一种新的磁共振图像处理流水线的设计与实现

磁共振图像的重建、后处理及可视化是磁共振成像（MRI）系统的重要组成部分.本文开发了一个新的用于磁共振图像重建、后处理及可视化的开源框架YAP（Yet Another Pipeline），利用此框架可以方便地构建图像处理流水线.与现有的一些其他开源框架相比，本文开发的框架具有如下特点：（1）采用基于接口的设计，可使用基于接口的插件对流水线的功能进行扩展；（2）允许用户使用编写脚本的方式构建图像处理流水线，编辑与修改流水线都很方便；（3）支持带有分支结构的流水线，便于流水线的构建与调试.目前，该框架已经在商用系统中获得了应用.     

基于虚拟中心电流法的 HL-2M快控电源数学模型

针对中国环流器2号M(HL-2M)装置中用于核聚变物理实验等离子体的垂直不稳定性控制的快控电源拓扑结构，充分考虑线圈的自感与互感对输出的影响，构建出数学模型，首次提出并运用虚拟中心电流法，使得控制算法更加简单，采用多输入多输出的控制方法，利用2个参量控制3个变量。本文基于基本供电方案得到多线圈耦合电压，基于快控电源拓扑推导出快控电源电路方程，再将其合并得到最终的线圈电压数学模型，最后进行仿真验证。结果表明数学模型搭建正确，为今后进行进一步计算提供了坚实的基础。     

Zr掺杂对MgB2超导微观结构和超导电性的影响

将Mg粉、Zr粉和B粉按比例混合获得Mg1-xZrxB2(x=5%10%和20%),压制成型后,在流通氩气的条件下于800℃烧结2h.利用X射线衍射仪(XRD)、扫描电子显微镜(SEM)分析烧结后样品的显微结构和化学组成,采用差热分析(DTA)观察Zr掺杂对MgB2分解温度的影响,并用物性测试仪(PPMS)测试样品的超...     

High-speed deposition of RE123 film with large current capacity by hot-wall type PLD system

We have studied a hot-wall heating system to produce GdBa₂Cu₃O_y (GdBCO) films with large critical currents (I_c) at a high production rate by a pulsed-laser-deposition (PLD) method. GdBCO films fabricated at a production rate of 30 m/h under the optimized conditions, especially a distance of 95 mm between the target and the substrate (T–S), exhibited high critical current densities (J_c) of about 3 MA/cm² and I_c over 300 A at a thickness of 1–2 μm. Furthermore, long GdBCO tapes prepared by repeated depositions at each tape-passing speed of 80 m/h showed uniform I_c distribution along the longitudinal direction, because the hot-wall system enabled to stabilize temperature within a few degrees at 800 °C. A 170 m long tape with I_c over 600 A was successfully fabricated at a production rate of 16 m/h using a laser power of 360 W.     

Spin-dependent transport in a nanopillar non-local spin valve

We investigate the injection of a pure spin current into a non-magnetic Cu wire in a lateral spin valve. We detect the spin accumulation occurring at the interfaces between the magnetic nanopillars and the non-magnetic wire in the non-local geometry. We confirm that the accumulated spins diffuse equally in the Cu wire irrespective of the presence of a charge current. The inversion of the injector and detector magnetic nanopillars does not affect the spin signal, in agreement with analytical predictions for this system.     

A model of nonlinear electrodynamics

A new model of nonlinear electrodynamics with two parameters is investigated. We also consider a model with one dimensional parameter. It was shown that the electric field of a point-like charge is not singular at the origin and there is the finiteness of the static electric energy of point-like charged particle. We obtain the canonical and symmetrical Belinfante energy–momentum tensors and dilatation currents. It is demonstrated that the dilatation symmetry and dual symmetry are broken in the models suggested. We have calculated the static electric energy of point-like particles.     

