基于特征圆单目视觉的飞机舵面角位移标定技术

提出了一种基于特征圆单目视觉的非接触式飞机舵面角位移标定技术。用一台数码摄像机对固定在飞机舵面上的特征圆进行拍照,经数字图像处理后确定五个特征点的坐标,利用针孔成像和射影变换原理建立物像空间坐标解算模型,计算出特征圆的法线相对方向和圆心的相对位置,舵面角位移由该圆的法线方向确定。仿真结果表明,该方法具有标定过程简单、实时、快速和准确的特点,标定精度可达到0.1°。该技术也可用于航天器上实时测量交会对接时的相对位姿参数。     

一种大视场相位测量轮廓术系统标定方法

在进行大视场相位测量轮廓术系统参量标定时需要大的标定平面和精密移动台,由于携带不方便,不易进行现场标定。提出了一种用于相位测量轮廓术系统参量的高精度、现场标定方法,采用一块较小的平面标定靶在有效测量体积内不同位置多次摆放,以获取密集的数据点。先标定出摄像机的内参量和外参量,再指定一个全局参考平面和若干辅助参考平面,然后在图像平面上分区计算出每个位置标定靶上每点相对辅助参考平面的高度差和相位差,最后应用极大似然估计法估计出相位高度映射参量。实验中平面高度测量的标准偏差达到0.0433 mm。这种方法只需要较小的平面标定靶,标定过程方便、精度高,完全适合大视场三维测量相位测量轮廓术系统现场标定要求。     

The High Energy X-ray telescope (HE) onboard the Insight-HXMT astronomy satellite

The Insight-Hard X-ray Modulation Telescope(Insight-HXMT) is a broadband X-ray and γ-ray(1-3000 ke V) astronomy satellite. One of its three main telescopes is the High Energy X-ray telescope(HE). The main detector plane of HE comprises 18 Na I(Tl)/Cs I(Na) phoswich detectors, where Na I(Tl) is used as the primary detector to measure ~ 20-250 ke V photons incident from the field of view(FOV) defined by collimators, and Cs I(Na) is used as the active shielding detector to Na I(Tl) by pulse shape discrimination. Additionally, Cs I(Na) is used as an omnidirectional γ-ray monitor. The HE collimators have a diverse FOV,i.e. 1.1°×5.7°(15 units), 5.7°×5.7°(2 units), and blocked(1 unit). Therefore, the combined FOV of HE is approximately5.7°×5.7°. Each HE detector has a diameter of 190 mm resulting in a total geometrical area of approximately 5100 cm2, and the energy resolution is ~15% at 60 ke V. For each recorded X-ray event by HE, the timing accuracy is less than 10 μs and the deadtime is less than 10 μs. HE is used for observing spectra and temporal variability of X-ray sources in the 20-250 ke V band either by pointing observations for known sources or scanning observations to unveil new sources. Additionally, HE is used for monitoring the γ-ray burst in 0.2-3 Me V band. This paper not only presents the design and performance of HE instruments but also reports results of the on-ground calibration experiments.     

基于交比不变性的投影仪标定

提出了一种新的投影仪标定方法以提高数字光栅投影三维测量中投影仪标定的准确性.该方法结合二次投影技术和交比不变性进行投影仪标定.采用二次投影技术解决投射图案与标定板图案互相干扰的问题;采用交比不变性以避免引入相机的标定误差.接着进行了对比实验,以验证所提方法的有效性.选取需要相机参数的传统投影仪标定方法以及根据全局单应性...     

