氯化血红素催化新型荧光反应测定葡萄糖的研究

本文用流动注射分析了研究了过氧化物模拟酶催化过氧新型荧光底物（Ｎ，Ｎ－二氰甲基邻苯二胺，ＤＣＭＯＰＡ）的最优条件。结果表明，该系统可用于定量测定氧化氢及催化氯化血红素的浓度。     

Determination of lithium in pharmaceutical formulations used in the treatment of bipolar disorder by flow injection analysis with spectrophotometric detection

In this work, a flow injection system with spectrophotometric detection was developed for the determination of lithium in pharmaceutical formulations used in the treatment of bipolar disorder. Reaction between Quinizarine (1,4-dihydroxyanthraquinone) and Li(I) ion in alkaline medium containing dimethylsulfoxide (DMSO) was explored for this purpose. The flow system was optimized regarding to its chemical (DMSO, Quinizarine and NaOH concentrations and sample pH) and physical parameters (sample loop volume, carrier flow rate and reactor length) in order to establish better conditions in terms of sensitivity and sampling frequency. The results obtained showed that the concentration of DMSO in the reagent solution presents remarkable influence on the magnitude of analytical signal. Chemical species that could be found in the formulations such as Na(I), K(I), Mg(II), Ca(II), Ti(IV), Cl⁻, CO₃²⁻ e sodium dodecylsulfate were tested as possible interfering ions. Among them, only non-monovalent cations presented noticeable interference on lithium signal. However, they were not found in concentrations high enough to cause interference in the determination of lithium in the samples. Sample preparation was performed by sonicating a slurry prepared by dispersing 100 mg of powdered sample in 15 mL of 0.10 mol L⁻¹ HCl solution. Results obtained by developed methodology were not statistically different from those obtained by flame emission spectrometry. In the optimized conditions the method presented a linear range of 5-40 mg L⁻¹ and a relative standard deviation of 3.6% at 5 mg L⁻¹ Li concentration. Detection and quantification limits were 0.54 and 1.8 mg L⁻¹, respectively. Sampling frequency, calculated as the time interval passed between two consecutive injections, was 60 samples per hour. The methodology was successfully applied in the determination of lithium in three commercial samples.     

Sequential injection analysis for benzophenone-4 and phenylbenzimidazole sulphonic acid in sunscreen sprays by solid-phase extraction coupled with ultraviolet spectrometry

A sequential injection UV method was developed to determine benzophenone-4 (BZ4) and phenylbenzimidazole sulphonic acid (PBS) simultaneously, these being the most commonly used UV-filters in aqueous formulations used as sunscreen sprays. The selective elution of both was performed by on-line solid-phase extraction, by retention on a SAX microcolumn and separation by varying the pH of elution. The sensitivity obtained was 0.042±0.001 ml μg⁻¹ for PBS and 0.0159±0.0003 ml μg⁻¹ for BZ4. The limit of detection was 1.6 μg ml⁻¹ for PBS and 0.6 μg ml⁻¹ for BZ4. The R.S.D. of the results was 1-6% for PBS and 1-12% for BZ4. The method was validated using commercial sunscreen formulations with concentrations determined by a liquid chromatographic procedure. The two procedures gave comparable results. Automation of the method means the amount of reagents used and residues generated are decreased. The system allows the required analysis sequence to be programmed using suitable software.     

Formation of the surface charge on silica in mixed solvents

At sufficiently high concentrations of methanol and of alkali salts in aqueous silica dispersions, the negative -potentials of the particles are decreased. This effect is more pronounced with lithium than with other alkali cations, and it is independent on the anion. The NMR spectra indicate lithium adsorption on silica from mixed solvents, but not in the absence of alcohol.Supported by a contract with the XMX Corporation, Burlington, Massachusetts, USA     

Mechanism Study on Nanoparticle Negative Surface Charge Modification by Ascorbyl Palmitate and Its Improvement of Tumor Targeting Ability

