Study of local lattice relaxation of substitutional impurities in silicon and germanium

Local lattice relaxation of substitutional donors in silicon investigated using self‐consistent multiple scattering Xα (MSXα) method within the framework of the standard muffin‐tin potential approximation is extended to substitutional donors in germanium and substitutional acceptors in both silicon and germanium. Incorporating the effect of lattice relaxation surrounding the impurity makes the model suitable for both shallow and deep levels. Chemical trends of some aspects of impurity states, such as local lattice relaxation and charge transfer, of the impurities both in silicon and germanium are inferred. © 2004 Wiley Periodicals, Inc. Int J Quantum Chem, 2004     

Specific heat and related thermophysical properties of liquid Fe-Cu-Mo alloy

The specific heat and related thermophysical properties of liquid Fe77.5Cu13Mo9.5 monotectic alloy were investigated by an electromagnetic levitation drop calorimeter over a wide temperature range from 1482 to 1818 K. A maximum undercooling of 221 K (0.13 Tm) was achieved and the specific heat was determined as 44.71 J·mol-1·K-1. The excess specific heat, enthalpy change, entropy change and Gibbs free energy difference of this alloy were calculated on the basis of experimental results. It was found that the calculated results by traditional estimating methods can only describe the solidification process under low undercooling conditions. Only the experimental results can reflect the reality under high undercooling conditions. Meanwhile, the thermal diffusivity, thermal conductivity, and sound speed were derived from the present experimental results. Furthermore, the solidified microstructural morphology was examined, which consists of (Fe) and (Cu) phases. The calculated interface energy was applied to exploring the correlation between competitive nucleation and solidification microstructure within monotectic alloy.     

集中荷载下叠合梁抗剪强度

本文对低叠合面钢筋破简支在合梁二阶段受力的斜截面抗剪性能进行了试验研究，并运用非线性有限元分析和试验实测数据，得出了一个适合于集中荷载下高低叠合面叠合梁的抗剪强度计算公式．     

Characterization of reduced iso‐α‐acids derived from hops (Humulus lupulus) by NMR

Reduced forms of iso‐α‐acids (isohumulones), used in modern beer brewing were separated and characterized by ¹H and ¹³C NMR spectroscopy. Components from mixtures of rho‐iso‐α‐acids, tetrahydro‐iso‐α‐acids, and hexahydro‐iso‐α‐acids were isolated using high‐performance liquid chromatography (HPLC) and analyzed by use of one‐ and two‐dimensional NMR experiments. The data presented assign the identities of the main peaks in the HPLC traces for the reduced iso‐α‐acids. Previous tentative assignments regarding the cis and trans configurations and the structures of the acyl residues of the reduced iso‐α‐acids were confirmed and extensive NMR assignments were made. Furthermore, the previously unknown stereochemistry in the C‐4 side‐chain of the rho‐ and hexahydro‐iso‐α‐acids was assigned. Copyright © 2003 John Wiley & Sons, Ltd.     

Interpretation of the polyelectrolyte and antipolyelectrolyte effects of poly(N‐vinylimidazole‐co‐sodium styrenesulfonate) hydrogels

Hydrogels of N‐vinylimidazole (VI) and sodium styrenesulfonate (SSS) were synthesized in aqueous solution by radical crosslinking copolymerization with N,N′‐methylene‐bis(acrylamide) as crosslinker. Swelling in several saline solutions was measured for hydrogel samples synthesized with different comonomer concentrations (C_T = 10, 25, or 40%) and with SSS mole fractions covering a broad range (f_SSS = 0–0.7), while the crosslinker ratio was 2 wt % in all cases. The degree of swelling in aqueous solution with a specific ionic strength (μ), plotted versus the SSS composition of the feed, shows a minimum for any set of samples synthesized with a fixed C_T. The dependence of swelling on μ shows both polyelectrolyte (f_SSS beyond the minimum) and antipolyelectrolyte behaviors (in the low f_SSS limit). It was found that the nonGaussian factor of the crosslinking density and the polymer‐solvent interaction parameter increase with f_SSS for any C_T. Moreover, in the low f_SSS limit, the osmotic swelling pressure is governed not only by the ionic contribution, but also by the polymer‐solvent mixing and, the concentration of mobile counterions inside the gel is not proportional to the net fixed charge but to the addition of cationic and anionic side groups, what discards the formation of ionic pairs. The antipolyelectrolyte effect is interpreted as due to the increasing protonation of VI as μ goes up. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1683–1693, 2007     

