人体静电放电对有机发光二极管的影响

研究了静电放电（ESD）人体模式（HBM）下的脉冲应力对有机发光二极管（OLED）的性能及寿命的影响,并讨论了相应的物理机制。对比分析了4组OLED在施加ESD放电为0,200,800,1 600 V前后的电学和光学特性,并进行了相应的寿命测试分析。研究发现,OLED器件的光谱对ESD不敏感,随着冲击电压的增大,由于静电打击对载流子的短期抑制效应,OLED的亮度出现轻微下降。在静电冲击电压为200 V和800 V时,伏安特性没有发生变化;当静电冲击电压增至1 600 V时,反向漏电有明显增加。后续的加速寿命实验表明,静电打击对器件的工作寿命没有明显的规律性影响,但是会一定程度提高非本质老化失效的概率。     

金属UV光敏薄膜的实验研究

介绍了金属Au和Al薄膜的制备方法，研究了其UV光电发射特性，并做了寿命实验。给出了在真空中以及放在大气中光电发射衰减的情况。指出了其在大气中达到一个稳定值之后，再反复多次暴露于干燥大气时仍存在一个稳定光电发射周期的特点，可长达数月。金属薄膜有一个最佳膜层厚度，这与光电发射逸出深度、膜层结构等密切相关。近年来光电子成像器件发展非常迅速，急需光电发射均匀的面电子源，因此在微通道板的特性测试和像管的动态模拟中，Au和Al金属薄膜成为被优选的对象。     

基于薄膜电极溶胶修饰的染料敏化太阳电池光电特性研究

染料敏化太阳电池(DSC)中的纳米薄膜电极 是决定太阳电池光电转换性能的重要组成部分. 为改善薄膜电极特性, 采用了不同浓度的TiO₂溶胶对DSC光阳极导电玻 璃和纳米TiO₂多孔薄膜进行不同方式的界面处理. 利用X射线衍射方法对制备得到的多孔薄膜以及溶胶经高温处理 后致密层中纳米TiO₂颗粒的尺寸及晶型进行了测试. 采用高分辨透射电子显微镜和场发射扫描电子 显微镜观察了纳米颗粒及薄膜微结构形貌. 采用强度调制光电流谱/光电压谱分析了TiO₂溶 胶的不同处理方式对电子传输和复合的影响. 在100 mW· cm^-2光强以及暗环境下分别测试了DSC的伏安输出性能以及暗电流. 结果表明, 不同浓度和处理方式均能较好地抑制暗电流. 溶胶处理后光生电子寿命τ_n延长, 电子传输平均时间τ_d相应缩短. 采用浓度为0.10 mol·L^-1的 溶胶对导电玻璃和多孔膜同时处理, DSC的宏观输出特性最佳, 短路电流密度J_sc提高了10.9%, 光电转换效率η提高了11.9%.     

MgxZn1-xO薄膜的生长及其光学性能

利用金属有机化学气相沉积(MOCVD)法在蓝宝石(1120)衬底上生长高质量的Mg_xZn_1-xO合金薄膜,实验研究了各种不同Mg组分对样品光学性能的影响。通过光致发光荧光衰减特性对激子发光寿命的研究表明,激子的寿命随Mg组分的增加而增加,当Mg组分达到50%时,激子的寿命为872 ps。     

Quantitative Time-Resolved Fluorescence Spectrum of the Cortical Sarcoma and the Adjacent Normal Tissue

