Dependence of the rate constants on the treatment of internal rotation modes: the reaction OH + CH3SH --> CH3S + H2O as an example

The title reaction has been used as an example to test the importance of using a hindered rotor treatment instead of a harmonic oscillator model for calculating vibrational partition functions corresponding to low-frequency internal rotation modes. First, a normal-mode analysis according to the Ayala and Schlegel's algorithm has been used to identify the internal rotation modes of methanethiol and the transition state structure. Then, after calculation of the energy barrier for each internal rotation, the corresponding hindered rotor partition functions have been calculated following the CW scheme of Chuang and Truhlar. The results show that the anharmonic treatment produces a rather modest improvement of the rate constants at room temperature or below.     

Drift tube investigations on the reactions of O 2 + with CH4 and of CO 2 + with NO in various buffer gases

The influence of internal excitation on the reactions of O ₂ ⁺ + CH₄ and of CO ₂ ⁺ + NO has been investigated using a slow flow drift tube. The rate coefficients for these reactions obtained as a function of relative kinetic energy in various buffer gases like He, Ne, Ar, and Kr showed higher values under conditions where the internal excitation of the reactant ions was enhanced. For both reactions the lowest reactivity at all kinetic energies was observed to occur in He, indicating that He is the least effective buffer for collisionally inducing internal excitation of molecular ions.     

Ab initio study of the ground state and conformational stability of peroxyacetyl nitrate in internal rotation about the peroxide bond

The molecular and electronic structure of the ground state of peroxyacetyl nitrate (PAN) was calculated by the unrestricted Hartree-Fock-Roothaan method with the use of the standard 3–21G and 6–31G basis set. The potential curve of the internal rotation about the peroxide bond of PAN was calculated with the 6–31G basis set. The curve contains two maxima. The ground state of PAN is characterized by a structure in which groups of atoms adjacent to the peroxide bond lie in planes that are perpendicular to each other (the dihedral angle ϱ(COON) is 89.9°). The calculated barriers to rotation are 19.6 and 66.8 kJ mol⁻¹. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 4, pp. 600–604, April, 1998.     

Adsorption Behavior of a Water-soluble Porphyrin at the Glass-water Interface as Studied by Synchronous Total Internal Reflection Fluorescence Spectroscopy

Total imernal reflection fluorescence spectroscopy (TIRF) and synchronous scanning technique were combined to study the adsorption behavior of the meso-tetrakis (4-sulfonatophenyl)porphyrin (TPPS) at the glass-water interface without any surfactant. The pH dependence of synchronous fluorescence signal at the interface was analyzed. Both unprotonated (TPPS^4-) and diprotonated (H2TPPS^2-) forms of TPPS were observed at the interface. But the interface favored the adsorption of. The apparent estimated pKa2 value shifted from 5.00 in the bulk solution to 2.7 at the interface. STIRF provides a good technique to study multi-component systems at the interface.     

S1←S0 Vibronic spectra and the structure of acetyl fluoride-h3 and acetyl fluoride-d3 molecules

UV absorption spectra of acetyl fluoride-h₃ and -d₃ (CH₃COF and CD₃COF) molecules in the region of S₁S₀ electronic transitions are investigated. The origins (0⁰ ₀ or 14^0± ₀) of these transitions are observed at 39912 and 39904 cm^–1, respectively, and some of the fundamental frequencies of these molecules in the s₀ and S₁ states are determined. In particular, the systems of torsion and inversion (out-of-plane C=O vibrations) energy levels are studied. The geometric parameters of an acetyl fluoride-h₃ molecule in the S₁ state are estimated by the theoretical simulation of the rotational contours of the 0⁰ ₀ (14^0± ₀) band. These data are used to evaluate the potential barriers to internal rotation in the S₀ and S₁ states, which were found to be 360 and 560 cm^–1 for acetyl fluoride-h₃ and 380 and 770 cm^–1 for acetyl fluoride-d₃, respectively, as well as the potential barriers to inversion in the S₁ states, which were found to be 2090 and 2370 cm^–1 for acetyl fluoride-h₃ and acetyl fluoride-d₃, respectively.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 11, pp. 1957–1964, November, 1994.In conclusion, the authors would like to acknowledge T. S. Kuznetsova for the synthesis and purification of the AF samples.The research presented here was supported in part by the International Science Foundation under grant No. MJ 1000.     

Prepared Low Stress Cubic Boron Nitride Film by Physical Vapor Deposition

We present low stress cubic boron nitride (cBN) films with a transition layer deposited on the metal alloy substrates by tuned substrate radio-frequency magnetron sputtering. The films were characterized by Fourier transform infrared spectroscopy and transmission electron microscopy (TEM). The IR peak position of cubic boron nitride at 1006.3 cm⁻¹, which is close to the stressless state, indicates that the film has very low internal stress. The TEM image shows that pure CBN phase exists on the surface of the film. Several phases of boron nitride were found at the medium implantation dose. It is believed that the transition from the low ordered phases to cBN phase occurred during implantation.     