The side chain effects on TPD-based copolymers: the linear chain leads to a higher jsc

Abstract

Alkyl substituents appended to polymers play the determining role on self-assembly and film-forming properties, and on device performance. In this work, we highlight the effects of the linear and branched flexible chains appended to the acceptor moiety (A) in D-A type copolymers. Two thieno[3,4-c]-pyrrole-4,6-dione (TPD) based copolymers PT1 and PT2 with different alkyl chains, were designed and synthesized. By comparison their UV-vis absorptions, HOMO/LUMO energy levels, as well as the characters in polymer solar cells, the influences of alkyl chains were investigated. Both copolymers showed molecular weights of 21?kDa and similar optical properties with a medium band gap of 1.93?eV, while PT2 with the branched chain exhibited a lower HOMO than that of PT1 (?5.43 vs???5.37?eV). In bulk heterojunction (BHJ) solar cells, PT1 with a linear chain presented a short circuit current (J_sc) of 6.76?mA cm^?2, open circuit voltage (V_oc) of 0.89?V and power conversion efficiency (PCE) of 2.92%. To the contrary, PT2 showed a J_sc of 3.53?mA cm^?2, V_oc of 0.99?V, delivering a relatively lower PCE of 2.05%. The result indicates that appending a linear alkyl chain to the TPD unit could sufficient enhance the J_sc value of the related polymer.     

室温下制备以{211}晶面为主的Ti1-xVxO2薄膜及其可见光催化性能

以金属Ti和V作为靶材,采用直流反应共溅射技术在室温下制备了以{211}晶面为主的锐钛矿相Ti_1-xV_xO₂薄膜,研究了不同V靶功率对Ti_1-xV_xO₂薄膜的薄膜成分、晶相结构和可见光催化性能的影响。研究表明,Ti_1-xV_xO₂薄膜的晶相结构为锐钛矿相,择优取向为(211),而结晶度受V靶功率的影响。随着V靶功率的增加,薄膜中V元素含量逐渐增加,同时,晶粒和沉积速率也逐渐增加。另外,当V靶功率为150 W时,薄膜的表面粗糙度值有一个最大值。V的掺杂导致薄膜的能带间隙变窄,对光的吸收向可见光区偏移,从而有效地改善了薄膜的可见光催化能力。当V靶功率为150 W时,Ti_1-xV_xO₂薄膜的能带间隙值为 2.82 eV,其在2 h的可见光照射下分解了80%的RhB染料。这被归结于能带间隙窄,高能晶面{211}和结晶度高的共同作用。     

Accelerated solvent extraction and pH‐zone‐refining counter‐current chromatographic purification of yunaconitine and 8‐deacetylyunaconitine from Aconitum vilmorinianum Kom

This study aimed to seek an efficient method to extract and purify yunaconitine and 8‐deacetylyunaconitine from Aconitum vilmorinianum Kom. by accelerated solvent extraction combined with pH‐zone‐refining counter‐current chromatography. The major extraction parameters for accelerated solvent extraction were optimized by an orthogonal test design L₉ (3)⁴. Then a separation and purification method was established using pH‐zone‐refining counter‐current chromatography with a two‐phase solvent system composed of petroleum ether/ethyl acetate/methanol/water (5:5:2:8, v/v) with 10 mM triethylamine in the upper phase and 10 mM HCl in the lower phase. From 2 g crude extract, 224 mg of 8‐deacetylyunaconitine (I) and 841 mg of yunaconitine (II) were obtained with a purity of over 98.0%. The chemical structures were identified by ESI‐MS and ¹H and ¹³C NMR spectroscopy.     

An efficient strategy for the extraction and purification of lignans from Schisandra chinensis by a combination of supercritical fluid extraction and high‐speed counter‐current chromatography

An efficient strategy for extracting and separating five lignans from Schisandra chinensis (Turcz.) Baill has been developed using supercritical fluid extraction (SFE) and high‐speed counter‐current chromatography (HSCCC) in the present study. First, the extraction was performed by a preparative SFE system under 15 MPa of pressure at 36°C for 4 h. Then, the SFE extract was successfully separated and purified by HSCCC with a two‐phase solvent system composed of n‐hexane/ethyl acetate/methanol/water (6:4:5:5, 6:4:6:4, 6:4:8:2, v/v) in a stepwise elution mode. The fractions were analyzed by HPLC, and the chemical structures of the products were identified by ESI‐MS and ¹H NMR spectroscopy. As a result, a total of 12.5 mg of schisandrin at 98.0% purity, 7.1 mg of gomisin A at 98.1% purity, 1.8 mg of schisantherin B at 93.3% purity, 4.4 mg of deoxyschisandrin at 92.9% purity, and 6.8 mg of γ‐schisandrin at 89.1% purity were obtained from 300 mg crude extract in a one‐step purification.