The difference in time-resolved fluorescence spectrum between the cortical sarcoma and the adjacent normal tissue was studied in both experimental and theoretical ways. The Clinical data were obtained in vivo using a time-resolved fluorescence spectrometer employing a single fiber-optic probe for excitation and detection. Tissue was modeled as s-180 sarcoma tumor surrounded with normal muscle and was mediated by the Palladium-porphyrin photosensitizer (Pd-TCPP). The emitted fluorescence was considered as arising from the tumor tissue or the normal muscle, due to the presence of the photosensitizer. A computational code which could simulating time-resolved fluorescence emission was presented and applied to comparing fluorescence decay of photosensitizer in different stages of tumor growth. In this code the different stages of the tumor was modeled through changing the time τ, the delay of the fluorescence photon emission and z _max, the thickness of the tumor. It was found in the in vivo experiment that the fluorescence from tumor tissue decayed more quickly than from the adjacent normal muscle. For the ten rats in the first experiment day, the mean decay constant of tumor T _s and normal tissue T _n were 554 and 526 μs, respectively. And T _s increased with the tumor growth, from 554 μs in the first day to 634 μs in the eighth day while T _s kept steady. It was believed that the more adequate oxygen supplied by the normal tissue can more effectively quench the fluorescence and in the normal tissue the photosensitizer lifetime is smaller. As a result the simulated time-resolved fluorescence spectrum of normal tissue showed more quickly decay. And the thickness of the tumor can also delay the fluorescence decay. Both the experimental and simulated results indicated that the germination of the tumor would increase the decay constant of the time-resolved fluorescence spectrum. So decay constant of the tumor tissue spectrum should be larger than that of adjacent normal tissue for the reason of hypoxia and overgrouth. This fact could be of use in the tumor diagnoses.     

Charge carrier decay and diffusion in organic–inorganic CH3NH3PbI3–xClx perovskite based solar cell

In recent years, organic–inorganic lead halides attracted widespread interest, mainly due to their impressive photoconversion properties and low‐cost solution processing. In this study, we employed small amplitude transient photovoltage and photocurrent spectroscopy to investigate charge transport and recombination properties of perovskite CH₃NH₃PbI_3–xCl_x solar cell under realistic light harvesting conditions (<1 sun). Cell structure resembles outlay commonly found in organic photovoltaics, with perovskite absorber being sandwiched between two thin layers of organic polymers. Tested device displayed high power conversion efficiency (10.3%), good fill factor and negligible hysteresis effect. Fundamental device parameters were characterized at various open‐circuit voltages (V_oc) by examination of small voltage and current perturbations created by the low intensity pulsed laser excitations. The obtained results exhibit long charge carrier lifetimes and fast charge transport over the full range of applied optical bias, as well as remarkable diffusion lengths exceeding 1 μm. (© 2015 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

A combined transient and steady state approach for robust lifetime spectroscopy with micrometer resolution

We present the combination of two complementary micro‐photoluminescence spectroscopic techniques operating in transient and steady state condition, respectively. Introducing the time domain into the well‐established micro‐photoluminescence mapping approach operating under steady state conditions demonstrates a distinct improvement of the robustness and reliability in the determination of charge carrier lifetime measured with micrometer spatial resolution. Lifetimes from 50 ns to above ms are accessible. We elaborate a calibration procedure and apply the combined all‐photoluminescence setup to high‐performance multicrystalline silicon. A lifetime image obtained from the established photoluminescence imaging technique is reconstructed from the microscopic map by considering lateral diffusion and optical blurring, revealing a more detrimental influence of small angle grain boundaries as well as a higher lifetime within grains as may be deduced from the standard imaging technique. (© 2015 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

Investigation of a Photochromic Diarylethene with Electron-acceptor Attached

In this contribution, an electron acceptor attached diarylethene derivative was synthesized and fully characterized. The photochromic behavior was investigated in THF. Under exposure of UV and visible light cycles, the solution color can be switched between colorless and yellow smoothly. Fatigue resistance measurements could be repeated 50 times with an acceptable degradation. Due to the electron acceptor attached to the framework of diarylethene, the photo- and thermal-stability were enhanced both. A full-photo mode switch can be established based on the well-defined states by external excitation. The molecular structures of ring-open and ring-closed form were optimized by Dmol³. The distance between photocyclizing atoms in aptiparallel conformation meets the requirement for photochromic reaction. And the calculated absorption wavelengths were also in agreement with the experimental values.     

Interphases in Polymer Solid-Contacts and Nanocomposites Probed by Positron Annihilation Lifetime Spectroscopy

At polymer-solid contacts with thermoplastic polymers, the chain characteristics can deviate from the bulk on a length-scale of several nanometer in the so-called interphase. Such an interphase depends on the interaction between respective macromolecule and substrate, and affects the free volume in the polymer. Here, we review our experiments on the characterization of the free volume by positron lifetime spectroscopy at planar and curved interfaces. For Teflon AF on silicon, we identify a layer of increased density, corresponding to an interphase width of some 10 nm. PEP based nanocomposites with functionalized silica show no interphase, whereas for functionalized POSS an interphase is detected.