碰撞角对爆炸复合材料界面状态的影响

复合材料界面状态是衡量复合质量优劣的主要评定因素之一,焊接参数和界面状态之间存在着紧密的联系。为了获得理想的复合质量,必须正确选择爆炸焊接参数。本文在实验的基础上,通过理论研究和数值计算,探讨了爆炸复合的力学模型及物理机制,验证了碰撞角对再入射流的质量(或再入射流的厚度)和爆炸复合材料界面状态存在的影响,得出了波形的变化趋势与碰撞角的变化趋势相一致的结论,同时确立了波形参数和碰撞角的半定量表达式,拓展和深化了爆炸复合的研究领域,丰富和发展了爆炸复合的成波机理,从而能够更好地指导工程应用,减少工程损耗,提高复合质量和工作效率。     

MB2镁等四种金属材料的本构关系和动态断裂研究

采用炸药爆轰－分离飞片加载装置与电容传感技术相结合，由高速示波器连续记录靶板自由面速度剖面，通过波剖面的时间分辨测量，研究了ＭＢ＿２镁、ＬＹ－１２铝、钨合金、２１６９钢四种金属材料的动力学响应特性，给出了这几种材料在弹性－理想塑性模型假设下的本构关系，还给出了它们的动态断裂强度，并对标准化层裂强度与破坏比功、屈服强度之间的相关性进行了分析和讨论。     

炸药驱动强电流短路开关的研

由于电磁轨道炮和其它强电流装置中短路运行的需要,研制了一种条形炸药驱动的大电流闭合开关。利用爆炸成型技术使金属飞板负电极在炸药部件作用下,大面积地同时切断绝缘薄膜,嵌入另一电极模槽中构成牢固的接触。开关的绝缘强度大于30kV,电感(包括传输线)小于50nH,最大峰值电流达到400kA,闭合接触电阻小于0.1m,动作时间约为14us。对于开关的爆轰,撞击及变形过程进行了一维和二维数值模拟计算,并提出了一个描述爆炸开关行为的经验模型。利用这个模型进行电磁轨道炮整个系统的数值模拟,同实验结果符合较好。     

Overwinter changes to near-surface bulk density, penetration resistance and infiltration rates in compacted soil

Previous studies at Yakima Training Center (YTC), in Washington State, suggest freeze-thaw (FT) cycles can ameliorate soil compacted by tracked military vehicles [J. Terramechanics 38 (2001) 133]. However, we know little about the short-term effects of soil freezing over a single winter. We measured bulk density (BD), soil penetration resistance (SPR), and steady-state runoff rates in soil newly tracked by an Abrams tank and in uncompacted soil, before and after a single winter at YTC. We similarly measured BD, SPR and saturated hydraulic conductivity (k_fs) in simulated tank tracks at another site near Lind Washington. Average BD was significantly greater in tank ruts at YTC and in simulated tracks at the Lind site than in uncompacted soil soon after tracking and did not change significantly during the winter of 1997–1998. Measurements of SPR were strongly influenced by soil moisture. When soil was moist or tracks were newly formed, SPR was significantly higher in tank ruts than in uncompacted soil from the surface to a depth of about 10–15 cm. The greatest average SPR in compacted soil was observed between 4 and 6 cm depth. We observed less difference in SPR between tank ruts and uncompacted soil near-surface at YTC as the time after trafficking increased. We observed highest SPR ratios (compacted rut:undisturbed) in fresh tracks near the surface, with lower ratios associated with increasing track age or soil depth, indicating that some recovery had occurred at YTC near-surface. However, we did not observe a similar over-winter change in SPR profiles at the Lind site. Rainfall simulator data from YTC showed higher steady-state runoff rates in tank ruts than over uncompacted soil both before and after winter. However, more time was required to reach steady-state flow in tank ruts and the proportion of runoff was slightly lower in May 1998 than in August 1997. At the Lind site, k_fs was lower in newly compacted soil than in one-year old compacted soil or uncompacted soil. Our data suggest that indices of water infiltration such as steady-state runoff rates or k_fs, are more sensitive indicators of soil recovery after compaction than are BD or SPR.     

