Sample Injection for Capillary Electrophoresis on a Micro Fabricated Device/On Chip CE Injection

Abstract

Reproducible injection for capillary electrophoresis on a micro device/Lab on chip is not an easy task. Different injection designs (e.g., T‐type, double T‐type, cross) and different injection modes have been applied (pinched injection, gated injection, optically gated injection, pressure/pneumatic injection, double L injection) with various analytes. Problems and properties of the different modes are described.     

TiO2光催化降解4-氯苯酚过程中的电分析监测

采用循环伏安法和紫外光谱法对有机物的光催化降解进行机理研究和在线监测.以标准光催化剂DegussaP25在紫外光照射下催化降解4-氯苯酚,发现在降解过程中至少有两对氧化还原中间产物对苯二酚-苯醌和羟基氢醌-羟基苯醌.由4-氯苯酚及中间产物的电极响应,可以观测到它们在光催化降解过程中的含量变化,从而对整个过程实现在线监测,并由此全面了解光催化反应机理.从不同反应时间后测得的紫外光谱可以看到,苯环特征峰逐渐消失.这表明4-氯苯酚的苯环逐渐被打开,直至被彻底降解.     

邻苯二酚紫-示波计时电位法测定天然水中不同形态铝

报道邻苯二酚紫-示波计时电位法分别在酸性和碱性条件下直接检测天然水中的无机单核铝和总单核铝浓度。并用该法测定了水样中的总铝,有机单核铝和酸溶态铝,从而实现了天然水中5种Al形态的电化学测定。测定了20多个实际水样,与Driscoll方法进行了对照,结果基本一致。     

金红石浮选组合捕收剂的 HPLC 的分离测定

采用HPL法对浮选组合捕收剂（水杨羟肟酸、N－竣工在酰胺类F203、油酸）进行了分析测定,采用自行填装的ODS C18不锈钢柱、甲醇和水作流动相,用5％（v/v)的磷酸调节流动相pH=5.0,可获得满意的测定结果。     

热对银电极阳极膜光电流测定的影响

利用光电流 ,光热信息和热电流方法研究了热对Ag在 1mol/LNaOH溶液中表面阳极膜光电流的影响 .所用光源为 4 88nm和 5 32nm的激光 .结果表明Ag2 O层具有半导体光电流特性 ,在Ag ,Ag2 O和AgO的转变过程中 ,光照下电极表面的温升不同 .对照循环伏安曲线 ,及光电流和热电流曲线 ,可以证明在电位朝负方向扫描过程中于 0 .37V出现的阳极光电流峰和 0 .1V出现的阴极光电流峰主要是由光照下温度升高引起的热电流所造成的 .光电流和热电流随着光强度的增强而线性增强     

镀镍液中镍的在线分析研究

基于硫酸镍溶液的光谱吸收特征,采用双波长双通道流动注射分光光度法测定镀镍液中镍的含量。借助计算机控制,实现了镀镍液中镍的在线分析,能满足生产工艺分析的要求。     

Nonmonotonic pattern of the critical percolation temperature due to variations of additive chain length in water-in-oil microemulsions

The nonmonotonic variation of the critical percolation temperature (T _c) of ternary nonionic (C₁₄E₅) water-in-oil microemulsions was studied as a function of the alkyl chain length of an ionic additive (n-alkyl sulfonate sodium salt). A thermodynamic approach shows the relationship between T _c and additive chain length, which is supplemented by a consideration of a possible molecular mechanism of the observed phenomenon. Received: 20 October 2000 Accepted: 7 November 2000     

在线分析己烷中痕量四氢呋喃的气相色谱柱系统研究

 根据 30万t乙烯工程“橡胶”装置中生产工艺控制的实际需要 ,研究了在线分析己烷中痕量四氢呋喃的气相色谱柱系统。使用自制的 7μm特厚膜甲基硅氧烷大孔径弹性石英毛细管柱 ,通过试验不同条件下色谱柱的分离特性及研究组分在柱内的运动轨迹 ,给出了总的柱切换时间程序。在上述基础上 ,完成了正己烷、环己烷中 10 -6(体积分数 )级的四氢呋喃分析。现场应用一年多的实践表明 ,所研制的柱系统从分析时间、运行稳定性、定量准确性 (相对标准偏差小于 5 % )等方面均满足工艺控制的要求。     

Preparation and characterization of Cu (II) supported on poly(8‐hydroxyquinoline‐p‐styrene sulphonate) and its application as catalyst for the synthesis of hexahydroquinolines

Cu ( II ) supported on poly(8‐hydroxyquinoline‐p‐styrenesulfonate) (Cu ( II )@PHQSS) was prepared and fully characterized by the different techniques including fourier transform infrared spectroscopy (FT‐IR), ¹H NMR, ¹³C NMR, thermal gravimetric analysis (TGA), differential thermal gravimetric (DTG), differential thermal analysis (DTA), scanning electron microscope (SEM) and energy dispersive X‐ray analysis (EDS). Afterward, the Cu ( II )@PHQSS as nanostructured catalyst was used as catalyst for the synthesis of hexahydroquinolines.     

Direct determination of δ44/42Ca isotope ratio by ion chromatography/low‐resolution multicollector ICPMS

High‐precision on‐line procedure for measurement of calcium isotopic ratio by coupling ion chromatography to multicollector inductively coupled plasma mass spectrometry was developed. Calcium separation from the sample matrix was achieved on an ion chromatography column—IonPac CS16—ID 3 mm connected with CERS 500 2 mm suppressor and followed by multicollector inductively coupled plasma mass spectrometry calcium isotopic ratio determination. Dry plasma mode was used with Aridus II desolvation system. To sustained samples with high level of total dissolved salts as well as account capacity of applied analytical column, the method has been optimized regarding calcium isotope ratio measurements with low‐resolution mass spectrometry. Mass discrimination and instrument drift were corrected by sample‐standard bracketing method using the ⁴⁴Ca/⁴²Ca isotope ratio of SRM 915a as a standard. Good accuracy and reasonable precision of calcium isotope ratio (generally 0.20‰ [2SD]) were achieved, which are comparable to off‐line Ca separation and continuous measurement. The reproducibility of the proposed analytical procedure was verified by measuring the SRM 915a standard as a sample randomly over 3 months (n = 56). Applicability of the protocol was demonstrated for matrix‐rich natural water samples, coral samples, and bone standard reference materials.