The role of various binding materials for trace elemental analysis of powder samples using laser-induced breakdown spectroscopy

Study of various binding materials like potassium bromide, poly(vinyl alcohol), starch, silver and aluminum has been carried out using laser-induced breakdown spectroscopy (LIBS). The role of matrix effects using these five binders on LIBS signal intensity was investigated for better performance of LIBS technique as a quantitative analytical tool. For comparative study of different binders, the signal intensity of different Mg lines at 518.3, 517.2, 383.8 and 279.5 nm wavelengths were recorded for pellets prepared with known concentrations of Mg in these binders. The influence of laser energy on ablated mass under different binding materials and its correlation with LIBS signal intensity has been explored. Optical scanning microscopy images of the ablated crater were studied to understand the laser ablation process. The study revealed that the binding material plays an important role in the generation of LIBS signal. The relative signal intensity measured for a standard Mg line (at 518.3 nm) were 735, 538, 387, 227 and 130 for potassium bromide, starch, poly(vinyl alcohol), silver and aluminum as binders, respectively. This indicates clearly that potassium bromide is better as a binder for LIBS studies of powder samples.     

Bioactive steroidal glycosides from the marine sponge Erylus lendenfeldi

Bioassay-guided fractionation of the methanol extract of Erylus lendenfeldi using engineered strains of budding yeast (Saccharomyces cerevisiae) has resulted in the isolation of the known compound eryloside A (1) and two new compounds, erylosides K (2) and L (3). The structures were established based mainly on 1D and 2D NMR data. The absolute stereochemistry of eryloside A, which had never been fully characterized, was determined using the modified Mosher's method. The absolute stereochemistry of eryloside K was determined by comparison with tetrahydroeryloside A. Compounds 1-3 exhibited selective cytotoxicity against a yeast strain (Δrad50) deficient in double strand break (DSB) repair.     

Three‐dimensional wave impact on a rigid structure using smoothed particle hydrodynamics

Navier–Stokes computations of a wave–structure interaction are performed with the aim of assessing the potential of smoothed particle hydrodynamics to accurately estimate impact loading time history. A three‐dimensional dam‐break flow with a rectangular column located downstream is considered. The net force and impulse exerted on the column is monitored throughout the simulation with the results correlating well with existing experimental data. Initial and boundary conditions and numerical parameters are varied and their effect on the column load investigated. The column load is found to be most sensitive to the choice of boundary treatment. Copyright © 2011 John Wiley & Sons, Ltd.     

梯级溃坝洪水洪峰增强机制

我国在多条河流上修建了大量梯级水库, 梯级坝溃决诱发洪水大大超过单坝溃决洪水洪峰, 因此亟需加深对梯级坝溃决洪水洪峰增强机制的认识. 本文建立了梯级坝溃决洪水演进过程的一维浅水动力学模型, 发展了一套能捕捉激波、干湿边界和保平衡结构的数值求解方法, 通过大量算例, 系统研究了梯级坝溃决洪水演进过程的质量转化和能量转化机制. 研究结果表明, 梯级溃决中, 上游溃决诱发的洪水大大增大下游水库的质量和动量, 形成一个带动量的水塔, 同时在尾部残留一个动量较大的射流, 不断补充下游坝体溃决后水塔的质量和动量, 持续维持洪峰高度. 根据该射流-水塔机制, 建立了梯级坝溃决洪水演进过程对应的射流-水塔单坝溃决洪水过程等效模型, 该等效模型基本反映了梯级坝溃决诱发洪水的洪峰过程, 并成功预测了多个坝间距为百公里量级的梯级坝溃决洪水洪峰高程和流量, 可望为流域防洪和梯级坝设计提供理论依据.      

