新型噻吩基取代卟啉的合成及其荧光光谱研究

合成了两种新型噻吩基卟啉－5，15－二（2－噻吩基）－2，8，12，18－四乙基－3，7，13，17－四甲基卟啉7a（45．1％）和5，15－二（2－联噻吩基）－2，8，12，18－四乙基－3，7，13，17－四甲基卟啉7b(61.2%),并研究了它们的光谱性质，其中荧光光谱的最大发射峰蜂都在631nm处，量子产率分别为4．1％（7a)和1．4％（7b)。     

双面电弧焊接的传热模型

将等离子焊接(PAW)电弧和钨极氩弧焊(TIG)电弧串接,相对作用于工件的正反面形成双面电弧焊接(DSAW)系统,可以引导焊接电流沿工件厚度方向流过小孔,补偿等离子电弧穿透工件时消耗的能量,以有效地提高等离子弧的穿透能力.综合考虑影响双面电弧焊接正反面熔池几何形状的力学因素,建立了熔池表面变形的控制方程,以此为基础并采用帖体曲线坐标系建立了DSAW焊接传热的数学模型,分析了DSAW,PAW焊接传热的差异,从传热的角度解释了DSAW焊接熔深增加的原因.焊接工艺实验表明,计算结果与实测结果吻合良好. 关键词： 双面电弧焊接(DSAW) 传热模型 熔池表面变形模型     

Contact angle hysteresis of liquid drops as means to measure adhesive energy of zein on solid substrates

Adhesion of zein to solid substrates has been studied using surface energy profiles as indices and by adhesion mapping using atomic force microscopy (AFM). Different plasticizers like glycerol and sorbitol have been used to form mixed films with zein and properties of these films are studied using surface energy profiles. Comparison of the results from the different mixed samples with those from the pure zein films showed that force mapping could identify areas rich in protein. The adhesion maps produced were deconvoluted from sample topography and contrasted with the data obtained from contact angle measurements. A comparison of the two methods shows that the extent of contact angle hysteresis is indicative of both hydrophobicity of the surface as well as the force of adhesion. Mechanical properties and microstructure of zein films prepared by casting from solutions and using Langmuir-Blodgett film technique have been investigated. Pure zein seemed brittle and exhibited an essentially linear relationship between stress and strain. Films with plasticizer were tougher than these films. In general, mixed films showed better mechanical properties than pure films and had higher ultimate tensile strength and increased per cent elongation. Further, the mixed films of zein showed a higher force of adhesion compared to the pure films.     

纳米颗粒悬浮液池内泡状沸腾的实验研究

本文对纳米颗粒悬浮液在平壁面上池内沸腾进行了实验研究。实验用的纳米粒子为26 nm的铁粉和13 nm的三氧化二铝纳米粉末,基液为去离子水。分别配成体积浓度为0．1％, 1％和2％的悬浮液。实验结果表明,纳米悬浮颗粒对液体沸腾换热过程的影响会随着纳米颗粒性质,颗粒浓度及热流密度大小的不同而出现不同的效果;加入纳米颗粒后, 对基液沸腾换热的影响存在着两个相反的作用机制,它们分别为:纳米颗粒增强了液体内部的热量迁移能力(热物性的影响)和改变了加热面的表面结构特性(加热面特性的影响)。     

Performance Analysis for Mobile Ad Hoc Network in Random Graph Models with Spatial Reuse

In this paper,we present a random graph model with spatial reuse for a mobile ad hoc network(MANET) based on the dynamic source routing protocol.Many important performance parameters of theMANET are obtained,such as the average flooding distance (AFD),the probability generating function of theflooding distance,and the probability of a flooding route to be symmetric.Compared with the random graphmodel without spatial reuse,this model is much more effective because it has a smaller value of AFD and alarger probability for finding a symmetric valid route.     

Ag纳米颗粒的光吸收和透射电镜研究

用硼氢化钠作还原剂,制备出两种相对稳定的含银纳米颗粒的水溶胶,用透射电镜（TEM）和光学吸收谱对这些颗粒进行了表征.当被还原的银离子较少时,所形成的银纳米颗粒较小,吸收峰呈现二极等离子体共振吸收峰.当被还原的银离子较多时,银纳米颗粒尺寸变大,并出现二极和四极共振吸收峰.在Ag纳米颗粒形成后,对其溶液稀释,发现其峰形保持不变,而峰位会出现红移,最大红移量可达到10 nm.透射电镜研究表明,低浓度溶胶中的Ag纳米颗粒尺寸较为均匀,平均直径12 nm.高浓度溶胶中的纳米颗粒尺寸呈双尺寸分布特点,少量颗粒直径小于14 nm,大部分颗粒直径大于20 nm.     

用力敏传感器测量乙醇水溶液的表面张力系数与浓度的关系

用硅压阻式力敏传感器测量了纯水、乙醇的表面张力系数，并测量了不同浓度的乙醇水溶液的表面张力系数，得到了乙醇水溶液的表面张力系数随浓度的变化曲线．     

影响DPF焦点装置中子稳定性的因素和改进措施

简要叙述了稠密等离子体聚焦装置作为中子发生器的工作原理，对影响稠密等离子体聚焦装置放电出中子产额及其稳定性的一些因素和改进措施进行了简单讨论．通过使用不同电极形状的场畸变开关很好地提高了焦点装置的运行，使装置输出中子的起伏得到明显的改善．通过对腔内电极的清洁，在不更换气体的条件下，聚焦装置放电出中子产额稳定.The principle of dense plasma focus(DPF) as neutron generator has been investigated in this paper. We have stated briefly some factors that mainly influnce the DPF s neutron yield and some methods improving the stability of neutron yields on the dense plasma focus. It is showed that the fluctuation of DPF output neutron becomes smaller by using different types of field-distortion elements. Over 100 consecutive shots without purging the test gas the neutron yields has no obvious change.     

Vassiliev invariants for braids on surfaces

We show that Vassiliev invariants separate braids on a closed oriented surface, and we exhibit a universal Vassiliev invariant for these braids in terms of chord diagrams labeled by elements of the fundamental group of the surface.

     

混凝土动态劈裂拉伸试验的数值模拟

采用LS-DYNA有限元编码程序，对混凝土的动态劈裂拉伸试验进行了数值模拟，给出了混凝土试样在不同类型加载情况下应力分布之间的差异，证实了动态劈裂拉伸试验的有效性，提出了改进试验方法的若干结论．