Catalytic wet air oxidation of oleic acid on ceria-supported platinum catalyst.effect of pH

Summary Catalytic wet air oxidation (CWAO) of oleic acid was carried out in a batch reactor on platinum supported ceria catalyst (Pt/CeO₂). Oleic acid is a water insoluble linear unsaturated fatty acid of 18 carbon atoms. To increase the homogeneity of the solution by saponification, the influence of NaOH additions in oleic acid CWAO mechanism and catalyst performances have been investigated. The oxidation of such molecule occurs by two types of mechanisms: successive carboxy-decarboxylation which leads essentially to CO₂and/or C-C bonds splitting in the alkyl chain inducing a high formation of acetic acid. With or without NaOH, the 5%Pt/CeO₂catalyst is active in the conversion of oleic acid and selective to carbon dioxide. In alkaline medium, oleic acid is initially saponified which increases the solubility of the reactant before it to be oxidized. Finally the oxidation is slightly delayed by the presence of NaOH. The catalyst characterizations show no significant difference before and after reaction.</o:p>     

Black fungus derived aerogel with double faced properties

Black fungus aerogel (BFA) exhibited interesting double-faced properties. Weexplored the diverse properties of each side of the black fungus in three aspects:water contact angle measurements, liquid selective absorption capacity and air pollutant adsorption abilities.     

活性炭纤维电极电解法处理墨绿B染料废水

将铁丝缠绕在活性炭纤维(简称ACF)上制成电极,并在阴极鼓入空气,用电解生成的Fenton试剂处理墨绿B染料模拟废水.研究了电压、pH值、温度、空气流量、支持电解质的浓度等因素对染料脱色率的影响.结果表明,pH值越低,温度越高,处理效果越好,气流量的改变对于处理效果影响不大.室温时处理浓度为50mg·L-1的活性染料墨绿B,在实验电压为11V,中性条件下,无水硫酸钠的浓度为20g·L-1,通入空气流量为60L·min-1时,处理60min,色度去除率达到95%左右.55℃时,电解30min色度去除率就达到96%,60min时达到100%.     

Electron beam forming system for irradiation of large diameter cylindrical products

The report describes electron beam electromagnetic forming system, which is destined for irradiation of cylindrical long goods, specifically for PE tubes 160 mm diameter. System consists of electromagnet, power supply units, beam distributions control units, etc. for use at an electron accelerator at 5 MeV and 50 kW. The particular geometry of the magnet poles and their mutual arrangement are creating an irradiation field that allows the electrons to irradiate the surface of the product close to 90°.     

Synthesis of anodic silicon oxide films in water-organic solutions containing orthophosphoric acid

Variations in electrophysical properties of anodic silicon oxide at the surface of semiconductor silicon are studied as a function of the composition of electrolytic solutions containing orthophosphoric acid and the conditions of reaching the final formation potential. The optimum conditions for the formation of anodic SiO₂ coatings that include phosphorus-containing admixtures are determined, the coatings being intended for application as diffusates in nanoelectronics.     

Determination of arsenic in sediments, coal and fly ash slurries after ultrasonic treatment by hydride generation atomic absorption spectrometry and trapping in an iridium-treated graphite tube

A simple and reliable method for the determination of arsenic in sediment and in coal without sample digestion, based on hydride generation from slurry samples is proposed. After grinding the samples to a particle size of 50 μm, the sample powder was mixed with aqua regia and hydrofluoric acid in an ultrasonic bath for 30 min. After diluting the mixture with hydrochloric acid, the slurry was allowed to stand for 48 h, and an aliquot was used for hydride generation with sodium borohydride. More than 80% of the arsenic was leached to the aqueous phase under these conditions, except for one sediment sample with very high silica content. The generated arsine was collected in a graphite tube, treated with 0.5 mg of iridium as a permanent modifier, and the arsenic determination was carried out by electrothermal atomic absorption spectrometry. The same tube could be used for at least 160 cycles without any re-treatment. The greatest advantage of the method was that only a minimum of reagents and sample handling were required, reducing the risks of contamination and/or analyte loss. However, the addition calibration technique had to be used in order to obtain results within the 95% confidence level for 11 certified reference materials, 5 sediments, 5 coals and one coal fly ash. One certified sediment slurry was spiked with the analyte and the resulting addition calibration curve was used for the analysis of the certified sediments. Similarly, one certified coal was used to obtain the addition calibration curve for the coal and coal fly ash samples. The recoveries of the certified values, except for one sediment, were between 91 and 115%. The limits of detection in the samples were 0.54 and 0.7 μg g⁻¹ for the coal and sediment samples, respectively, obtained for 1 ml of slurry containing 1 mg of sample.     

