基于包层模谐振的三包层石英特种光纤温度传感特性研究

提出了一种基于包层模谐振的光纤温度传感器. 它是通过将三包层石英特种光纤(TCQSF)两端分别与普通单模光纤(SMF)电弧熔接构成的SMF-TCQSF-SMF结构. 根据耦合模理论, 首先将TCQSF等效为三个同轴波导, 按各波导模场的分布特点标量计算其传输模式的色散曲线, 并深入研究其耦合长度与传输谱线之间的关系; 其次根据光纤的热光效应及热膨胀效应, 分析计算该传感器的温度灵敏度; 最后选取耦合长度为一个拍长时的传感器进行温度传感实验. 实验结果表明, 在35-95 ℃的温度变化范围内, 其温度灵敏度为73.74 pm/℃, 与理论计算结果一致. 因此, 该传感器具有结构简单、制备容易、灵敏度高、包层模激发可控等优点, 可用于工业生产、生物医学等温度传感领域.     

基于(火积)理论的“+”形高导热构形通道实验研究

基于构形理论和■理论,对"+"形高导热通道的方形构造体开展导热实验研究,并对不同优化目标和不同高导热通道布置形式下的构造体导热性能进行比较.结果表明:对于"+"形高导热通道的方形构造体,实验和数值计算所得到的构造体最高温度点均位于"+"形高导热通道两分支之间,实验和数值计算所得到的构造体平均温差和■耗散率的误差均在可接受范围内,这从定性和定量的角度证明了导热构形优化结果的正确性.与"H"形高导热通道的方形构造体相比,构造体内高导热通道采用一级"+"形布置使得其导热■耗散率得到降低.■耗散率最小的一级"+"形高导热通道构造体最优构形与最大温差最小的构造体最优构形相比,前者的导热■耗散率降低了5.98%,但最大温差提高了3.57%.最大温差最小目标有助于提高构造体的热安全性,■耗散率最小目标有助于提高构造体的整体导热性能.在保证热安全性能的前提下,实际微电子器件设计中可采用■耗散率最小的构造体最优构形以提高其整体导热性能.     

爆轰波对碰驱动平面锡飞层的动力学及动载行为特征研究

强冲击下的物质变形、破坏及诱发的轻重介质混合问题,是内爆压缩科学和工程应用领域的研究重点.本文针对爆轰波对碰条件下的复杂加载动力学过程及其动载破坏形态特征,开展数值模拟研究与极曲线理论分析.设计了爆轰波对碰驱动平面锡飞层的计算模型,获得了爆轰加载动力学过程及波系相互作用物理图像,分析了锡飞层对碰区自由表面速度历史的典型特征.给出了锡飞层中折射激波对碰发生马赫反射的临界条件,解读了三波结构的传播行为,阐明了对碰区内存在"一维正冲击"区域,一维区外存在单次斜冲击向两次斜冲击过渡的复杂加载动力学过程,提出了对碰区冲击动力学模型,揭示了影响对碰区动载行为特征的机理.数值模拟结果与极曲线理论分析结果相互印证,符合较好.本文的研究成果,将为深入理解和解读对碰区特殊的物质破坏及混合现象提供重要的理论支撑.     

富勒烯C20四聚体的结构与性能研究

采用密度泛函理论(DFT)中的杂化密度泛函(B3LYP)方法, 在6-31 G基组水平上对C₂₀四聚体进行了几何参数全优化, 得到了基态构型, 并对其稳定性、电子结构、极化率和芳香性进行了计算研究. 结果表明: C₂₀碳笼以[2+2]加成方式结合形成C₂₀四聚体, 具有良好的热力学稳定性; C原子内部以sp²的方式杂化, C原子之间有少量电荷转移; C₂₀ 四聚体的IR和Raman光谱都有较多的振动峰; 随碳笼数的增加, C₂₀聚合物中原子间的成键相互作用随之增强; C₂₀四聚体具有芳香性.     

(CH3)2和(NH2)2基团修饰的齐聚苯乙炔分子电子输运性质研究

采用密度泛函理论和非平衡格林函数相结合的方法研究了S原子作为单、双端基的(CH₃)₂-OPE (齐聚苯乙炔)和(NH₂)₂-OPE分子在金电极间的电子输运性质. 通过第一性原理优化计算获得分子部分稳定结构, 再置于Au电极之间构成两极系统, 然后再优化整个两极系统获得稳定结构. 另外, 通过非平衡格林函数方法计算了两极系统的电子输运性质. 计算结果表明, 不同的修饰基团和桥接方式可以导致两极系统的开关效应、负微分电阻行为和整流行为等不同的电子输运性质. 通过计算不同偏压下的分子体系投影轨道电子分布、透射谱、态密度, 对这些新异的电输运性质出现的机理进行了解释.     

