Dummy molecularly imprinted polymers as the coating of stir bar for sorptive extraction of bisphenol A in tap water

A unique stir bar coated with dummy molecularly imprinted polymers for bisphenol A was prepared by sol-gel technique. The scanning electron microscopic image of the coating presented a homogeneous surface with a thickness of about 57 ± 2.5 μm. The Fourier transform infrared spectrum of the coating proved the incorporating of dummy molecularly imprinted polymers with the sol-gel network. When used to extract bisphenol A from aqueous solution containing bisphenol A and its three analogs (4-tert-butylphenol, 4,4'-dihydroxybiphenyl, and 3,3',5,5'-tetrabromo-bisphenol A). Dummy molecularly imprinted polymers-coated stir bar showed better selectivity than the bars coated with polydimethylsiloxane or non-imprinted polymers. The extraction conditions including stirring speed, pH, and extraction time were optimized. After back extraction with methanol, the extracts were analyzed by high-performance liquid chromatography-fluorescence detection. The linear range was 0.0228-0.456 ng/mL with correlation coefficient of 0.9994 and the detection limit was about 5.70 × 10(-3) ng/mL based on three times ratio of signal-to-noise. The method was applied to the determination of trace bisphenol A in tap water.     

丙烯环氧化反应中TS-1催化剂失活研究

采用丙烯气相进料,在预混段中先与双氧水的甲醇溶液混合后进入固定床反应器,考察了进料液中pH值、丙二醇单甲醚、乙硫醇以及铁锈等对丙烯环氧化连续反应中TS-1分子筛催化剂性能的影响。结果表明,进料液体pH值对催化剂的催化性能有影响,适宜的进料液体pH值在7左右;副产物丙二醇单甲醚含量的增加不会对催化剂性能产生影响;乙硫醇量的增加使环氧丙烷选择性下降,但不会引起催化剂的失活;而进料液体中铁锈的引入会导致催化剂中部分孔堵塞,使催化剂部分失活。当进料液中的pH值用0.1mol/L的氨水调节为7左右,在反应温度55℃,反应压力0.7MPa,TS-1催化剂具有较好的稳定性,经130h的连续试验考察,双氧水的转化率和环氧丙烷的选择性约为90%。     

钇对Nd-Fe-Al-Ni非晶合金热稳定性与晶化行为的影响

采用差示扫描量热法（DSC）、X射线衍射（XRD）和透射电镜（TEM）研究了Y对Nd-Fe-Al-Ni非晶合金热稳定性和晶化行为的影响。结果表明,淬火态的Nd60Fe20Al10Ni10-xYx（x=0,2）合金基本为非晶组织同时还含有少量的淬态相,Y的加入抑制了淬态相的析出。加入Y后,非晶合金的晶化开始温度和晶化峰值温度都向高温方向移动,证明其热稳定性提高。Y的加入改变了合金的晶化方式和最终晶化产物,使非晶基体中析出的晶化相更加弥散圆整细小。并且Y具有在化学上钝化氧杂质的作用,从而抑制了氧的有害作用。利用Kissinger方程获得了Nd60Fe20Al10Ni8Y2非晶合金的晶化开始和晶化峰值激活能分别为1.21和1.16 eV。     

Al2O3/SnO2 Co-Nanoparticle Modified Grafted Collagen for Improving Thermal Stability and Infrared Emissivity

Al2O3/SnO2 co-nanoparticles were prepared with a modified sol-gel technique followed by a thermal treatment process. With these co-nanoparticles the grafted collagen-Al2O3/SnO2 nanocomposites were obtained using a supersonic dispersion method. X-ray diffraction, FT-IR analysis, transmission electron microscopy, TGA/DTA and infrared emissivity test were performed to characterize the resulting nanoparticles and nanocomposites, respectively. The Al2O3/SnO2 co-nanoparticles showed a narrow distribution of size between 20-40 nm and could be uniformly absorbed on the tri-helix scaffolds of the grafted collagen without any aggregation. The nanocomposites possessed better thermal stability and substantially lower infrared emissivity than the grafted collagen and Al2O3/SnO2 co-nanoparticles with an increase of degradation temperature from 39 to 210 ℃ and a decrease of infrared emissivity from 0.850 of the grafted collagen and 0.708 of the Al2O3/SnO2 co-nanoparticles to 0.424, which provided a potential application of the nanocomposites to areas such as photoelectronics.     

Enhanced thermal stability and structural ordering in short chain <Emphasis Type="Italic">n</Emphasis>-alkanethiol monolayers on gold probed by vibrational spectroscopy and EQCM

Monolayers of alkanethiols with varied chain lengths, CH₃(CH₂)_nSH where n = 3, 5, and 7, on gold substrates have been prepared by adsorption from (1) neat thiol, (2) millimolar thiol solution in alcohol (conventional method), and (3) potential-controlled adsorption. Reflection absorption infrared spectroscopy (RAIRS) and electrochemical quartz crystal microbalance (EQCM) have been used to characterize the integrity of the monolayers. Methylene and methyl stretching modes along with C–S stretching modes have been used as benchmarks to follow the order–disorder transitions in the monolayer structure, in the temperature range from 25 to 175 °C. Monolayers adsorbed from neat thiol show superior quality in terms of stability and structural arrangement. Short chain thiols with n = 3, 5, and 7 do show substantial stability. The possibility of multilayer formation is ruled out by EQCM studies comparing the frequency and mass change associated with the monolayer desorption. Self-assembled monolayers (SAMs) adsorbed under potential control behave very similarly to the monolayers adsorbed from neat thiol as far as stability and structural orientation are concerned, irrespective of the chain length. The adsorption from neat thiol gets rid of the solvent-induced defects and arrests the propagation of defects under temperature constraints.     

