Study on the impedance of aligned carbon microcoils embedded in silicone rubber matrix

This paper reports that carbon microcoils are grown through a chemical vapour deposit process, they are then embedded in silicone rubber, and manipulated to parallel with each other along their axes in the resulting composite. The impedance |Z| as well as phase angle θ of both the original carbon microcoil sheets and the aligned carbon microcoil/silicone rubber composites are measured. The results illustrate that carbon microcoils in different forms show different alternating current electric properties. The aligned carbon microcoils in the composites show stable parameters for f<10⁴ Hz but a sharp decrease in both |Z| and θ for frequencies >10⁴ Hz, which will also change as the carbon microcoils are extended. But, the original sheets have a pure resistance with their parameters stable throughout the entire alternating current frequency range investigated.     

频率自动跟踪超声波电源设计

针对超声波电源工作时负载状态改变,换能系统产生谐振漂移的问题,提出了一种基于STM32的频率自动跟踪超声波电源的设计。电源逆变电路采用带辅助网络的全桥结构,阻抗匹配电路选择了一种改进型的T型匹配网络,应用PWM移相调功技术控制电源的输出功率,通过数字鉴相技术得到电压电流的相位差作为电路谐振状态的反馈信号,结合STM32主控制器进行PI控制,调节PWM波的输出频率使电路始终工作于谐振状态,实现了谐振频率的自动跟踪。最后基于该设计方案,实际制作了一款应用于超声波清洗仪的电源,并通过实验验证了该电源具有输出功率稳定,负载适应性强,输出频率自动跟踪等特点。     

基于电阻抗层析成像的高强度聚焦超声温度监测技术

作为一种对正常组织无损伤且不易引起癌细胞转移的非入侵肿瘤治疗手段,高强度聚焦超声(HIFU)治疗过程中焦域的温度监测是实现剂量精准控制的关键.本文基于生物组织的温度-电阻抗的关系,将电阻抗层析成像(EIT)和HIFU治疗相结合,提出了一种利用组织焦平面的表面电压实现电阻抗重构的检测技术.建立了HIFU治疗和EIT综合系统模型,在考虑组织的声吸收条件下,对三维Helmholtz方程在柱坐标下的声场计算进行了二维简化,并引入Pennes生物热传导方程来计算HIFU焦域的声压和温升分布特性;引入生物组织的温度-电阻抗关系,基于麦克斯韦电磁场理论,建立了具有温度分布HIFU焦域的电流和电压计算模型,利用恒流注入的边界条件实现电场计算,获得焦平面的表面电压分布.在数值计算中,利用实验聚焦换能器参数,模拟了在固定声功率下组织焦域的声场和温度场分布,以及中心和偏心聚焦条件下不同治疗时刻的电导率分布;然后通过对称电极的循环电流注入,计算了组织模型焦平面内的电流密度和电势分布,获得了焦平面圆周分布的表面电极电压;进一步采用修正的牛顿-拉夫逊算法,利用32×32的表面电极电压实现了焦平面内电导率分布的重建.结果表明,基于温度-电阻抗关系的EIT电导率重建技术不但能准确定位HIFU焦域中心,还能恢复HIFU治疗中焦域的温度分布,证明了EIT用于HIFU治疗中温度监测的可行性,为其疗效评估和剂量控制提供了一种无创电阻抗测量和成像新方法.     

基于聚多巴胺/氧化锌复合阴极缓冲层的倒置聚合物太阳能电池的研究

利用多巴胺氧化自聚合形成聚多巴胺(PDA)与ZnO结合形成PDA/ZnO复合阴极缓冲层,制备了以P3HT:PC_(61)BM为活性层的倒置结构聚合物太阳能电池,通过改变PDA的自聚合时间来分析复合阴极缓冲层对器件性能的影响.实验发现,随着PDA的自聚合时间的增加,聚合物太阳能电池的光电转换效率先增大后减小,当自聚合时间为10 min时,相应器件光伏性能达到最优值,其开路电压V_(OC)为0.66 V,短路电流密度J_(SC)为9.70 mA/cm~2,填充因子FF为68.06%,光电转换效率PCE为4.35%.器件性能改善的原因是由于PDA/ZnO复合阴极缓冲层减小了ZnO与ITO之间的接触电阻,同时PDA中存在大量的氨基有利于倒置太阳能电池阴极对电子的收集.     

Synthesis,structural and complex impedance spectroscopy studies of Ni0.4Co0.4Mg0.2Fe2O4 spinel ferrite

Spinel ferrite having composition Ni_0.4Co_0.4Mg_0.2Fe₂O₄ was prepared by sol-gel method. X-ray diffraction result indicates that the ferrite sample has a cubic spinel type structure. FT-IR showed two absorption bands (ν₁ and ν₂) that are attributed to the stretching vibration of tetrahedral and octahedral sites. Complex impedance properties have been investigated in 200–420 K temperature range with varying frequency between 40 and 10⁷ Hz. Frequency and temperature dependency of imaginary part of permittivity (?″) and dielectric loss (tanδ) has been discussed in terms of hopping of charge carriers between Fe²⁺ and Fe³⁺ ions. Activation energy has been estimated from both temperature dependency of dc conductivity and relaxation time data, which indicates that the relaxation process and conductivity have the same origin. Nyquist plots of impedance show semicircle arcs for sample and an electrical equivalent circuit has been proposed to explain the impedance results.     

