Comparison of two models for managing reliability growth during product design

Relying on reliability growth testing to improve system designis neither usually effective nor efficient. Instead it is importantto design in reliability. This requires models to estimate reliabilitygrowth in the design that can be used to assess whether goalreliability will be achieved within the target timescale forthe design process. Many models have been developed for analysisof reliability growth on test, but there has been much lessattention given to reliability growth in design. This paperdescribes and compares two models: one motivated by the practicalengineering process; the other by extending the reasoning ofstatistical reliability growth modelling. Both models are referencedin the recently revised edition of international standard IEC61164. However, there has been no reported evaluation of theirproperties. Therefore, this paper explores the commonalitiesand differences between these models through an assessment oftheir logic and their application to an industrial example.Recommendations are given for the use of reliability growthmodels to aid management of the design process and to informproduct development.     

Laser-induced damage of Ta2O5/SiO2 narrow-band interference filters under different 1064 nm Nd:YAG laser modes

The laser-induced damage (LID) behavior of narrow-band interference filters was investigated with a Nd:YAG laser at 1064 nm under single-pulse mode and free-running mode. The absorption measurement of such coatings was performed with surface thermal lensing (STL) technique. The damage morphologies under the two different laser modes were also studied in detail. It was found that all the filters exhibited a pass-band-center-dependent absorption and laser-induced damage threshold (LIDT) behavior, but the damage morphologies were diverse. The explanation was given with the analysis of the electric field distribution and the operational behavior of the irradiation laser.     

串联双环光微谐振器的滤波特性

详细研究了串联双环光微谐振器的光带通滤波特性，给出了其通带带宽的公式，分析了出／入环光耦合系数和环间光耦合系数对通带特性的影响，计算并特别强调了滤波通带的结构特点，也分析了微环中存在的光损耗对串联双环光微谐振器的滤波特性的影响。     

基于进化人工神经网络的组合系统滤波技术

在组合系统运用Kalman滤波器技术时,准确的系统模型和可靠的观测数据是保证其性能的重要因素,否则将大大降低Kalman滤波器的估计精度,甚至导致滤波器发散.为解决上述Kalman应用中的实际问题,提出了一种新颖的基于进化人工神经网络技术的自适应Kalman滤波器.仿真试验表明该算法可以在系统模型不准确时、甚至外部观测数据短暂中断时,仍能保证Kalman滤波器的性能.     

Oracle Inequalities for Efromovich–Pinsker Blockwise Estimates

Oracle inequality is a relatively new statistical tool for the analysis of nonparametric adaptive estimates. Oracle is a good pseudo-estimate that is based on both data and an underlying estimated curve. An oracle inequality shows how well an adaptive estimator mimics the oracle for a particular underlying curve. The most advanced oracle inequalities have been recently obtained by Cavalier and Tsybakov (2001) for Stein type blockwise estimates used in filtering a signal from a stationary white Gaussian process. The authors also conjecture that a similar result can be obtained for Efromovich–Pinsker (EP) type blockwise estimators where their approach, based on Stein's formula for risk calculation, does not work. This article proves the conjecture and extends it upon more general models which include not stationary and dependent processes. Other possible extensions, a discussion of practical implications and a numerical study are also presented.     

成分和厚度的依赖

通过调整Mn的成分，系统地研究了Ni81Fe19/Ni100-xMnx双层膜的磁学性质，特别是交换偏置场(Hex)的变化.当Ni100-xMnx中Mn的原子百分比在534%到600%之间时，对于150nm的Ni81Fe19，得到了最大的交换偏置场175kA/m，同时由于Mn对Ni81Fe19层的扩散所造成的磁矩的降低小于20%；高角x射线衍射证明Ni100-xMnx的晶格常数随着Mn成分的改变而变化，Mn含量越多，其晶格常数越大；制备态Ni100-xMnx膜晶格常数与θ相NiMn膜晶格常数的接近程度与NiMn膜θ相形成的容易程度相对应.也研究了交换偏置场随着Ni１００-xMnx厚度的变化，第一次得到了当Ni100-xMnx中Mn的原子百分比为706%时，Ni81Fe19(150nm)/Ni100-xMnx(90nm)双层膜在经过240℃，5h退火后，可以有80kA/m的交换偏置场，此时铁磁层磁矩的大小几乎不变. 关键词： Ni81Fe19/Ni100-xMnx 交换偏置场     

滤波器对偏振模色散的补偿

根据耦合非线性薛定谔方程 ,本文研究了偏振模色散如何影响各种码型的频谱 ,分析了滑频滤波器和固定滤波器对偏振模色散的补偿作用。研究结果表明 :偏振模色散对不同码型的频谱影响是不一样的 ,对色散管理孤子的频谱影响最大 ,产生新的频率分量也最多 ,而且每个新频率分量都较强 ,比入射频谱展宽许多 ;滑频滤波器和固定滤波器对偏振模色散都具有补偿作用 ,使最大可传输距离成倍增加 ,两种滤波器对偏振模色散的补偿作用相差较小 ;但是对色散管理孤子系统中的偏振模色散补偿效果最佳。     

Reduction of Entrained Hydroxy Species in Ormosil Films for Integrated Optics

Organically modified silicates (ormosils) have been viewed as possible materials for optical signal processing devices for communications networks. One significant problem obstructing their use in this application is the absorption of infrared light by hydroxy species (present for example in silanol groups (SiOH) and water) around the communications wavelengths (1310 and 1550 nm). We have investigated several ormosil compositions, synthesised via an aqueous sol-gel method, to determine if residual hydroxy groups can be removed more effectively via reducing the connectivity of the material by increasing the number of organic groups (such as Si—CH₃). Furthermore, we have investigated the effect of different inert atmospheres on the drying process. It was found that reducing the connectivity does promote the removal of hydroxy absorption, mainly via the condensation of residual silanol groups, but also by removal of residual water, depending on the other precursors in the system. It was also found that the drying atmosphere used (nitrogen or helium) had no effect on the drying process.     

Preparation and characterization of finely dispersed drugs. 5. Ethyl 3,5-di(acetylamino)-2,4,6-triiodobenzoate

Controlled precipitation of the diagnostic imaging agent ethyl 3,5-di(acetylamino)-2,4,6-triiodobenzoate has been used to produce fine particles of various sizes, morphologies, and degrees of crystallinity, which depended on experimental conditions. In addition, two distinct polymorphic forms of the drug have been fully characterized by single crystal X-ray diffraction studies, and evidence for a third polymorph was also observed. Some of the so prepared dry particles were coated with a thin layer of silica.