基于麻雀搜索算法结合深度前馈神经网络的近红外模型转移方法研究

该文提出了一种基于麻雀搜索算法结合深度前馈神经网络（SSA-DFN）的近红外光谱模型转移方法。使用深度前馈神经网络拟合不同仪器采集到的光谱之间的非线性函数映射,并将麻雀搜索算法用于网络各层连接权值和阈值的初始化,通过种群中个体位置的迭代更新,求得连接权值和阈值的最优初始值;通过多次调整深度前馈神经网络模型的超参数,使网络拟合效果趋于最优,最终确定转移函数。为验证方法的有效性,分别从烟叶近红外光谱谱图、主成分投影和预测结果的角度,将SSA-DFN方法与分段直接校正算法（PDS）、典型相关性分析算法（CCA）转移前后的效果进行了对比。结果表明SSA-DFN方法转移后的从机光谱与原主机光谱重合度最高,转移后主、从机总糖、烟碱含量的预测结果差异不显著,预测平均误差从8.32%、9.15%分别降至4.65%、4.82%,预测均方根误差（RMSEP）和决定系数（R2）等指标均优于PDS和CCA,取得了最佳的转移效果,可满足企业需求。结果表明该方法是一种有效的模型转移方法。     

氮中二氧化硫标准气体定值方法的研究

介绍用脉冲荧光分析仪对氮中二氧化硫标准气体定值的分析方法,对方法的精密度、准确度及定值的不确定度进行了考察。该方法的定值结果与重量法的配制值相一致。用该法对荷兰国家计量院制备的氮中二氧化硫标准气体进行比对试验,取得了良好的等效性。     

MALDI/FTMS中碰撞衰减机理对准确质量校正的影响

Collisional　damping　affects　the　relationship　between　ion　mass　and　effective　cyclotron　frequency　in　Fourier transform mass spectrometry. The exact mass calibration equation（m/z=A/f＋（mneutral/m^^＋mneutral）k＋B/f（f＋（mneutral/m^^＋mneutralk））was therefore derived from the characteristic equation of system model, force=m（dv/dt）=qE-qv×B0-ξv,a frictional damping force）, in which k is amended by the shift of observed frequency of matrix ion or other known ion in external calibration. The mass obtained by the amended calibration equation is therefore immune to collisional damping and space-charge effects on mass accuracy. The relative errors of ion mass measured were all less than 2×10^-6.     

Feasibility study on qualitative and quantitative analysis in tea by near infrared spectroscopy with multivariate calibration

This study attempted the feasibility to use near infrared (NIR) spectroscopy as a rapid analysis method to qualitative and quantitative assessment of the tea quality. NIR spectroscopy with soft independent modeling of class analogy (SIMCA) method was proposed to identify rapidly tea varieties in this paper. In the experiment, four tea varieties from Longjing, Biluochun, Qihong and Tieguanyin were studied. The better results were achieved following as: the identification rate equals to 90% only for Longjing in training set; 80% only for Biluochun in test set; while, the remaining equal to 100%. A partial least squares (PLS) algorithm is used to predict the content of caffeine and total polyphenols in tea. The models are calibrated by cross-validation and the best number of PLS factors was achieved according to the lowest root mean square error of cross-validation (RMSECV). The correlation coefficients and the root mean square error of prediction (RMSEP) in the test set were used as the evaluation parameters for the models as follows: R = 0.9688, RMSEP = 0.0836% for the caffeine; R = 0.9299, RMSEP = 1.1138% for total polyphenols. The overall results demonstrate that NIR spectroscopy with multivariate calibration could be successfully applied as a rapid method not only to identify the tea varieties but also to determine simultaneously some chemical compositions contents in tea.     

Least-squares support vector machines and near infrared spectroscopy for quantification of common adulterants in powdered milk

This paper proposes the use of the least-squares support vector machine (LS-SVM) as an alternative multivariate calibration method for the simultaneous quantification of some common adulterants (starch, whey or sucrose) found in powdered milk samples, using near-infrared spectroscopy with direct measurements by diffuse reflectance. Due to the spectral differences of the three adulterants a nonlinear behavior is present when all groups of adulterants are in the same data set, making the use of linear methods such as partial least squares regression (PLSR) difficult. Excellent models were built using LS-SVM, with low prediction errors and superior performance in relation to PLSR. These results show it possible to built robust models to quantify some common adulterants in powdered milk using near-infrared spectroscopy and LS-SVM as a nonlinear multivariate calibration procedure.     

多元分辨校正模型与方法研究—无机多组份分析

系统研究了各种多元分辨校正模型、方法及其应用，以模拟体系、病态体系有态体系为对象，考察了它们的多元校正能力与多元分辨效果，给我机多组份分析态体系实例。