ε-CL-20/F_(2311) PBXs力学性能和结合能的分子动力学模拟

本文应用分子动力学(MD)模拟方法,研究高能量密度化合物六硝基六氮杂异伍兹烷(ε-CL-20)与常用高聚物粘结剂F2311所构成的CL-20/F2311高聚物粘结炸药(PBXs)的力学性能和结合能随温度和高聚物浓度而变化的规律.结果表明,添加高聚物于主体炸药中,使其弹性模量减小,表明刚性减小,弹性增大,机械力学性能大为改善;在一定范围内,随高聚物F2311在PBXs中浓度的增加,体系结合能从正值变为负值,而随温度升高,体系的结合能变化不是很明显.     

Electrochemical detection of ultratrace nitroaromatic explosives using ordered mesoporous carbon

A sensitive electrochemical sensor has been fabricated to detect ultratrace nitroaromatic explosives using ordered mesoporus carbon (OMC). OMC was synthesized and characterized by scanning electron microscopy, transmission electron microscopy and nitrogen adsorption/desorption measurements. Glassy carbon electrodes functionalized with OMC show high sensitivity of 62.7 μA cm⁻² per ppb towards 2,4,6-trinitrotoluene (TNT). By comparison with other materials such as carbon nanotubes and ordered mesoporous silica, it is found that the high performance of OMC toward sensing TNT is attributed to its large specific surface area and fast electron transfer capability. As low as 0.2 ppb TNT, 1 ppb 2,4-dinitrotoluene and 1 ppb 1,3-dinitrobenzene can be detected on OMC based electrodes. This work renders new opportunities to detect ultratrace explosives for applications of environment protections and home securities against chemical warfare agents.     

波后慢放能过程对钝感炸药爆轰过程的影响

采用唯象反应率模型与慢放能函数相结合方法,研究钝感炸药波后缓慢放能过程对爆轰过程的影响,计算结果与实验对比分析表明,慢放能反应率模型可更好地描述钝感炸药的爆轰物理过程.     

爆炸复合1Cr13Mo/45钢连铸辊工艺

鉴于目前连铸辊制造工艺存在的不足,以爆炸复合法制造1Cr13Mo/45钢复合轧辊,并以爆炸复合工艺为研究对象,采用超声波探伤和金相观察等方法,研究药厚和间隙大小对复合界面波形的影响.结果表明:药厚一定的情况下,间隙对复合轧辊界面波形的影响较大;而在间隙一定的情况下,药厚对复合轧辊界面波形的影响不明显.通过实验,获得了该...     

层内爆炸压裂岩石破碎颗粒尺寸的预测模型

借鉴爆破工程经验,结合层内爆炸压裂实际,应用能量守恒原理,将液体炸药爆炸形成的冲击波能 量分为岩石破碎的表面能和岩石内部的应变能,结合岩石断裂理论建立了粉碎区内岩石破碎粒径的预测模 型。实例计算层内爆炸压裂形成的岩石颗粒直径为1.43mm。计算结果表明:液体炸药层内爆炸后形成的 岩石破碎颗粒与石油工业中水力压裂使用的支撑剂粒径相当,能够支撑形成具有一定导流能力的裂缝。     

基于改进HHT的水中爆炸冲击波信号时频特性分析方法

根据水中爆炸冲击波信号的特征,利用希尔伯特-黄变换(HHT)处理非平稳信号的优势,提出了一种结合小波分解及相关系数筛选的改进HHT方法.该方法首先通过小波分解将信号分为高频部分和低频部分,然后利用相关系数对固有模态函数(IMF)分量进行筛选.理论与实践表明,改进的HHT方法能够有效、准确地对水中爆炸冲击波信号的时频信息...