Asymptotic behavior of tails and quantiles of quadratic forms of Gaussian vectors

We derive results on the asymptotic behavior of tails and quantiles of quadratic forms of Gaussian vectors. They appear in particular in delta–gamma models in financial risk management approximating portfolio returns. Quantile estimation corresponds to the estimation of the Value-at-Risk, which is a serious problem in high dimension.     

Qualitative Theory and Identification of Dynamic System with One Degree of Freedom

Dynamic systems described by nonlinear differential equations of the second order are studied. It is assumed that certain preliminary information on the dissipative or elastic characteristics of systems is known. A new approach is demonstrated to obtaining full information on unknown or partially known characteristics of a system from measurements of not only displacements but also velocities and accelerations __________ Published in Prikladnaya Mekhanika, Vol. 41, No. 6, pp. 139–143, June 2005.     

Existence results for second order boundary value problem of impulsive dynamic equations on time scales

In this paper, Schaefer's fixed point theorem and nonlinear alternative of Leray-Schauder type are used to investigate the existence of solutions for second order boundary value problem for impulsive dynamic equations on time scales.     

On the tribological characteristics of dynamically loaded journal bearing with micropolar fluids

The addition of the additives to the lubricant oil to enhance the characteristics of the lubricant will influence the performance of the bearings. Based on the theory of micropolar fluids, the tribological characteristics of a dynamically-loaded journal bearing are numerically studied. Comparisons are made between the Newtonian fluids and the micropolar fluids. It is shown that for a dynamically-loaded journal bearing, the micropolar fluids yield an increase not only in the friction force, but also in the friction coefficient. In addition, the oil film pressure and the oil film thickness are obviously higher than that of Newtonian fluids.     

Stress and heat flux stabilization for viscous compressible medium equations with a nonmonotone state function

We study a system of quasilinear equations describing one-dimensional flow of a viscous compressible heat-conducting medium with a nonmonotone state function and mass force. The large-time behavior of solutions is considered for arbitrarily large initial data. In spite of possible nonuniqueness and discontinuity of the stationary solution, we prove L²-stabilization for the stress and heat flux as t → ∞ along with corresponding global energy estimates for them. The new method of proof utilizes a combination of energy type equalities for the stress and heat flux. Consequently, H¹-stabilization of the velocity and temperature along with global estimates for their derivatives are valid as well.     

关于曲线积分中值定理“中间点”的一个一般性结果

讨论了第一类曲线积分中值定理“中间点”的渐近性质,得到了更具一般性的新结果.     

Voltammetric determination of mesotrione at hanging mercury drop electrode

A study of the electrochemical reduction of the mesotrione pesticide on a hanging mercury drop electrode (HMDE) was performed as a basis for the development of a sensitive analytical method for natural samples. The electrochemical characteristics of herbicide mesotrione dissolved in a phosphate buffer (pH 7.0) have been determined by means of electrochemical techniques such as cyclic voltammetry (CV) and differential pulse voltammetry (DPV) over a wide range of pH from 2.0 to 10.0. The experimental parameters, such as electrolyte type and its pH, pulse amplitude, and scan rate were optimized. The method was applied to the determination of the pesticide in a spiked soil samples. Using this method, a linear calibration curve for mesotrione was obtained up to the 0.1 μM range in pH 7 phosphate buffer solution with a detection limit (S/N = 3) of 50 nM. The method can be applied successfully to the determination of mesotrione in soils. The text was submitted by the authors in English.     

Sterically stabilized emulsion polymerization of styrene: Pseudo‐semicontinuous approach

The sterically stabilized emulsion polymerization of styrene initiated by a water‐soluble initiator at different temperatures has been investigated. The rate of polymerization (R_p) versus conversion curve shows the two non‐stationary‐rate intervals typical for the polymerization proceeding under non‐stationary‐state conditions. The shape of the R_p versus conversion curve results from two opposite effects—the increased number of particles and the decreased monomer concentration at reaction loci as the polymerization advances. At elevated temperatures the monomer emulsion equilibrates to a two‐phase or three‐phase system. The upper phase is transparent (monomer), and the lower one is blue colored, typical for microemulsion. After stirring such a multiphase system and initiation of polymerization, the initial coarse polymer emulsion was formed. The average size of monomer/polymer particles strongly decreased up to about 40% conversion and then leveled off. The initial large particles are assumed to be highly monomer‐swollen particles formed by the heteroagglomeration of unstable polymer particles and monomer droplets. The size of the “highly monomer” swollen particles continuously decreases with conversion, and they merge with the growing particles at about 40–50% conversion. The monomer droplets and/or large highly monomer‐swollen polymer particles also serve as a reservoir of monomer and emulsifier. The continuous release of nonionic (hydrophobic) emulsifier from the monomer phase increases the colloidal stability of primary particles and the number of polymer particles, that is, the particle nucleation is shifted to the higher conversion region. Variations of the square and cube of the mean droplet radius with aging time indicate that neither the coalescence nor the Ostwald ripening is the main driving force for the droplet instability. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 804–820, 2003     

Hg1-xCdxTe/Cd1-zZnzTe的X射线反射率及半峰全宽的动力学研究

X射线衍射摇摆曲线的计算机模拟是一种获得材料晶体质量参量的有效方法，其中材料本征摇摆曲线的计算是计算机模拟的基础。用X射线动力学理论计算了Hg1-xCdxTe和Cd1-zZnzTe本征反射率曲线，并研究了组分、膜厚分别对本征反射率和半峰全宽的影响。结果表明Hg1-xCdxTe和Cd1-zZnzTe的本征反射率和半峰全宽与材料组分和厚度有明显的依赖关系，且该依赖关系取决于X射线在材料中的散射和吸收的相对强弱。薄膜的厚度也是直接影响本征摇摆曲线峰形、半峰全宽和反射率的重要因素，当薄膜厚度小于穿透深度时，表征本征反射率曲线的各个参量均与薄膜厚度有直接的关系。对于(333)衍射面，碲镉汞材料厚度大于7μm后，本征反射率和半峰全宽将不再发生明显变化。     

Determination of the rheological behavior of epoxy–amine thermosets by dynamic mechanical analysis: Isothermal methods versus nonisothermal methods

The reticulation process of an epoxy resin using an amine as a cure agent was studied at different temperatures and concentrations of the cure agent with dynamic mechanical thermal analysis. The study was performed under both isothermal and nonisothermal conditions, and a temperature–time–transformation diagram was obtained. The measurements from the two modes gave similar results, although the nonisothermal mode required fewer experiments. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1965–1977, 2003