无焰燃烧烟密度标准物质的研制

介绍无焰燃烧烟密度标准物质的研制方法。选用合适的α-纤维素作为原材料,经打浆造纸后,作为标准物质候选物,经均匀性检验和稳定性考察合格后,对标准物质进行定值。在无焰燃烧条件下烟密度标准物质的标准值为175,扩展不确定度为8;校正烟密度标准物质的标准值为166,扩展不确定度为8。     

大港常压渣油临氮与临氢热反应过程中胶体稳定性变化研究

对比了大港常压渣油临氮和临氢热反应过程中的胶体稳定性变化。结果表明,随着反应时间的延长,在热反应生焦诱导期内,渣油样品的胶体稳定性迅速下降;开始生焦后,胶体稳定性缓慢下降。从组分组成和组分性质角度,对大港常压渣油样品在热反应过程中胶体稳定性变化原因进行了分析。结果表明,随着反应时间的延长,沥青质含量先上升、后下降,在生焦诱导期结束时达到最大值,与体系胶体稳定性的变化特征相一致。随着热反应的进行,饱和分和轻芳烃组分的含量在上升,重芳烃、轻胶质、中胶质、重胶质含量下降,临氮热反应过程中轻胶质、中胶质、重胶质含量的下降更为显著。对渣油样品各组分的数均相对分子质量和平均偶极矩进行了研究。结果表明,随着热反应的进行,轻、中、重胶质组分的数均相对分子质量和平均偶极矩呈下降趋势,而沥青质的数均相对分子质量和偶极矩先增大后减小,从而使沥青质和胶质的分子性质差别先增加后减小,与体系胶体稳定性的变化趋势一致;同时沥青质的偶极矩变化表明,强极性的沥青质优先聚集生焦、临氢热反应过程中,氢与催化剂的作用有助于抑制沥青质分子量增大和极性增强,从而有助于抑制生焦。     

Size-dependent phase stability of a molecular nanocrystal: a proxy for investigating the early stages of crystallization

We make the link between the size-dependent phase stability of a nanocrystal and the phase-transition behavior of emerging crystallites during the earliest stages of crystallization, by using the former as a proxy for the latter. We outline an extension of the classical nucleation theory to describe crystal nucleation and subsequent transformations of competing polymorphic phases that characterize Ostwald's rule of stages. The theoretical framework reveals that the relative stability of the competing phases is a function of cluster size, which in turn varies with time, and therefore explains the complex transformation behavior observed for some systems. We investigated the stability of a nanocrystal of dl-norleucine by means of molecular simulation as a proxy for post-nucleation phase-transformation behavior in emerging crystallites. The simulations reveal that, for nanocrystals, the surface energy of the transition state of a transformation can dominate the barrier to phase change, thus causing metastable phases to be stabilized, not because they are thermodynamically stable, but rather due to kinetic hindering. Therefore, in the context of the earliest stages of crystal growth, not only does phase stability vary as a function of cluster size, and hence time, but thermodynamically feasible transformations are also prone to kinetic hindering.     

2-羰基丙酸（芳甲酰基）腙二（2,4-二氯苄基）锡配合物的合成、晶体结构、热稳定性及与DNA相互作用研究

在含水甲苯中,2,4-二氯苄与锡粉反应合成了二（2,4-二氯苄基）二氯化锡,将其分别与2-羰基丙酸（苯甲酰基）腙及2-羰基丙酸（水杨酰基）腙反应,合成了2个取代苄基锡配合物（C2、C3）,配合物C2和C3通过元素分析、¹H NMR、¹³C NMR、IR、UV-Vis等表征,运用X-射线单晶衍射测试了2个有机锡配合物的分子结构,结构分析表明,锡与配位原子形成变形五角双锥构型的双核有机锡配合物,分子以Sn₂O₂四元环为中心对称。热分析结果表明,在空气氛下,配合物C2在121℃、C3在128℃以下可稳定存在;在Tris-HCl缓冲溶液中,以EB做为荧光探针,用荧光光谱法初步研究了配合物与鲱鱼精DNA的相互作用,结果表明配合物与鲱鱼精DNA作用是插入结合与静电结合共同作用所致。     

顶空吸附萃取-气相色谱法分析小麦中部分风味物质

采用顶空吸附萃取法(headspace sorptive extraction, HSSE)建立了小麦中部分风味物质的分析方法。以硅橡胶为原料,采用溶胶-热空气硫化法,在模具中定型制得硅橡胶萃取棒。萃取棒的硅橡胶层体积约为87 μL,热稳定性好,耐热温度达到390 ℃。萃取棒吸附的风味物质经自制热解吸装置热脱附,被吹扫进入气相色谱仪进行分析。考察了萃取温度及时间、相比、热解吸条件对该方法萃取效率的影响。在优化条件下分析小麦粉标准样品,结果表明:方法的线性关系良好(r>0.9979),检出限为0.09～1.00 μg/kg,标准物质的平均添加回收率为95%～121%,相对标准偏差在2.2%～7.8%之间。对小麦粉实际样品进行分析,采用外标法得到了7种风味物质的绝对含量。该方法简便快捷,检出限低,适用于小麦中风味物质的快速定量分析。