因瓦合金纳米微粉的恒磁导率及其压力、频率特性和压力相变

 以Fe-30wt%Ni合金片为母合金，用蒸发冷凝法制备了三种粗细不同的纳米微粒。经透射电镜和X光衍射物相分析，微粒成分与母合金一致。5T、5H和3K粉的平均粒度分别为13.6、27和40 mm。在室温和43~28个不同的流体静压力（0.000 1~2.205 GPa）下测量了它们的磁化曲线、磁导率曲线和起始磁化曲线。结果表明：（1）在H＝(20－132)(1000/4π)A/m范围内Fe-30Ni合金三种纳米粉均具有恒磁导率。（2）三种纳米粉恒磁导率随静水压的变化规律如下：μ_r＝3.83+0.253p-0.022 1p²-0.007 22p³（5T粉）；μ_r＝3.93+1.20p-1.97p²+1.52p³-0.510p⁴+0.059 9p⁵（5H粉）；μ_r＝5.96-0.276p+0.107p²-0.045 9p³（3K粉）。前两者随压力增加而升高。后者随压力增加而下降。（3）γ-α马氏体相变明显存在于5T、5H粉中，而3K粉中未见到。（4）Fe-30Ni合金片的μ_i从200kHz至2 MHz已下降一个数量级，而其纳米粉μ_i的频率范围高于300 MHz，增大两个数量级以上。     

食品微生物对超高压处理的逆境响应

 超高压（High Hydrostatic Pressure,HHP）作为一种非热杀菌技术,在食品工业中有着很广泛的应用,与传统的热加工处理相比,在保持食品品质、杀菌、钝酶等方面都有其明显的优势。通过对国内外相关文献的分析,对HHP处理后处于亚致死状态食品微生物的细胞膜、遗传与结构物质、机体代谢等方面,以及大部分食品微生物在应对外界的多种刺激时而进行的普遍性调控机制的研究进行了总结,探讨了经过HHP处理后处于亚致死状态的食品微生物在逆境下存活的应激反应。     

静压及范德瓦尔斯压力对超流氦传热的影响

1引言在过冷态超流氦（HellP）被成功地获得并应用在超导磁体冷却后，超流氦的工程应用引起了低温工程和低温物理研究者的重视，各种各样的HellP制冷机（恒温器）相继出现。同时出现了很多有关Hell浴中传热的论文山；然而从未有过有关压力对传热影响的系统研究。本文以Hell传热的基本规律及Hell的相图为基础，结合传热实验结果系统地研究了压力对Hell传热的影响。2P＜PA时Hell中的最大临界热负荷软2·1饱和态起流氧2·1·1无噪声沸腾Hell传热中试样达到其最大临界热负荷伽的前提条件是必须克服一过冷度凸Tin。x。如图1氦的相图所示，…     

高压处理后水稻抗氧化酶活性及对逆境胁迫的响应

 对经高静水压处理的水稻粤香占（Oryza sativa L. cv. Yuexiangzhan）种子播种后的植株进行了抗氧化酶活性的测定和对逆境胁迫响应的研究。结果表明,高压处理抑制了水稻生长早期（12 d）色素和蛋白质含量的增加,并使早期抗氧化酶活性表现较对照低。随着播种天数增加,经高压处理的材料中的色素、蛋白质含量不同程度地增加,抗氧化酶活性发生改变,至播种后32 d时,高压处理的叶绿素含量和可溶性蛋白含量都高于对照粤香占。在自然低温条件下,经高压（干压、湿压）处理的植株其Rubisco大、小亚基含量和光合色素含量较高,抗光抑制能力增强,具一定的耐低温性。     

响应曲面法优化超高压杀灭金黄色葡萄球菌条件的研究

 因子试验研究结果表明,显著影响超高压杀灭金黄色葡萄球菌效果的外界因子是温度、压力和保压时间。在此基础上,采用响应曲面法（Response Surface Methodology,RSM）建立了超高压杀灭金黄色葡萄球菌的二次多项数学模型,验证了模型的有效性,并探讨了上述3个因子的交互作用及其最佳水平范围,优化出杀灭6个数量级金黄色葡萄球菌ATCC6538的外界条件为：温度34.35 ℃,压力329.84 MPa,时间15.53 min。     

静水高压处理对水稻植株生理特性的影响

 以75 MPa静水高压处理萌动的水稻种子12 h，成苗后移栽至大田，研究高压处理后植株剑叶光合特性的变化。结果显示，静水高压处理后，粤香占和粤丰占种子的发芽率分别降低了14.4% 和16.6%，成苗率分别降至对照的24.6%和21.9%，生长明显受抑制，幼苗的株高在35天左右才能追赶上对照。高压处理的粤香占剑叶在生育过程中的净光合速率（P_n）和表观量子效率（AQY）的总平均值分别比未处理的对照增加了9.2%和12.4%，而粤丰占则分别增加5.7%和17.4%。高压处理后两个品种的植株叶片不同生长时期的平均光合色素含量均高于未处理的对照，在生长后期的衰老过程中高压处理植株剑叶的色素含量和PSⅡ光化学效率F_v/F_m下降速率较各自的未处理对照缓慢。高压处理后两个水稻品种的生物量和单株产量分别比对照提高了8%~27%及7%~14%。提出高压处理可能作为一种新的选育品种的方法。     