高分辨等离子体质谱法直接测定高纯镓中的痕量元素

建立高分辨电感耦合等离子体质谱法(HR-ICP-MS)测定高纯镓样品中Be、Mg、A l、S i、Ti、V、Cr、Mn、Fe、Co、N i、Cu、Zn、Ge、As、Mo、Ag、Cd、In、Sb、Ba、Pb、B i等痕量元素的方法。样品用HNO3 HC l经微波消解后,试液直接进样用HR-ICP-MS法同时测定上述元素,在高分辨质谱测量模式下避免了大量的质谱干扰,详细地研究了HC l和高纯镓所产生的基体效应,以Sc、Rh、Tl作为内标元素校正了基体效应,讨论和确定了实验的最佳测定条件。结果表明,23种痕量元素的检出限在0.001~0.21μg/L之间;回收率在89.8%~111.6%之间,相对标准偏差(RSD)小于3.3%。     

Estimation of the absolute internal-rotation entropy of molecules with two torsional degrees of freedom from stochastic simulations

A method of statistical estimation is applied to the problem of evaluating the absolute entropy of internal rotation in a molecule with two torsional degrees of freedom. The configurational part of the entropy is obtained as that of the joint probability density of an arbitrary form represented by a two-dimensional Fourier series, the coefficients of which are statistically estimated using a sample of the torsional angles of the molecule obtained by a stochastic simulation. The internal rotors in the molecule are assumed to be attached to a common frame, and their reduced moments of inertia are initially calculated as functions of the two torsional angles, but averaged over all the remaining internal degrees of freedom using the stochastic-simulation sample of the atomic configurations of the molecule. The torsional-angle dependence of the reduced moments of inertia can be also averaged out, and the absolute internal-rotation entropy of the molecule is obtained in a good approximation as the sum of the configurational entropy and a kinetic contribution fully determined by the averaged reduced moments of inertia. The method is illustrated using Monte Carlo simulations of isomers of stilbene and halogenated derivatives of propane. The two torsional angles in cis-stilbene are found to be much more strongly correlated than those in trans-stilbene, while the degree of the angular correlation in propane increases strongly on substitution of hydrogen atoms with chlorine.     

Progress on phthalocyanine-conjugated Ag and Au nanoparticles: Synthesis,characterization, and photo-physicochemical properties

Phthalocyanine (Pc) complexes are an important class of dyes with numerous (e.g., biological, photophysical, and analytical) applications. Among the methods used to improve the properties of these complexes, one should mention the introduction of different substituents, variation of the central metal ion, ligand exchange, and conjugation to nanomaterials (e.g., carbon-based nanomaterials and metal nanoparticles (NPs)). This work briefly reviews Pc complex conjugation to Ag and Au NPs, highlights the different NP shapes, and discusses the diversity of conjugation approaches. Moreover, the use of UV–Vis spectroscopy, powder X-ray diffraction, X-ray photoelectron spectroscopy, transmission electron microscopy, atomic force microscopy, dynamic light scattering and Fourier transform infrared spectroscopy to characterize Pc-NP hybrids is summarized. The effect of conjugation on Pc photo-physicochemical properties (fluorescence, singlet oxygen generation, triplet state formation, and optical limiting behavior) is discussed, and future perspectives for the synthesis and applications of new hybrids are provided.     

High modulus polyimide/polyimide molecular composite films that utilize acetylene unit as a crosslink site

Polyimide/polyimide molecular composite (MC) films comprised of a rigid polyimide derived from biphenyltetracarboxylic dianhydride (BPDA) and p-phenylenediamine (PDA) and a flexible polyimide derived from BPDA and bis (3,3'-diaminodiphenyl) acetylene (intA) and/or oxydianiline (ODA) were prepared by blending the polyamic acid solutions in 7 : 3 weight ratio, and then imidizing the blend films. Acetylene content in the flexible polyimide backbone was controlled by the ratio of intA and ODA. Cold-drawing of the blend polyamic acid films, followed by imidization, gives high modulus polyimide/polyimide MC films. The modulus of the MC films increased almost linearly with the draw ratio, reaching 25.5 GPa for the 40% drawn film. Acetylene groups in the flexible polyimide can be thermally cured to crosslink. The onset of exotherm appeared at 340°C on DSC, reaching maximum at 398°C. After the thermal crosslinking, the MC films maintained the high modulus, though elongation became small. Taking advantage of the crosslinkable acetylene units, two MC films were laminated and processed at 400°C for 20 min under 100 kg/cm² to give a good-quality laminate film. The interface of the two films was strongly bonded through the crosslinking of acetylene groups. Laminate films maintained the high modulus afforded by the cold-drawing. © 1994 John Wiley & Sons, Inc.