Application of High Pressure-DTA for High Pressure-liquid Phase Epitaxy of Doped Mercury and Thallium HTS Formations

The fabrication method of superconducting thin films of compositions HgBa₂Ca₂Cu₃O_8+δ (Hg-1223) and Tl₂Ba₂CuO_y (2201) on single-crystalline SrTiO₃ and LaAlO₃ substrates is reported. The highest obtained T _c was 134 K and J _c over 10⁶ A cm^–2 at 77 K. High pressure DTA(HP-DTA) was applied to grow mercury- and thallium-based high-temperature superconducting crystals and thin films, to identify melting points of particular phases within these oxide systems and determine suitable processing conditions. The DTA system operates at the: maximum temperature of 1200°C, volume up to 5 cm³, working pressure up to 1.5 GPa and at a working atmosphere — inert gas with up to 25% oxygen. This revised version was published online in August 2006 with corrections to the Cover Date.     

On the pressure-induced phase transformation in the structure II clathrate hydrate of tetrahydrofuran

A high-pressure phase of the clathrate hydrate of tetrahydrofuran was prepared by freezing a liquid phase of overall composition THF · 7 H₂O under a pressure of 3.0 kbar, or by pressurizing the solid structure II THF hydrate of 255K to 3.4 kbar. Unfortunately, the products recovered at 77K were always mixed phase materials as shown by X-ray powder diffraction. A number of diffraction lines could be indexed in terms of the cubic structure I hydrate with a slightly expanded lattice parameter, 12.08 Å, giving some support to Dyadin's idea that the high pressure phase transition involves a conversion of Structure II to Structure I. Other phases observed in the recovered product include Ice IX and amorphous materials. The reversion of the high pressure sample to the structure II hydrate was followed by differential scanning calorimetry. At ambient pressure, the high pressure sample converts slowly back to Structure II hydrate event at 77K.NRCC No. 35786.     

疏水缔合型增稠剂聚(丙烯酰胺-丙烯酸高级酯)的合成及增稠性能研究

采用沉淀聚合法合成了聚（丙烯酰胺－丙烯酸十四酯），聚（丙烯酰胺－丙烯酸十六酯）和聚（丙烯酰胺－丙烯酸十八酯），重点讨论了共聚物中疏水基团数量及疏水基团链长对增稠性能的影响。采用凯达尔定氮法和动态热分析（DMTA）测定了共聚物的组成及玻璃化温度。     

反相高效液相色谱法测定3种中成药中的葛根素

 建立了测定小儿清感灵片、步长新脑心通胶囊和感冒清热颗粒 3种中成药中葛根素含量的反相高效液相色谱方法。采用APEXODS色谱柱 ,以醋酸铵缓冲液 (10 0mmol/L ,pH 5 0 ) 甲醇 (体积比为 75∶2 5 )的混合溶液为流动相 ,检测波长为 2 5 0nm ,流速为 0 8mL/min。葛根素在 2mg/L～ 2 0mg/L时其色谱峰面积与质量浓度的线性关系良好 (r =0 9999) ;上述 3种中成药中的葛根素含量分别为 3 48mg/g ,1 0 8mg/ g及 1 5 2mg/ g(蔗糖型 ) ;其加样回收率分别为 99 0 % ,93 4%和 97 5 %。该法简便、快速、专属性强 ,可以作为多种中药制剂中葛根素含量的测定方法。     

Influence of biomass on hydrodynamics of an internal loop airlift reactor

The effect of the biomass presence on the overall circulation velocity, the linear velocities both in the riser and the downcomer and the overall gas hold-up was studied in a three-phase internal loop airlift reactor (ILALR). The measured data were compared with those obtained using a two-phase system (air—water). All experiments were carried out in a 40 dm³ ILALR at six different biomass concentrations (ranging from 0 g dm⁻³ to 7.5 g dm⁻³), at a temperature of 30°C, under atmospheric pressure. Air and water were used as the gas and liquid model media, respectively. Pellets of Aspergillus niger produced during the fermentation of glucose to gluconic acid in the ILALR were considered solid phase. In addition, liquid velocities were measured during the fermentation of glucose to gluconic acid using Aspergillus niger. All measurements were performed in a bubble circulation regime. At given experimental conditions the effect of the biomass on the circulation velocities in the ILALR was negligible. However, increasing of the biomass concentration led to lower values of the total gas hold-up. Presented at the 33rd International Conference of the Slovak Society of Chemical Engineering, Tatranské Matliare, 22–26 May 2006.     

