油水井水泥环在冲击载荷作用下的损伤分析

 冲击整形扩径工艺是修复油水井套管损坏的常用技术，根据冲击整形的施工工艺和波 动理论，建立了套损局部位置处水泥环的损伤力学模型，以有限变形理论为基础，采用悬臂 梁力学模型，分段研究了冲击整形时钻杆屈曲的平衡位形及对套管、水泥环产生 的冲击力. 结合水泥环的应力状态, 根据脆性 材料的Mazars损伤模型，建立了水泥环的损伤力学模型. 并分析了水泥环的损伤 状态. 通过与现场测试结果对比，理论计算与实测结果误差在2.7%左右.     

Global stability analysis of a 90°-bend pipe flow

The present work investigates the stability properties of the flow in a 90°-bend pipe with curvature $\delta =R/R_c=1/3$, with R being the radius of the cross-section of the pipe and $R_c$ the radius of curvature at the pipe centreline. Direct numerical simulations (DNS) for values of the bulk Reynolds number ${\mathit{Re}}_b=U_{b}D/\nu$ between 2000 and 3000 are performed. The bulk Reynolds number is based on the bulk velocity $U_b$, the pipe diameter D, and the kinematic viscosity $\nu$. The flow is found to be steady for ${\mathit{Re}}_b⩽2500$, with two main pairs of symmetric, counter-rotating vortices in the section of the pipe downstream of the bend. The presence of two recirculation regions is detected inside the bend: one on the outer wall and the other on the inner side. For ${\mathit{Re}}_b⩾2550$, the flow exhibits a periodic behaviour, oscillating with a fundamental non-dimensional frequency $\mathit{St}=\mathit{fD}/U_b=0.23$. A global stability analysis is performed in order to determine the cause of the transition from the steady to the periodic regime. The spectrum of the linearised Navier-Stokes operator reveals a pair of complex conjugate eigenvalues with positive real part, hence the transition is ascribed to a Hopf bifurcation occurring at ${\mathit{Re}}_{b,\mathit{cr}}\approx 2531$, a value much lower than the critical Reynolds number for the flow in a torus with the same curvature. The velocity components of the unstable direct and adjoint eigenmodes are investigated, and they display a large spatial separation, most likely due to the non-normality of the linearised Navier-Stokes operator. Thus, the core of the instability, also known in the literature as the wavemaker, is sought performing an analysis of the structural sensitivity of the unstable eigenmode to spatially localised feedbacks. The region located 15° downstream of the bend inlet, on the outer wall, is the most receptive to this kind of perturbations, and thus corresponds to where the instability originates. Since this region coincides with the outer-wall separation bubble, it is concluded that the instability is linked to the strong shear by the backflow phenomena. The present results are relevant for technical applications where bent pipes are frequently used, and their stability properties have hitherto not been studied.     

Degradation effects of dilute polymer solutions on turbulent drag reduction in pipe flows

An important practical problem in the application and study of drag reduction by polymer additives is the degradation of the polymer, for instance due to intense shearing, especially in recirculatory flow systems. Such degradation leads to a marked loss of the drag-reducing capability of the polymer.Three different polymer types were tested on degradation effects in a closed pipe flow system. The polymers used were Polyox WSR-301, Separan AP-273 and Superfloc A-110, dissolved in water in concentrations of 20 wppm each. The flow system consisted of a 16.3 mm pipe of 4.25 m length. Two different pumps were used: a centrifugal pump and a disc pump. Different solution-preparation procedures were tried and the experiments were performed at different flow rates.Superfloc A-110 proved to be both the most effective drag reducer and most resistant to degradation. Because of very fast degradation, Polyox WSR-301 was found to be unsuitable for being used as a drag reducer in re-circulatory systems. The disc pump proved to be much better suited for pumping the polymer solutions than the centrifugal pump. The degradation curve of the combination Superfloc/disc pump showed a plateau-like region with reasonable drag reduction, which makes it possible to perform (laser Doppler) measurements under nearly constant circumstances during a sufficient time.     