STUDY ON THE PROPERTIES OF BLEND OF NATURAL RUBBER LATEX/METHYL METHACRYLATE GRAFTED RUBBER LATEX BY GAMMA RADIATION

Natural rubber latex(NRL)and methyl methacrylate(MMA)grafted rubber latex were blended in different ratios and irradiated at various absorbed doses by gamma rays from Co-60 source at room temperature.The tensile properties, swelling ratio and permanent set were measured.The maximum tensile strength and modulus at 500% elongation were obtained at an absorbed dose of 8 kGy.Modulus increases from 6.99 MPa to 9.87 MPa for an increase in proportion of MMA grafted rubber from 40% to 60% in the blend at similar absorbed dose.Elongation at break and swelling ratio decrease with increasing absorbed dose as well as the MMA grafted rubber content in the blends.The decreasing trend of permanent set is high up to 5 kGy absorbed dose,and beyond that dose,it becomes almost flat.     

水下爆炸冲击荷载下混凝土重力坝的抗爆性能

在水下爆炸冲击荷载作用下,结构动力响应较之静态荷载和地震荷载作用下要复杂得多。通过大 量的数值模拟,探讨了混凝土重力坝在水下爆炸冲击荷载作用下,大坝高度、库前水位对大坝抗爆性能的影 响,为大坝抗爆性能评估和防护设计提供基础。数值计算中,构建了重力坝水下爆炸全耦合数值模型,并考虑 爆炸冲击作用下混凝土的高应变率效应。研究结果表明:对于混凝土重力坝,随着大坝高度的增加,大坝的抗 爆性能增强;库前水位对大坝的抗爆性能影响较大,通过降低库前水位可有效提高大坝的抗爆性能。     

水力劈裂问题的态型近场动力学建模

将态型近场动力学理论引入水力劈裂问题的模拟。构建了能反映岩土类材料准脆性断裂特征的态型近场动力学本构模型,并在物质点间相互作用力模型中加入等效水压力项,以实现在新生裂纹面上跟踪施加水压力。同时,考虑裂纹面间的接触,引入物质点间的短程排斥力作用,并设计了相应的接触算法。通过自编程序将模型和算法应用于含初始裂纹、不含初始裂纹以及含坝基软弱结构面的混凝土重力坝在高水头作用下的水力劈裂过程模拟,并与扩展有限元等模拟结果对比,验证了本文模型和算法的可行性和准确性。     

The limiting distribution for the infinitely deep dam with a Markovian input

The paper outlines a case for taking greater interest in the bottomless, or infinitely deep, dam model in Hydrology. It then shows that for such a model with unit withdrawals and an ergodic Markov chain input process the limiting distribution of depletion, when this exists, is a zero modified geometric distribution. This result generalises the well known result for independent inputs. The technical conditions required for the proof are satisfied for finite state space input processes and are shown to be satisfied by certain infinite state space input processes. These include as special cases examples which have a negative binomial limiting input distribution.     

Rheology and microstructures formation of immiscible model polymer blends under steady state and transient flows

Viscoelastic properties of model immiscible blend were studied here under steady state condition at different initial conditions and transient flow conditions. The flow‐induced microstructure has been studied on these model blends. For this system, the elastic properties of the blend are mainly governed by the interface. Measurement of the dynamic modulus and of the first normal stress difference, both reflecting this enhanced elasticity, have been used to prove the blend morphology. The dynamic moduli after cessation of shear flow, the mean diameter of the disperse phase as generated by the shear flow, have been calculated using the model of Palierne. A procedure based on a direct fitting of the dynamic moduli with the model is compared with the one that uses a weight relaxation spectrum. On the other hand, the steady state normal stress data have been related to the morphology of the blend by means of Doi and Ohta model. The specific interfacial area is found to be inversely proportional to the ratio of interfacial tension over shear stress for the blend. The flow behavior during transient shear flow was also discussed. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 43: 3519–3533, 2005     

Halting combustion waves with a fire break

A simple model for the propagation of an exothermic reaction is proposed in which the reactant ignites at a specified temperature. It is shown that the model supports waves of permanent form and the speed and stability of such waves is determined. Finally the behavior of this wave as it encounters a break in the fuel is considered. In particular results are obtained for the size of the break required to halt the wave.