室温下压致铁钴镍合金的bcc→hcp相变

 本文采用高压X光衍射方法在金刚石对顶压砧中在位地（in situ）研究了Fe₆₈Co₂₄Ni₈（wt%）合金在室温下的压致bcc→hcp结构相变和直到40.5 GPa的等温压缩行为。实验结果表明该合金在常压下为bcc结构，晶格常数a₀=(0.287 0±0.000 1) nm，体积V₀=(7.119±0.007) cm³/mol，密度ρ₀=(7.981±0.008) g/cm³；在20.9 GPa附近出现bcc→hcp结构相变，两相共存压力区约10 GPa，在此区域内有晶面间距d(002)_hcp=d(110)_bcc，且原子平面(002)_hcp//(110)_bcc，hcp相比bcc相体积减小(0.33±0.02) cm³/mol；高压相hcp结构的晶格参数比值c/a=1.608±0.004；相变后原子配位数的增加使得hcp相(002)平面内及(002)平面间的最近邻原子间距比bcc相最近邻原子间距分别增大约1.6%和0.5%；用Murnaghan状态方程对实验数据进行最小二乘法拟合，得到bcc相B₀=(130±13) GPa，B₀'=12.6±0.5；hcp相V₀=(6.62±0.04) cm³/mol，B₀=(243±21) GPa，B₀'=6.8±0.3；对于该合金的bcc→fcp相变时的结构转变机制做了详细的讨论。     

高压下液态Ag-20 at%Ge合金的凝固及密排六方亚稳相的形成

 利用高压淬火方法，在液态Ag-20at%Ge合金的凝固过程中，对比液态急冷低四个数量级的冷却速率得到了单相密排六方结构亚稳相，其点阵参数为a=0.289 8 nm，c=0.470 8 nm，c/a=1.625。     

Gas solubility of carbon dioxide in poly(lactic acid) at high pressures: Thermal treatment effect

The sorption of carbon dioxide in glassy Poly(lactic acid) (PLA) films was studied by quartz crystal microbalance (QCM) at high pressures. Two thermal treatments, melted and quenched, were performed in PLA with two different L:D contents, 80:20 and 98:2, films and compared with a third thermal protocol, annealed, and used in a previous work. The results obtained show that for pressures higher than 2 MPa, the carbon dioxide solubility is larger in PLA 80:20 than in PLA 98:2, indicating that the L:D plays a dominant role on this property. The thermal treatments only affect the gas solubility in PLA 98:2. Sorption isotherms at temperatures 303, 313, and 323 K, below the glass transition temperature of the polymer, and pressures up to 5 MPa were measured and analyzed with three different models, the dual‐mode sorption model, the Flory–Huggins equation, and a modified dual‐mode sorption model where the Henry's law term was substituted by the Flory–Huggins equation. This last model performs especially well for CO₂ in PLA 80:20, due to the convex upward curvature of the solubility isotherms for that system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 616–625, 2007     

碳化硅压腔和高压下的中子衍射

使用宝石级碳化硅晶体作为压砧材料，成功研制出了碳化硅压腔（MAC），并应用全景式MAC进行了高压下物质的中子衍射实验研究。结果表明，MAC是一种既能产生高的压力又具有大的高压样品室的装置，特别适合于高压下的中子衍射研究。     

一种新的磷化铟复合沟道高电子迁移率晶体管小信号物理模型

针对磷化铟(InP)复合沟道高电子迁移率晶体管(HEMT)的特点，对常规单沟道HEMT的小信号物理模型进行了修正，提出了一种新的用于复合沟道HEMT的小信号物理模型，用商用器件模拟软件ISE(integrated systems engineering)对其进行了仿真验证，对比了实测和仿真的I-V特性及转移特性曲线，重点研究了在InGaAs/InP双层沟道中考虑量子效应后的电场和电流密度随着不同栅电压的变化趋势，研究结果表明，由于在沟道中存在量子效应，在栅下靠源端低电场区域，电流主要分布在InGaAs沟道 关键词： 高电子迁移率晶体管 复合沟道 物理模型 磷化铟