ray absorption near‐edge structure (XANES) and extended X‐ray absorption fine‐structure (EXAFS) spectroscopies. Ni XANES for 1 – 3 reveals clear pre‐edge features and approximately +0.7 eV shift in the Ni K‐edge position for `one‐electron' oxidation. EXAFS simulation shows that the Ni—S bond distances for 1 , 2 and 3 (2.11–2.16 Å) are within the typical values for square planar complexes and decrease by ～0.022 Å for each `one‐electron' oxidation. The changes in Ni K‐edge energy positions and Ni—S distances are consistent with the `non‐innocent' character of the dithiolene ligand. The Ni—C interactions at ～3.0 Å are analyzed and the multiple‐scattering parameters are also determined, leading to a better simulation for the overall EXAFS spectra. The 1‐hexene adduct 4 presents no pre‐edge feature, and its Ni K‐edge position shifts by ?0.8 eV in comparison with its starting dithiolene complex 3 . Consistently, EXAFS also showed that the Ni—S distances in 4 elongate by ～0.046 Å in comparison with 3 . The evidence confirms that the neutral complex is `reduced' upon addition of olefin, presumably by olefin donating the π‐electron density to the LUMO of 3 as suggested by UV/visible spectroscopy in the literature.     

Characteristics of Friedel pairs and diffraction contrast tomography with non‐perpendicular rotation axis

The characteristics of Friedel pairs in diffraction contrast tomography (DCT) are studied in the condition that the rotation axis of the sample is not exactly perpendicular to the incident X‐ray direction. For the rotation axis approximately aligned along the vertical direction, the Friedel pairs close to the horizontal plane are insensitive to the non‐perpendicularity of the rotation axis, and can be used to refine the sample‐to‐detector distance and X‐ray energy, while the Friedel pairs close to the vertical direction are sensitive to the non‐perpendicularity of the rotation axis, and can be used to determine the rotation axis orientation. The correct matching proportion of Friedel pairs decreases with increasing non‐perpendicularity of the rotation axis. A method of data processing considering rotation axis misalignment is proposed, which significantly increases the correct matching and indexing proportions of the diffraction spots. A pure aluminium polycrystalline sample is investigated using DCT at beamline 4W1A of Beijing Synchrotron Radiation Facility. Based on the analysis of Friedel pairs, the sample‐to‐detector distance and X‐ray energy are refined to be 8.67 mm and 20.04 keV, respectively. The non‐perpendicular angle of the rotation axis is calculated to be 0.10°. With these refined geometric parameters, the matching proportion of the spatial position of diffraction spots is 90.62%. Three‐dimensional reconstruction of the sample with 13 grains is realised using the algebraic reconstruction technique. It is demonstrated that the precise correction of the orientation of the sample rotation axis is effective in DCT suffering from rotation axis misalignment, and the higher accuracy in determining the rotation axis is expected to improve the reconstruction precision of grains.     

Charge redistribution and a shortening of the Fe—As bond at the quantum critical point of SmO1–xFxFeAs

Many researchers have pointed out that there is a quantum critical point (QCP) in the F‐doped SmOFeAs system. In this paper, the electronic structure and local structure of the superconductive FeAs layer in SmO_1–xF_xFeAs as a function of the F‐doping concentration have been investigated using Fe and As K‐edge X‐ray absorption spectroscopy. Experiments performed on the X‐ray absorption near‐edge structure showed that in the vicinity of the QCP the intensity of the pre‐edge feature at the Fe‐edge decreases continuously, while there is a striking rise of the shoulder‐peak at the As edge, suggesting the occurrence of charge redistribution near the QCP. Further analysis on the As K‐edge extended X‐ray absorption fine structure demonstrated that the charge redistribution originates mostly from a shortening of the Fe—As bond at the QCP. An evident relationship between the mysterious QCP and the fundamental Fe—As bond was established, providing new insights on the interplay between QCP, charge dynamics and the local structural Fe—As bond in Fe‐based superconductors.     

Development of variable‐magnification X‐ray Bragg optics

A novel X‐ray Bragg optics is proposed for variable‐magnification of an X‐ray beam. This X‐ray Bragg optics is composed of two magnifiers in a crossed arrangement, and the magnification factor, M, is controlled through the azimuth angle of each magnifier. The basic properties of the X‐ray optics such as the magnification factor, image transformation matrix and intrinsic acceptance angle are described based on the dynamical theory of X‐ray diffraction. The feasibility of the variable‐magnification X‐ray Bragg optics was verified at the vertical‐wiggler beamline BL‐14B of the Photon Factory. For X‐ray Bragg magnifiers, Si(220) crystals with an asymmetric angle of 14° were used. The magnification factor was calculated to be tunable between 0.1 and 10.0 at a wavelength of 0.112 nm. At various magnification factors (M≥ 1.0), X‐ray images of a nylon mesh were observed with an air‐cooled X‐ray CCD camera. Image deformation caused by the optics could be corrected by using a 2 × 2 transformation matrix and bilinear interpolation method. Not only absorption‐contrast but also edge‐contrast due to Fresnel diffraction was observed in the magnified images.     

Towards a microchannel‐based X‐ray detector with two‐dimensional spatial and time resolution and high dynamic range

X‐ray detectors that combine two‐dimensional spatial resolution with a high time resolution are needed in numerous applications of synchrotron radiation. Most detectors with this combination of capabilities are based on semiconductor technology and are therefore limited in size. Furthermore, the time resolution is often realised through rapid time‐gating of the acquisition, followed by a slower readout. Here, a detector technology is realised based on relatively inexpensive microchannel plates that uses GHz waveform sampling for a millimeter‐scale spatial resolution and better than 100 ps time resolution. The technology is capable of continuous streaming of time‐ and location‐tagged events at rates greater than 10⁷ events per cm². Time‐gating can be used for improved dynamic range.