Analysis of free and esterified sterols in vegetable oil methyl esters by capillary GC

The introduction of quality standards for vegetable oil methyl esters is gaining in importance due to their increased use as diesel fuel substitutes and as technical products. Free and esterified sterols, the main constituents of the unsaponifiable matter in vegetable oils, are recovered in vegetable oil methyl esters and may influence the technical properties of vegetable oil methyl ester products. A rapid gas chromatographic method for the qualitative and quantitative determination of free and esterified sterols in vegetable oil methyl esters has therefore been developed. The concentration of the free sterols as well as their qualitative and quantitative composition and the concentration of the sterol esters have been determined in rape seed oil methyl ester samples by GC–FID. Prior to analysis, the free sterols were silylated with N,O-bis(trimethylsilyl)trifluoroacetamide with 1% of trimethylchlorosilane; betulinol was used as an internal standard. Calibration was performed by analysis of standard solutions containing β-sitosterol, cholesteryl stearate, and betulinol. The reproducibility of the quantitative results has been evaluated by repeated injections of the same test solution and by repeated complete analysis of the same sample.     

Bia-amperometric quantification of salbutamol in pharmaceutical products

This paper presents a simple, rapid and reproducible method of analysis of salbutamol in pharmaceutical products, utilizing batch injection analysis (BIA) associated with amperometric detection. A study of salbutamol oxidation demonstrated a strong dependence between electrode fouling and pH. All determinations were done utilizing a glassy carbon electrode in presence of 3.0 mol l⁻¹ NaOH. A large linear dynamic range from 8×10⁻⁷ to 2×10⁻⁴ mol l⁻¹ was obtained by using an injected volume of 100 μl with a detection limit of 2.5×10⁻⁷ mol l⁻¹. R.S.D. of 0.92% for 50 successive injections of 4×10⁻⁶ mol l⁻¹ of salbutamol and a sample throughput of 60 samples per hour were achieved. The method was applied for salbutamol quantification in syrups.     

Synthesis and structural revision of naturally occurring ayapin derivatives

The synthesis of three highly oxygenated naturally occurring coumarins, 8-methoxy-6,7-methylenedioxycoumarin, 5-methoxy-6,7-methylenedioxycoumarin and 5,8-dimethoxy-6,7-methylenedioxycoumarin is described for the first time, together with a new method for the preparation of ayapin (6,7-methylenedioxycoumarin). Comparison of the spectroscopic data of the synthetic tetraoxygenated coumarin 5,8-dimethoxy-6,7-methylenedioxycoumarin with literature reports resulted in the structural revision of several natural coumarins. Two coumarins, both identified as 5,8-dimethoxy-6,7-methylenedioxycoumarin must have other structures, while the structure of another coumarin, described as the isomeric 7,8-dimethoxy-5,6-methylenedioxycoumarin has to be revised to 5,8-dimethoxy-6,7-methylenedioxycoumarin.     

Quantitative determination of several mono- and oligosaccarides in food products by means of high-pressure liquid chromatography replacement of the toxic eluent 'acetonitrile/water' by a mixture of harmless solvents

Summary The toxic eluent mixture acetonitrile/water frequently used for separation of mono- and oligosaccarides is replaced by the harmless temary mixture acetone/ethyl acetate/water. By various techniques — degassing of the eluent, parallel connection of two columns and temperature control of the columns, of the eluate and RI-detector — the method is made suitable for the determination of lower saccharide concentrations than usual. Methods for rational preparation of samples — extraction of the saccarides, deionizing of the sample solution — are suggested. Based on examples, the efficiency of the method is demonstrated.     

Determination of iodide by detection of iodine using gas-diffusion flow injection and chemiluminescence

This work describes development of a flow injection (FI) system for determination of iodide, based on the chemiluminescence (CL) reaction between iodine and luminol. Iodide in the sample zone is oxidized to iodine. Employment of a gas-diffusion (GD) unit allows for selective detection of the generated CL (425 nm). Preliminary results showed for concentrations of less than 2 mg L⁻¹, that signals were irreproducible and that the calibration was not linear.In order to solve these problems, a method of ‘membrane conditioning’ was investigated, in which iodide stream was continuously merged with oxidant to generate I₂ that conditioned the GD membrane and tubing. This minimized surface interaction between the active surface and the I₂ generated from the samples, thus improving both precision and sensitivity. By employing membrane conditioning, it has been possible to reliably detect concentrations down to 0.1 mg L⁻¹.At the optimized condition, an excellent linear calibration (r² = 0.999) was obtained from 0.1 to 1.0 mg L⁻¹. The method was successfully applied to determine iodide in some pharmaceutical products such as potassium iodide tablets and a liquid patent medicine. However, for vitamin tablets, ascorbic acid was found to interfere seriously by causing a negative signal.     