Sorption of spruce O-acetylated galactoglucomannans onto different pulp fibres

Sorption of spruce acetylated galactoglucomannans (GGM) onto different pulps, among which unbleached and peroxide-bleached mechanical pulps, and unbleached and bleached kraft (BK) pulps, was studied as a means of understanding the retention of acetylated GGMs in mechanical pulping and papermaking. The fibre surface coverage of lignin and carbohydrates was estimated by X-ray photoelectron spectroscopy (XPS) or electron spectroscopy for chemical analysis (ESCA). GGM sorption was clearly favoured on kraft pulps. Hardly any differences in sorption were, however, observed between unbleached and BK pulps, even if the surface coverage of lignin was lower on the bleached pulp. Neither thermomechanical pulp (TMP) nor chemithermomechanical pulp (CTMP) manufactured from spruce sorbed any acetylated GGMs. Peroxide bleaching of the pulp did not increase sorption. Only CTMP produced from aspen sorbed some GGMs. The anionic charge of neither chemical nor mechanical pulps influenced GGM sorption.     

Surface patterns of block copolymers in thin layers after vapor treatment

A systematic study of formation of surface patterns in block copolymer thin layers after their exposure to solvent vapors was performed. The studied effect involves layers of thickness approximately equal to the ordering size of polymers - about 45 nm. Experiments were performed on three styrene - methacrylate derivative block copolymers, synthesized by living anionic polymerization: poly(4-octylstyrene)-block-poly(butyl methacrylate), poly(4-fluorostyrene)-block-poly(butyl methacrylate) and poly(p-octylstyrene)-block-poly(methyl methacrylate). The polymers were exposed to vapors of chloroform, 1,4-dioxane, hexane, acetone and tetrahydrofuran.     

Treatment of dairy wastewater using a selected bacterial isolate, Alcaligenes sp. MMRR7

Physicochemical and biologic analysis of dairy wastewater showed that the effluent had a high organic load (chemical oxygen demand [COD]: 5095 mg/L), an acidic pH (6.4), and a high probability of coliforms (most probable number [MPN]>1100). The various bacterial strains isolated and purified were identified as Sporolactobacillus sp., Citrobacter sp., Pseudomonas sp., Alcaligenes sp., Bacillus sp., Staphylococcus sp., and Proteus sp., as per the Bergey’s manual of systematic bacteriology. Among the five selected bacterial strains, the strain designated as MMRR₇ and identified as Alcaligenes sp. was found to give a maximum reduction in COD (62%) in 5 d of incubation. Chemical coagulation using alum at a concentration of 0.5 g/100 mL was found to be effective in the primary treatment of the effluent. Studies on free-cell treatment of the coagulated effluent with the selected bacterial strain Alcaligenes sp. MMRR₇ gave a maximum COD reduction of 91% in 120 h. This study clearly indicates the possibility of using Alcaligenes sp. MMRR₇ for the effective treatment of dairy wastewater.     

基于荧光效应的小分子抗癌药物释放体系研究进展

近年来,随着癌症发病率的不断升高,癌症治疗技术的更新和发展显得尤为重要,特别是化学疗法(Chemotherapy)的提出促进了荧光小分子抗癌药物释放体系的研究。 将具有荧光效应的有机小分子与抗癌药物结合在一起,使得药物释放体系表现出低毒性、优异的癌细胞靶向性和方便药物跟踪监测等特点。 因此,设计不同性能的前药可以研究抗癌药物释放的动力学过程,为实现癌症的精准治疗提供有力的工具。 本文主要介绍了基于喜树碱、SN-38和阿霉素等前药的研究进展,并对其发展前景作了展望。