从像上提取非旋转对称系统的传递函数制作解卷空间滤波器

本文提出从高分辨电子显微像中,利用光学、全息和部分相干等方法,提取传递函数,制作相位和振幅滤波器,实现解卷,提高高分辨电子显微像的分辨率.     

滤波器对偏振模色散的补偿

根据耦合非线性薛定谔方程 ,本文研究了偏振模色散如何影响各种码型的频谱 ,分析了滑频滤波器和固定滤波器对偏振模色散的补偿作用。研究结果表明 :偏振模色散对不同码型的频谱影响是不一样的 ,对色散管理孤子的频谱影响最大 ,产生新的频率分量也最多 ,而且每个新频率分量都较强 ,比入射频谱展宽许多 ;滑频滤波器和固定滤波器对偏振模色散都具有补偿作用 ,使最大可传输距离成倍增加 ,两种滤波器对偏振模色散的补偿作用相差较小 ;但是对色散管理孤子系统中的偏振模色散补偿效果最佳。     

Measurements of Optical Signals and Their Spectra in the Femtosecond Range with Additional Phase Modulation

A solution to the phase problem in optics is considered within the context of the analysis of signals changing in time and of the effect of an object under investigation on the probing radiation. The solution is based on the use of a twin-wave interferometer with phase modulation in one of the channels and a spectrometer. The analysis is concerned, in particular, with signals and processes of ultrashort duration. To shift the frequency in the interferometer channel, an electrooptical crystal of ferroelectric perovskite is used as the modulator. Errors of amplitude and phase structures determined are analyzed.     

波段三维ESR成像系统的研制（Ⅴ）——灵敏度与分辨率实验及系统总性能指标

实验确定了自行研制的L波段三维电子自旋共振成像（3D-ESRI）系统的检测灵敏度及成像分辨率指标. 用Tempo水溶液模型测量灵敏度结果表明： 样品体积为10 mm, 高30 mm，测量浓度1×10^-4 mol/L水溶液的信噪比为S/N=4∶1；加梯度磁场后，样品浓度需>5×10^-4 mol/L，样品体积为19 mm, 高30 mm时，获得的投影谱的信噪比可满足图像重建的需要. 用DPPH固体样品确定的成像分辨率结果<1 mm. 文中还对ESRI系统的
各项总体性能做了归纳总结.     

磁性Salisbury屏的高频响应

研究了利用磁性薄膜构造Salisbury屏的可能性及其在微波频段的反射率频率特性.结果表明，利用铁磁性材料在铁磁共振频率附近磁化率具有χ″>χ′的特性，可以构造出对电磁波有良好吸收性能的磁性Salisbury屏.通过对铁磁材料高频磁谱物理机理的分析后指出，具有弛豫型共振磁谱的铁磁材料可以构造出薄膜型Salisbury屏，其厚度为微米甚至亚微米量级.反射率的频率特性与磁性材料的特征阻抗z-r有关，它取决于铁磁共振频率和静态磁化率.反射率的频率响应显示磁性薄膜Salisbury屏具有较宽的吸收带宽. 关键词： 磁性Salisbury屏 反射率 频带响应 磁性薄膜     

X波段六腔渡越管振荡器的高频特性研究

 从麦克斯韦方程出发，采用时域有限差分法（FDTD）和离散傅里叶变换（DFFT）相结合的方法，通过数值计算得出了六腔开放式谐振腔中前四个谐振频率和场分布，计算出的谐振频率与实验测量结果基本相同。比较了开放腔和封闭腔谐振频率，验证了TEM波吸收边界条件，并在实际编程计算中得以应用。计算结果为六腔渡越管振荡器的机理研究提供了依据。     

Resolution of Secondary α-Ketoalcohols Catalyzed by Lipase and Inversion of Stereochemistry

Several α-ketoalcohols of synthetic value were resolved using lipase as a catalyst. Lipoprotein lipase (LPL) provided the best rate of hydrolysis and kinetic differentiation. One of these optically pure α-ketoalcohol was converted to (5)-ibuprofen in good optical purity. The stereospecific inversion of (R)-alcohol to (S)-alcohol is described.     

Temperature Dependence of InSb Reflectivity in the Far Infrared: Determination of the Electron Effective Mass

We measured the dependence of the reflectivity of InSb crystals upon temperature in the submillimeter region using monochromatic radiation from an optically pumped far infrared (FIR) laser. The measures allowed us to determine the value of the electron effective mass at low temperatures with radiations of different frequencies. Our measurements extend the results obtained recently on pure crystals with magneto-optical methods to the low temperatures region where only old measures were available.     

Deconvolution of very low primary energy SIMS depth profiles

In this paper, the deconvolution of SIMS profiles analysed at very low primary energy (0.5 keV/O₂⁺) is addressed. The depth resolution function (DRF) of the SIMS analysis in presence of roughness is established and a deconvolution procedure is implemented without or in presence of roughness on samples containing delta-doped layers of boron in silicon. It is shown that the deconvolution procedure can lead to a great improvement of the full width at half maximum (FWHM) of the measured peaks in the case where no roughness in detected in the crater bottom. In the case where it is present, the conditions required to use a deconvolution procedure are discussed, and the deconvolution is implemented using precise and restrictive assumptions.     

Dynamic response of permalloy/Cu/Co magnetoresistive sandwiches

The dynamic response of trilayer magnetoresistive permalloy/Cu/Co films was studied by high-frequency permeability spectra measurements. The resonance frequency is shown to depend on the interlayer copper thickness. This dependence is related to exchange coupling between permalloy and cobalt and the interaction field is estimated using the Landau–Lifschitz–Gilbert model.