Solid-phase ultraviolet absorbance spectrophotometric multisensor for the simultaneous determination of butylated hydroxytoluene and co-existing antioxidants

Continuous flow injection and UV spectrophotometric detection have been proposed for simultaneous determination of the two binary mixtures, butylated hydroxytoluene (BHT)/n-propyl gallate (n-PG) and butylated hydroxytoluene (BHT)/butylated hydroxyanisole (BHA), in food and cosmetics samples. The method is based on the different residence times of each antioxidant when the flow cell is packed to a height of 25 mm with silica C₁₈ using methanol-water 50:50% (v/v) as a carrier with a flow rate of 1.25 and 1.10 ml min⁻¹, respectively. The determination of each antioxidant is based on the measurement of its absorbance at its maximum wavelengths using a DAD detector at 30 and 180 s for the mixture n-PG-BHT and 90 and 220 s for BHA-BHT. Calibration graphs were linear over the range 10.0-300.0 μg ml⁻¹ for each antioxidant in both mixtures. The relative standard deviations were 2.5% for BHT and 2.0% for the co-existing antioxidant. Resolution of the n-PG-BHT mixture in ratios between 1:8 and 8:1 and the BHA-BHT mixture in ratios between 1:10 and 10:1 is possible. The method was applied to the determination of both antioxidants in fat foods and cosmetics samples with recoveries ranging between 101 and 105%.     

Marine Metabolites and Metal Ion Chelation: The Facts and the Fantasies

The marine environment is a seemingly inexhaustible treasury of organisms whose secondary metabolites bear witness to the lavishness and inventiveness with which nature is able to manipulate molecular architecture. But to what purpose are these diverse and often grotesque compounds produced? This review is founded on the premise that some of them may be involved in the uptake and transport of metal ions present in the aquatic milieu. Many metabolites produced by terrestrial organisms are known to act as ionophores, but the case for similar behavior by their marine counterparts is far hazier. Notwithstanding the relative abundance of certain metal ions in the oceans, and of metabolite structures possessing features that should facilitate the chelation of metal ions, few attempts to establish a connection between these two phenomena have been reported. We have whittled down the voluminous literature of natural products derived from marine sources to expose a core of observations and speculations germane to our premise. These facts and fantasies are evaluated in this review. A mere handful of metal-containing complexes has actually been isolated; furthermore, attempts to prepare such complexes in vitro are rare, and spectroscopic evidence for metal–metabolite interactions, whether in vivo or in vitro, is not common. Only with the vanadium-sequestering tunichromes does a logical (but by no means complete) picture begin to emerge. In several other cases, the plausibility of metal chelation, though mooted by authors, remains unsupported by experimental evidence. However, continuing efforts to obtain structural, and particularly conformational, information on the metabolites by means of X-ray crystallography, nuclear magnetic resonance spectroscopy, and molecular mechanics calculations would seem to provide the key to a rational approach to this neglected topic. On the basis of recent studies dealing with such structural aspects, we present a selection of candidate compounds, some of which are the targets of our own synthetic attentions, whose potential for binding to metal cations merits further research.     

SARS-CoV protease inhibitors design using virtual screening method from natural products libraries

Two natural products databases, the marine natural products database (MNPD) and the traditional Chinese medicines database (TCMD), were used to find novel structures of potent SARS-CoV protease inhibitors through virtual screening. Before the procedure, the databases were filtered by Lipinski's ROF and Xu's extension rules. The results were analyzed by statistic methods to eliminate the bias in target-based database screening toward higher molecular weight compounds for enhancing the hit rate. Eighteen lead compounds were recommended by the screening procedure. They were useful for experimental scientists in prioritizing drug candidates and studying the interaction mechanism. The binding mechanism was also analyzed between the best screening compound and the SARS protein.     

Synthesis of the marine furanoditerpene (−)-marginatone

A synthesis of the marine labdane furanoditerpene (−)-marginatone 1 has been accomplished by a short sequence of reactions starting from (+)-coronarin E 5. The key step is the stereocontrolled-intramolecular electrophilic cyclisation of the (+)-dihydrocoronarin E 6, to the tetracyclic marginatane skeleton 7, which is subsequently functionalized by allylic oxidation to give 1. As (+)-coronarin E 5 was previously synthesized from (−)-sclareol 10, the herein reported preparation constitutes the first formal total synthesis of (−)-marginatone 1, by which its absolute configuration has been confirmed.