含气率对PTS时压力容器内流动与传热的影响

本文对反应堆压力容器紧急安注时的流动与传热特性在1/10的模型上进行了流动可视化、局部传热系数以及混合函数的试验研究。针对三个热冲击敏感区域的部分测点,比较了环腔流速为0.5m/s、安注流速为1～30 m/s时不同含气率对下降环腔内流动与传热特性的影响,得出并分析了不同测点传热系数、混合函数的变化规律。研究结果表明:随着含气率增大,安注流体与环腔流体的混合增强;下降环腔内的含气率对小安注流速时的流动与传热影响显著,而对大安注流速时影响较小。     

Investigation of hypersonic nozzle flow uniformity using NO fluorescence

Planar laser-induced fluorescence visualisation is used to investigate nonuniformities in the flow of a hypersonic conical nozzle. Possible causes for the nonuniformity are outlined and investigated, and the problem is shown to be due to a small step at the nozzle throat. Entrainment of cold boundary layer gas is postulated as the cause of the signal nonuniformity. PACS 47.80.Jk, 47.40.Ki, 47.60.+i     

An M/G/1 Retrial Queueing System with Two-Phase Service and Preemptive Resume

An M/G/1 retrial queueing system with additional phase of service and possible preemptive resume service discipline is considered. For an arbitrarily distributed retrial time distribution, the necessary and sufficient condition for the system stability is obtained, assuming that only the customer at the head of the orbit has priority access to the server. The steady-state distributions of the server state and the number of customers in the orbit are obtained along with other performance measures. The effects of various parameters on the system performance are analysed numerically. A general decomposition law for this retrial queueing system is established.     

Halomethanes in tri-n-octylamine and squalane mixtures at infinite dilution

The retention behavior of eight halomethanes and four saturated hydrocarbons was measured in gas chromatographic stationary phases consisting in tri-n-octylamine (TOA), squalane (SQ) and six TOA+SQ mixtures, at 55.0, 58.5, 62.5 and 65.0°C. Equlibrium constants for complex formation were extracted from experimental data by using a lattice model developed by Martire. The results may be interpreted in terms of the formation of weak hydrogen-bonded complexes, with sociation constants of about 0.13 L-mol^–1 for haloforms and 0.07 L-mol^–1 for dihalomethanes at 60°C.     

Numerical integration of ordinary differential equations on manifolds

Summary This paper is concerned with the problem of developing numerical integration algorithms for differential equations that, when viewed as equations in some Euclidean space, naturally evolve on some embedded submanifold. It is desired to construct algorithms whose iterates also evolve on the same manifold. These algorithms can therefore be viewed as integrating ordinary differential equations on manifolds. The basic method “decouples” the computation of flows on the submanifold from the numerical integration process. It is shown that two classes of single-step and multistep algorithms can be posed and analyzed theoretically, using the concept of “freezing” the coefficients of differential operators obtained from the defining vector field. Explicit third-order algorithms are derived, with additional equations augmenting those of their classical counterparts, obtained from “obstructions” defined by nonvanishing Lie brackets.     

准移动闭塞系统的元胞自动机模型及列车延迟传播规律的研究

在NaSch模型的基础上，针对铁路交通的特点提出一种用于模拟准移动闭塞系统的元胞自动机模型.应用该模型模拟了准移动闭塞系统列车延迟传播的交通现象，分析了准移动闭塞系统中的轨道定位单元长度、发车时间间隔、初始延迟时间等因素对列车延迟传播的影响. 关键词： 元胞自动机 交通流 准移动闭塞     

水斗非定常自由水膜流三维贴体数值模拟

本研究采用水斗三维非正交贴体坐标系进行了非定常自由水膜流动的数值解析。对不规则水斗内表面采用三维非正交贴体坐标系下离散点进行拟合,推导了曲面离散点的法向矢量和曲面微元面高斯曲率、平均曲率等几何特征量的计算公式,进而导出流体粒子在运动方向上曲率计算式。在水斗三维贴体坐标系中,还推导了流体粒子在水斗曲面上的运动控制方程。最后对某水轮机水斗内表面非定常自由水膜流进行了数值模拟,得到其非定常水膜流态分布。     

AGE method simulations of a turbulent far‐wake compared to spectral DNS

Turbulent flow simulation methods based on finite differences are attractive for their simplicity, flexibility and efficiency, but not always for accuracy or stability. This paper demonstrates that a good compromise is possible with the advected grid explicit (AGE) method. Starting from the same initial field as a previous spectral DNS, AGE method simulations of a planar turbulent wake were carried out as DNS, and then at three levels of reduced resolution. The latter cases were in a sense large‐eddy simulations (LES), although no specific sub‐grid‐scale model was used. Results for the two DNS methods, including variances and power spectra, were very similar, but the AGE simulation required much less computational effort. Small‐scale information was lost in the reduced resolution runs, but large‐scale mean and instantaneous properties were reproduced quite well, with further large reductions in computational effort. Quality of results becomes more sensitive to the value chosen for one of the AGE method parameters as resolution is reduced, from which it is inferred that the numerical stability procedure controlled by the parameter is acting in part as a sub‐grid‐scale model. Copyright © 2002 John Wiley & Sons, Ltd.     

Simulation of the Action of a Permeable Barrier on an Ideal Incompressible Channel Flow

Plane ideal incompressible flow in a rectangular channel partitioned by a thin permeable barrier (lattice) is considered. In flowing through the lattice the stream suddenly (jumpwise) changes direction and loses energy. The flow is assumed to be vortical; the vorticity is discontinuous on the lattice. A mathematical formulation of the problem for the stream function is proposed in the form of a nonlinear elliptic equation with coefficients discontinuous on the lattice line. A numerical solution is constructed using the finite-element iteration method. The results of the numerical simulation show how the flow velocity profile in the channel can be controlled by means of permeable barriers.     

Convergent Flows of Molten Polymers Modeled by Generalized Second-Grade Fluids of Power-Law Type

The molding processes of polymer melts involve geometrically complex dies. Such dies are usually tapered or streamlined to achieve a maximum output rate under conditions of laminar flow. The model of a generalized second-grade fluid of power-law type is used and the results obtained are illustrated by examples of convergent flows in conical and wedge-shaped dies.