回旋速调管放大器输出腔的特性研究

 利用变截面波导的耦合模理论，根据输出腔中电场幅值分布函数所满足的微分方程组，编写了具有自动优化功能的计算程序，分析研究了不同渐变角度、考虑腔体损耗前后和输出腔与外电路失配时，谐振频率、腔体品质因数和高频场幅值沿轴分布的变化情况，为进一步研究高频场与电子注的互作用和输出腔奠定了基础。     

Measurement and calculation of gas compressibility factor for condensate gas and natural gas under pressure up to 116 MPa

The volumetric properties of two reservoir fluid samples collected from one condensate gas well and one natural gas well were measured under four groups of temperatures, respectively, with pressure up to 116 MPa. For the two samples examined, the experimental results show that the gas compressibility factor increases with the increase of pressure. But the influence of the temperature is related to the range of the experimental pressure. It approximately decreases with the increase of temperature when the pressure is larger than (45 to 50) MPa, while there is the opposite trend when the pressure is lower than (45 to 50) MPa. The dew point pressure was also determined for the condensate gas sample, which decreases with the increase of temperature. The capabilities of four empirical correlations and a thermodynamic model based on equation of state for describing gas compressibility factor of reservoir fluids under high pressure were investigated. The comparison results show that the thermodynamic model recommended is the most suitable for fluids whatever produced from high-pressure reservoirs or conventional mild-pressure reservoirs.     

SINGLE AND DOUBLE EDGE INTERFACE CRACK SOLUTIONS FOR ARBITRARY FORMS OF MATERIAL COMBINATION

In this paper interfacial edge crack problems are considered by the application of the finite element method. The stress intensity factors are accurately determined from the ratio of crack-tip-stress value between the target given unknown and reference problems. The reference problem is chosen to produce the singular stress fields proportional to those of the given unknown problem. Here the original proportional method is improved through utilizing very refined meshes and post-processing technique of linear extrapolation. The results for a double-edge interface crack in a bonded strip are newly obtained and compared with those of a single-edge interface crack for different forms of combination of material. It is found that the stress intensity factors should be compared in the three different zones of relative crack lengths. Different from the case of a cracked homogeneous strip, the results for the double edge interface cracks are found to possibly be bigger than those for a single edge interface crack under the same relative crack length.     

Nonequilibrium molecular dynamics simulation of coupling between nanoparticles and base-fluid in a nanofluid

The intent of this study is to examine nonequilibrium heat transfer in a copper-argon nanofluid by molecular dynamics simulation. Two different methods, the physical definition method and the curve fitting method, are introduced to calculate the coupling factor between nanoparticles and base fluid. The results show that the coupling factors obtained by these two methods are consistent. The coupling factor is proportional to the volume fraction of the nanoparticle and inversely proportional to nanoparticle diameter. In the temperature range of 90-200 K, the coupling factor is not affected by temperature. The nanoparticle aggregation results in a decrease of the coupling factor.     

美国NGSS科学与工程实践构架与化学教学案例——影响化学反应速率的因素

美国《新一代科学标准》（NGSS）强调科学实践的重要性并提出科学与工程实践的关键要素，不仅为科学实践的具体实施提供了方向而且使科学实践的评价标准更加明确。在介绍NGSS科学与工程实践的构架基础上，以“影响化学反应速率的因素”为例分析了科学与工程实践的关键要素在教学中的反映及实施特点，并基于案例分析提出对我国中学化学教学过程设计的借鉴与启示。     

四川省市州经济发展差异的统计分析

采用因子分析研究四川省21市州之间的相关性,利用主因子计算出各个市州得分,以市州得分作为新变量进行集团排序,再将基于相对位置排序法引入到集团排序中,进而得到最终的市州分类结果,在统计分析的基础上对市州经济发展给出一些建议.     

Exhaled breath condensate: Determination of non-volatile compounds and their potential for clinical diagnosis and monitoring. A review

Exhaled breath condensate is a promising, non-invasive, diagnostic sample obtained by condensation of exhaled breath. Starting from a historical perspective of early attempts of breath testing towards the contemporary state-of-the-art breath analysis, this review article focuses mainly on the progress in determination of non-volatile compounds in exhaled breath condensate. The mechanisms by which the aerosols/droplets of non-volatile compounds are formed in the airways are discussed with methodological consequences for sampling. Dilution of respiratory droplets is a major problem for correct clinical interpretation of the measured data and there is an urgent need for standardization of EBC. This applies also for collection instrumentation and therefore various commercial and in-house built devices are described and compared with regard to their design, function and collection parameters. The analytical techniques and methods for determination of non-volatile compounds as potential markers of oxidative stress and lung inflammation are scrutinized with an emphasis on method suitability, sensitivity and appropriateness. The relevance of clinical findings for each group of possible non-volatile markers of selected pulmonary diseases and methodological recommendations with emphasis on interdisciplinary collaboration that is essential for future development into a fully validated clinical diagnostic tool are given.     

多元统计分析方法的理论研究及应用分析

多元统计分析在多指标实际问题的研究中起着重要的作用.以往文献中,一般采用某一种多元统计方法对一个多指标实际问题进行研究,但其结果存在一定的偏差性.采用四种典型的多元统计方法:主成分分析法、因子分析法、分层聚类和K-均值聚类方法对同一个多指标银行问题进行研究,并对四种方法的不同结果进行比较综合分析,这样可以避免单一方法的偏差性,以便得到的结果更合理、更具有说服力.     

Comparison of scale factor estimators for ultrasonic temperature monitoring: Application to structural health monitoring

In Structural Health Monitoring (SHM) of materials, estimating the effects of environmental and operational conditions such as temperature is important. Indeed, temperature changes induce modifications of the mechanical properties of the material and therefore cause a dilation of the acoustic signals characterized by a scale factor. This paper described four scale factor estimators able to monitor changes in temperature: The short-time cross-correlation (STXC) method, the stretching method (STRE), the Minimum Variance Based Estimator method (MVBE) and the Scale Transform Based Estimator method (STBE). The first two methods have already been assessed in the literature while the latter two have been specifically developed for this study. First, closed-form for the Cramer-Rao bound on the estimates of the scale factor, from a simplified deterministic signal, are derived and simplified expressions are given. Then, a statistical evaluation of the quality of estimates is conducted through Monte-Carlo simulations using synthetic signals, based on a model taking into account the influence of temperature. A raw estimate of the computational complexity of signal processing methods also completes this evaluation phase. Finally, the experimental validation of estimation methods is conducted on an aluminum plate subjected to temperatures variations in a controlled thermal environment. The temperature estimates are then faced with an analytical model describing the material behavior.     

Direct modulation and optical confinement factor modulation of semiconductor lasers

Abstract

A method for modulation of semiconductor lasers is demonstrated. The method is based on the modulation of the optical confinement factor. Using this method an enhanced—3-dB bandwidth is observed in agreement with the small signal rate equation analysis. A modulation response that drops at high frequencies slower than the conventional direct current modulation response is achieved. This supports the theoretical predictions, showing an intrinsic 1/f decay rate for the optical confinement factor modulation scheme versus an intrinsic 1/f² decay for direct modulation.