Melnikov方法在输流管混沌运动研究中的应用

对基础简谐运动激励下两端固定输流管道的混沌运动进行了研究，推导出了系统的运动方程，确定了系统存在的平衡点及其稳定性，计算出了未扰系统的同宿轨道，并利用Melnikov方法得到了系统发生混沌运动时参数需满足的临界条件，同时还利用相平面图和：Poincare映射等方法对管道的混沌运动进行了数值模拟，通过比较发现，由Melnikov方法确定的临界参数值要稍小于数值模拟中首次观察到混沌运动时对应的临界值。     

Experimental study on oil–water flow in horizontal and slightly inclined pipes

Oil–water two-phase flow experiments were conducted in a 15 m long, 8.28 cm diameter, inclinable steel pipe using mineral oil (density of 830 kg/m³ and viscosity of 7.5 mPa s) and brine (density of 1060 kg/m³ and viscosity of 0.8 mPa s). Steady-state data on flow patterns, two-phase pressure gradient and holdup were obtained over the entire range of flow rates for pipe inclinations of −5°, −2°, −1.5°, 0°, 1°, 2° and 5°. The characterization of flow patterns and identification of their boundaries was achieved via observation of recorded movies and by analysis of the relative deviation from the homogeneous behavior. A stratified wavy flow pattern with no mixing at the interface was identified in downward and upward flow. Two gamma-ray densitometers allowed for accurate measurement of the absolute in situ volumetric fraction (holdup) of each phase for all flow patterns. Extensive results of holdup and two-phase pressure gradient as a function of the superficial velocities, flow pattern and inclinations are reported. The new experimental data are compared with results of a flow pattern dependent prediction model, which uses the area-averaged steady-state two-fluid model for stratified flow and the homogeneous model for dispersed flow. Prediction accuracies for oil/water holdups and pressure gradients are presented as function of pipe inclination for all flow patterns observed. There is scope for improvement for in particular dual-continuous flow patterns.     

Multiple solutions for the laminar flow in a porous pipe with suction at slowly expanding or contracting wall

In this paper, the asymptotic solution for the similarity equation of the laminar flow in a porous pipe with suction at expanding and contracting wall has been obtained using the singular perturbation method. However, this solution neglects exponentially small terms in the matching process. To take into account these exponentially small terms, a method involving the inclusion of exponentially small terms in a perturbation series was used to find the two solutions analytically. The series involving the exponentially small terms and expansion ratio predicts dual solutions. Furthermore, the result indicates that the expansion ratio has much important influence on the solutions. When the expansion ratio is zero, it is a special case that Terrill has discussed.     

Inverse estimation for unknown fouling geometry on inner wall of forced-convection pipe

A conjugate gradient method (CGM) based on the inverse algorithm is used to estimate the unknown fouling-layer profile on the inner wall of a pipe system using simulated temperature measurements taken within the pipe wall. It is assumed that no prior information is available about the functional form of the unknown profile. Therefore, the procedure is classified as the function estimation in inverse calculation. The temperature data obtained from the direct problem are used to simulate the temperature measurements. The accuracy of the inverse analysis is examined using the simulated exact and inexact temperature measurements. The results show that the excellent estimation of the fouling-layer profile can be obtained for the test case considered in this study. The technique presented in this study can be used in a warning system to call for pipe maintenance when the thickness of fouling exceeds a predefined criterion.     

Experimental study of air–water flow in downward sloping pipes

This paper presents results from seven experimental facilities on the co-current flow of air and water in downward sloping pipes. As a function of the air flow rate, pipe diameter and pipe slope, the required water discharge to prevent air accumulation was determined. In case the water discharge was less than the required water discharge, the air accumulation and additional gas pocket head loss were measured. Results show that volumetric air discharge as small as 0.1% of the water discharge accumulate in a downward sloping section. The experimental data cover all four flow regimes of water-driven air transport: stratified, blow-back, plug and dispersed bubble flow. The analysis of the experimental results shows that different dimensionless numbers characterise certain flow regimes. The pipe Froude number determines the transition from blow-back to plug flow. The gas pocket head loss in the blow-back flow regime follows a pipe Weber number scaling. A numerical model for the prediction of the air discharge as a function of the relevant system parameters is proposed. The novelty of this paper is the presentation of experimental data and a numerical model that cover all flow regimes on air transport by flowing water in downward inclined pipes.     

组合荷载作用下腐蚀缺陷管道的极限承载力

腐蚀缺陷的存在会降低管道的承载力,影响管道的正常运行.考虑了管道轴向与环向材料强度的各向异性,提出了腐蚀缺陷压力管道在内压、轴力和弯矩组合荷载作用下极限承载力的一组广义解.推导了等深度腐蚀、椭圆腐蚀和抛物线三种形状腐蚀缺陷管道的解析解.通过算例验证了解析解与广义解结果具有很好的吻合性.腐蚀形状对极限承载力有显著影响,把...     

Laser produced plasma: A pumping source for cadmium photo-ionization laser

We report laser oscillations in Cd II on 4d ⁹5s ^{2 2} D _5/2 − 4d ¹⁰5p ² P _3/2 transition at 441.6 nm using laser produced tungsten plasma as a pumping source. Mach Zehnder interferometer is used to measure electron density. Design and working of the crossed heat pipe used in the studies is discussed.