Wärmekapazitätsmessungen Nach Scanning-Methoden Bis Zu Hohen Temperaturen

Scanning calorimetric methods permit determination of heat capacities at high temperatures up to 1600°C. For disk systems with power compensation application limits are in order of 700°C, and for cylindrical systems with electrical calibration up to 1000°C. For the high temperature range above 1000°C DSC plates and a cylindrical calorimetric systems based on the CALVET principle ('MULTI HTC’) are known. For cylindrical calorimetric systems the precision of the Cp data is between 2 and 5% even at high temperatures without any requirements on the kind and shape of samples. These results are better than data provided by DSC plate systems. This revised version was published online in July 2006 with corrections to the Cover Date.     

反相高效液相色谱法测定全血中马钱子碱和士的宁的含量

 建立了反相高效液相色谱法定量分析全血中马钱子碱和士的宁含量的方法。该方法应用Oasis  R ○ MCX固相萃取小柱进行提取、采用XTerra TM RP 18 色谱柱进行分离。在该条件下马钱子碱和士的宁的线性范围为0.05～10 mg/L ,最小检出限为0.15 ng。该方法测得马钱子碱和士的宁在低、中、高浓度下的回收率均在90%以上,日内、日间精密度均符合方法学要求。该方法灵敏、快速、准确,适用于临床血药浓度监测和法医毒化检验。     

On the Temperature–Pressure Free‐Energy Landscape of Proteins

We studied the thermodynamic stability of a small monomeric protein, staphylococcal nuclease (Snase), as a function of both temperature and pressure, and expressed it as a 3D free‐energy surface on the p,T‐plane using a second‐order Taylor expansion of the Gibbs free‐energy change ΔG upon unfolding. We took advantage of a series of different techniques (small‐angle Xray scattering, Fourier‐transform infrared spectroscopy, differential thermal analysis, pressure perturbation calorimetry and densitometry) in the evaluation of the conformation of the protein and in evaluating the changes in the thermodynamic parameters upon unfolding, such as the heat capacity, enthalpy, entropy, volume, isothermal compressibility and expansivity. The calculated results of the free‐energy landscape of the protein are in good agreement with experimental data of the p,T‐stability diagram of the protein over a temperature range from 200 to 400 K and at pressures from ambient pressure to 4000 bar. The results demonstrate that combined temperature–pressure‐dependent studies can help delineate the free‐energy landscape of proteins and hence help elucidate which features and thermodynamic parameters are essential in determining the stability of the native conformational state of proteins. The approach presented may also be used for studying other systems with so‐called re‐entrant or Tamman loop‐shaped phase diagrams.     

K3MnH5, das erste salzartige Manganhydrid

K₃MnH₅, the First Salt-like Manganese Hydride K₃MnH₅ and K₃MnD₅ were synthesized by the reaction of potassium hydride (deuteride) with manganese powder under a hydrogen pressure above 3000 bar at 875 K. X-ray investigations on powdered samples and elastic neutron diffraction experiments on the deuterated compound at the time-of-flight spectrometer LAD in the temperature range 5–600 K led to the complete structure determination. The atomic arrangement is isotypic with that of Cs₃[CoCl₄]Cl (space group: 14/mcm, Z = 4). The structure of K₃MnH₅ contains isolated [MnH₄]^2?-tetrahedra and additional hydrogen ions which are exclusively coordinated by potassium cations. The magnetic susceptibilities show Curie-Weiss behaviour. At temperatures below 50 K there are obviously antiferromagnetic interactions.