水稻种子萌发期高压诱导的SSH-cDNA文库构建与分析

 为了研究高压处理对高等植物基因表达的影响,以萌发过程中经高压处理后的水稻种子的mRNA作为检测子（Tester）,以对照样品的mRNA作为驱动子（Driver）,采用抑制差减杂交（SSH）结合镜像选择技术（MOS）构建了高压处理后水稻种子萌发过程中诱导表达的差减cDNA文库,并通过蓝白斑筛选获得了580个重组克隆。菌液PCR检测的结果表明这些克隆中的插入片段的大小主要分布在200～1000 bp之间,平均大小约为575 bp,其中单一扩增条带的有效重组克隆数为542个,有效的重组克隆率为93.3%。对部分重组克隆进行测序发现,受高压诱导表达的基因主要涉及到代谢、胁迫响应、转录调控等方面。为高压处理后水稻种子基因表达模式变化的研究打下了基础。     

水稻压致变异和高压对水稻生长发育的影响

 将高收获指数型优质籼稻（Oryza sativa L.）品种“粤香占”种子在不同条件下进行了3个生长周期的高压种子处理和实验室种植试验。稻种经高压处理后,与对照样品相比,当代种子发芽和秧苗成长较慢且植株个体差异较大;后期生长较快,分蘖数及产量与对照样持平或有所增加。受压样品产生了4种新的植株变异,其中2种为不育植株,另外两种变异植株种植至F2及F3代,变异性状都能稳定遗传。表明高压不仅可以对水稻当代植株生理产生明显的影响,而且可以诱导水稻产生明显和稳定的可遗传变异。     

Phase Diagrams of Semicrystalline Polymer–Crystalline Substances: Polyolefins–1,2,4,5-Tetrachlorobenzene

The full phase diagrams of low-density polyethylene (LDPE), high-density polyethylene (HDPE), and isotactic polypropylene (i-PP) mixtures with 1,2,4,5-tetrachlorobenzene (TeCB), including the solubility curve of TeCB in a solid polymer, were constructed by an optical method. The diagrams contain a eutectic point that corresponds to the situation when the crystallization of TeCB out of its solution in a polyolefin is accompanied by the crystallization of monomer units of the macromolecules. As a result, the polymer acquires a gel structure with crystallites as crosslinks and amorphous regions saturated with TeCB. It is demonstrated that the eutectic point position on the phase diagram can be used for ranking polymers with respect to their thermodynamic affinity to a solvent. For the studied systems, the affinity to TeCB was decreased in the order i-PP, HDPE, and LDPE. Direct experimental evidence was obtained that TeCB crystals can be dissolved in a solid polymer via a vapor phase mechanism, which leads to the polymer amorphization.     

Combined of ultrasound irradiation with high hydrostatic pressure (US/HHP) as a new method to improve immobilization of dextranase onto alginate gel

In this research work, dextranase was immobilized onto calcium alginate beads by the combination of ultrasonic irradiation and high hydrostatic pressure (US/HHP) treatments. Effects of US/HHP treatments on loading efficiency and immobilization yield of dextranase enzyme onto calcium alginate beads were investigated. Furthermore, the activities of immobilized enzymes prepared with and without US/HHP treatments and that prepared with ultrasonic irradiation (US) and high hydrostatic pressure (HHP), as a function of pH, temperature, recyclability and enzyme kinetic parameters, were compared with that for free enzyme. The maximum loading efficiency and the immobilization yield were observed when the immobilized dextranase was prepared with US (40 W at 25 kHz for 15 min) combined with HHP (400 MPa for 15 min), under which the loading efficiency and the immobilization yield increased by 88.92% and 80.86%, respectively, compared to immobilized enzymes prepared without US/HHP treatment. On the other hand, immobilized enzyme prepared with US/HHP treatment showed V_max, K_M, catalytic and specificity constants values higher than that for the immobilized enzyme prepared with HHP treatment, indicated that, this new US/HHP method improved the catalytic kinetics activity of immobilized dextranase at all the reaction conditions studied. Compared to immobilized enzyme prepared either with US or HHP, the immobilized enzymes prepared with US/HHP method exhibited a higher: pH optimum, optimal reaction temperature, thermal stability and recyclability, and lower activation energy, which, illustrating the effectiveness of the US/HHP method. These results indicated that, the combination of US and HHP treatments could be an effective method for improving the immobilization of enzymes in polymers.