基于阻抗法的预应力波纹管密实性试验研究

针对预应力波纹管中压浆不密实的问题,提出了一种基于压电阻抗法的预应力波纹管密实性检测研究方法。运用压电阻抗法的结构健康监测原理,定义了预应力波纹管灌浆密实性指标的均方根偏差RMSD(Root Mean Square Deviation),通过测试粘贴在波纹管底顶板的压电陶瓷传感器PZT(Piezoelectric Ceramic Transducer)和嵌入到波纹管内部的智能骨料SA(Smart Aggregate)的电阻抗值,与灌浆100%工况相比研究了灌浆0%、灌浆50%以及灌浆90%等工况下的电阻抗实部与虚部的频谱曲线变化规律。结论是密实性指标RMSD随预应力波纹管密实性增加而减小。上述研究成果验证了阻抗法对波纹管密实性检测的有效性。     

羧甲基壳聚糖掺杂聚苯胺的制备及其在盐酸溶液中对碳钢的缓蚀性能研究

选用结构中同时带有羟基、羧基和氨基的羧甲基壳聚糖为掺杂酸,通过改变掺杂酸与苯胺单体的比例实现了产物从纳米纤维(直径为100nm)到空心微米小球(直径为200nm)的转变.傅立叶红外(FTIR)和紫外可见光谱(UV)表征结果表明,纳米纤维和空心微米小球均为掺杂态聚苯胺.另外,采用电化学交流阻抗技术和动电位极化方法研究了所得聚苯胺在0.5mol/L盐酸溶液中对碳钢的缓蚀作用.结果表明,聚苯胺的加入量为40mg/L时,其对碳钢的缓蚀效率高达91.6%～92.3%.     

A3钢在芽孢杆菌作用下的腐蚀行为

采用表面分析技术、失重法和电化学测试技术研究了A3钢在芽孢杆菌(Bacillus)作用下的腐蚀行为.扫描电子显微镜(SEM)分析结果表明,浸泡7d时,芽孢杆菌会在A3钢表面形成致密的生物膜,有效阻隔了溶液对基体的腐蚀,抑制了腐蚀过程.电化学交流阻抗测试结果显示,含菌体系中的试样表面经历了2个时间常数→3个时间常数→2个时间常数的变化过程.失重法和极化曲线测试结果表明,芽孢杆菌的细菌活性对生物膜的保护作用有着决定性的影响,当微生物活性下降,生物膜的保护能力也会大幅降低.     

Interface analysis of pure Sn,pure Ag and Sn?Ag binary alloys in H2SO4

The electrochemical and passivation properties of three selected binary xSn? Ag (x = 26, 50 and 70 wt%) alloys were studied by means of open‐circuit potential variation, potentiodynamic curves and a.c. impedance spectroscopy techniques.The specimens were polarized between ?1.0 and 0.5 V versus saturated calomel electrode (SCE) in naturally oxygenated sulfuric acidsolutions of different concentrations The experimental results indicate that i_corr increases with increasing either the acid concentration or the Sn content in the solid phase. Electrochemical impedance spectroscopyresults measured at the free corrosion potential confirm that alloy I (26Sn? Ag) characterizes by thicker passive film with higher protective ability compared to the other two samples richer in tin component. The exponential variation of the relative thickness of the surface film on any of the tested samples assumes an almost constant thickness for a thin barrier layer and a much larger outer porous layer that dominates the total film thickness on the alloy. Copyright © 2010 John Wiley & Sons, Ltd.     

A3钢在氧化亚铁硫杆菌、链霉菌及其混合菌体系中的腐蚀行为

采用电化学方法和表面分析技术研究了A3钢在链霉菌(Stremptomyces)和氧化亚铁硫杆菌(Thiobacillus fer-rooxidans,T.f)单独及共同作用下的腐蚀行为.结果表明,试样在不同的含菌腐蚀体系中浸泡7d后,表面生成了不均匀的生物膜层,并表现出各不相同的形貌特征;A3钢在氧化亚铁硫杆菌和链霉菌单种菌作用下发生了局部腐蚀,而混合菌体系中的试样发生均匀腐蚀;混合菌体系中A3钢的腐蚀失重速率介于两种菌单独存在时的腐蚀失重速率之间;试样浸泡14d后的电化学阻抗谱(EIS)测试结果表明,A3钢电极在氧化亚铁硫杆菌-链霉菌混合菌体系中的阻抗值介于两种单菌腐蚀体系之间.以上研究结果表明,A3钢在链霉菌体系中腐蚀最重,混合菌体系其次,氧化亚铁硫杆菌体系中腐蚀最轻.