Microstructural properties and local atomic structures of cobalt oxide nanoparticles synthesised by mechanical ball-milling process

In this study, facile preparation of pure and nano-sized cobalt oxides particles was achieved using low-cost mechanical ball-milling synthesis route. Microstructural and morphological properties of synthesised products were characterised by X-ray diffraction (XRD) and transmission electron microscopy (TEM) techniques. XRD results indicated that the fabricated samples composed of cubic pure phase CoO and Co₃O₄ nanocrystalline particles with an average crystallite size of 37.2 and 31.8 nm, respectively. TEM images showed that the resulting samples consisted of agglomerates of particles with average diameter of about 37.6 nm for CoO and 31.9 nm for Co₃O₄. Phase purity of the prepared samples was further investigated due to their promising technological applications. Local atomic structure properties of the prepared nanoparticles were probed using synchrotron radiation-based X-ray absorption spectroscopy (XAS) including X-ray absorption near-edge structure (XANES) and extended X-ray absorption fine structure (EXAFS). EXAFS data analysis further confirmed the formation of single-phase CoO and Co₃O₄ nanoparticles. In addition, structural properties of cobalt oxide nanoparticles were investigated by performing density functional theory calculations at B3LYP/TZVP level and Born–Oppenheimer molecular dynamics. Theoretical calculations for both prepared samples were found to be consistent with the experimental results derived from EXAFS analysis. Obtained results herein reveals that highly crystalline and pure phase CoO and Co₃O₄ nanoparticles can be synthesised using simple, inexpensive and eco-friendly ball-milling method for renewable energy applications involving fuel cells and water splitting devices.     

Spin‐polarized electron gas in Co2M Si/SrTiO3 (M = Ti,V, Cr,Mn, and Fe) heterostructures

Spin‐polarized density functional theory is used to study the TiO₂ terminated interfaces between the magnetic Heusler alloys Co₂Si (M = Ti, V, Cr, Mn, and Fe) and the non‐polar band insulator SrTiO₃. The structural relaxation at the interface turns out to depend systematically on the lattice mis‐ match. Charge transfer from the Heusler alloys (mainly the M 3d orbitals) to the Ti d_xy orbitals of the TiO₂ interface layer is found to gradually grow from M = Ti to Fe, resulting in an electron gas with increasing density of spin‐polarized charge carriers. (© 2016 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

Infrared/laser multi-sensor fusion and tracking based on the multi-scale model

The state estimation problem of targets detected by infrared/laser composite detection system with different sampling rates was studied in this paper. An effective state estimation algorithm based on data fusion is presented. Because sampling rate of infrared detection system is much higher than that of the laser detection system, the theory of multi-scale analysis is used to establish multi-scale model in this algorithm. At the fine scale, angle information provided by infrared detection system is used to estimate the target state through the unscented Kalman filter. It makes full use of the high frequency characteristic of infrared detection system to improve target state estimation accuracy. At the coarse scale, due to the sampling ratio of infrared and laser detection systems is an integer multiple, the angle information can be fused directly with the distance information of laser detection system to determine the target location. The fused information is served as observation, while the converted measurement Kalman filter (CMKF) is used to estimate the target state, which greatly reduces the complexity of filtering process and gets the optimal fusion estimation. The simulation results of tracking a target in 3-D space by infrared and laser detection systems demonstrate that the proposed algorithm in this paper is efficient and can obtain better performance than traditional algorithm.     

Tuning the electronic properties of single-walled SiC nanotubes by external electric field

The electronic properties of SiC nanotubes (SiCNTs) under external transverse electric field were investigated using density functional theory. The pristine SiCNTs were semiconductors with band-gaps of 2.03, 2.17 and 2.25 eV for (6,6), (8,8) and (10,10) SiCNTs, respectively. It was found the band gaps was reduced with the external transverse electric filed applied. The (8,8) and (10,10) SiCNTs changed from semiconductor to metals as the intensity of electric field reached 0.7 and 0.5 V/Å. The results indicate that the electronic properties of SiCNTs can be tuned by the transvers electric field with integrality of the nanotubes.     

Multiple mobility edges in a 1D Aubry chain with Hubbard interaction in presence of electric field: Controlled electron transport

Electronic behavior of a 1D Aubry chain with Hubbard interaction is critically analyzed in presence of electric field. Multiple energy bands are generated as a result of Hubbard correlation and Aubry potential, and, within these bands localized states are developed under the application of electric field. Within a tight-binding framework we compute electronic transmission probability and average density of states using Green's function approach where the interaction parameter is treated under Hartree–Fock mean field scheme. From our analysis we find that selective transmission can be obtained by tuning injecting electron energy, and thus, the present model can be utilized as a controlled switching device.