Surface charge polarity and density influence the immune clearance and cellular uptake of intravenously administered lipid nanoparticles (LNPs), thus determining the efficiency of their delivery to the target. Here, we modified the surface charge with ascorbyl palmitate (AsP) used as a negatively charged lipid. AsP-PC-LNPs were prepared by dispersion and ultrasonication of AsP and phosphatidylcholine (PC) composite films at various ratios. AsP inserted into the PC film with its polar head outward. The pK_a for AsP was 4.34, and its ion form conferred the LNPs with negative surface charge. Zeta potentials were correlated with the amount and distribution of AsP on the LNPs surface. DSC, Raman and FTIR spectra, and molecular dynamics simulations disclosed that AsP distributed homogeneously in PC at 1–8% (w/w), and there were strong hydrogen bonds between the polar heads of AsP and PC (PO²⁻), which favored LNPs’ stability. But at AsP:PC > 8% (w/w), the excessive AsP changed the interaction modes between AsP and PC. The AsP–PC composite films became inhomogeneous, and their phase transition behaviors and Raman and FTIR spectra were altered. Our results clarified the mechanism of surface charge modification by AsP and provided a rational use of AsP as a charged lipid to modify LNP surface properties in targeted drug delivery systems. Furthermore, AsP–PC composites were used as phospholipid-based biological membranes to prepare paclitaxel-loaded LNPs, which had stable surface negative charge, better tumor targeting and tumor inhibitory effects.     

Sensing the ortho Positions in C6Cl6 and C6H4Cl2 from Cl2− Formation upon Molecular Reduction

The geometrical effect of chlorine atom positions in polyatomic molecules after capturing a low-energy electron is shown to be a prevalent mechanism yielding Cl₂⁻. In this work, we investigated hexachlorobenzene reduction in electron transfer experiments to determine the role of chlorine atom positions around the aromatic ring, and compared our results with those using ortho-, meta- and para-dichlorobenzene molecules. This was achieved by combining gas-phase experiments to determine the reaction threshold by means of mass spectrometry together with quantum chemical calculations. We also observed that Cl₂⁻ formation can only occur in 1,2-C₆H₄Cl₂, where the two closest C–Cl bonds are cleaved while the chlorine atoms are brought together within the ring framework due to excess energy dissipation. These results show that a strong coupling between electronic and C–Cl bending motion is responsible for a positional isomeric effect, where molecular recognition is a determining factor in chlorine anion formation.     

Gold Nanoparticles as Effective ion Traps in Poly(dimethylsiloxane) Cross-Linked by Metal-Ligand Coordination

At this time, the development of advanced elastic dielectric materials for use in organic devices, particularly in organic field-effect transistors, is of considerable interest to the scientific community. In the present work, flexible poly(dimethylsiloxane) (PDMS) specimens cross-linked by means of ZnCl₂-bipyridine coordination with an addition of 0.001 wt. %, 0.0025 wt. %, 0.005 wt. %, 0.04 wt. %, 0.2 wt. %, and 0.4 wt. % of gold nanoparticles (AuNPs) were prepared in order to understand the effect of AuNPs on the electrical properties of the composite materials formed. The broadband dielectric spectroscopy measurements revealed one order of magnitude decrease in loss tangent, compared to the coordinated system, upon an introduction of 0.001 wt. % of AuNPs into the polymeric matrix. An introduction of AuNPs causes damping of conductivity within the low-temperature range investigated. These effects can be explained as a result of trapping the Cl⁻ counter ions by the nanoparticles. The study has shown that even a very low concentration of AuNPs (0.001 wt. %) still brings about effective trapping of Cl⁻ counter anions, therefore improving the dielectric properties of the investigated systems. The modification proposed reveals new perspectives for using AuNPs in polymers cross-linked by metal-ligand coordination systems.     

A new interpretation of an event attributed to a magnetic monopole

An alternate and a new interpretation is given for the event attributed to a magnetic monopole by Price and coworkers found in an emulsion plastic sandwich stack flown from Sioux City, Iowa, USA on 18 September 1973. The electron pick-up and stripping cross-sections of nuclei ofZ∼70–80 andv∼0.6–0.7c in Lexan polycarbonate are calculated using the formulae given by Nikolaev. It is shown that the corresponding mean free paths are of the order of thickness (∼250μ) of Lexan plastic sheets used by them. In such a case asnapshot of these processes is believed to have been observed in plastic sheets. Monte-Carlo simulations of the event have been made for three values of charges at the top of the main Lexan stack, namelyZ=83, 78 and 70 respectively. The event is thus interpreted as a cosmic ray nucleus ofZ=70–83 andv=0.6–0.7c losing and capturing electrons (mainly the latter) as it passes through the stack. The probability of the occurrence of such an event is estimated by several methods.     

Like‐Charge Attraction: A Combined Electrostatic–Hydrodynamic Approach

Abstract

This article discusses the like‐charge attraction of colloidal spheres close to a charged plate and compares results produced by an electrostatic and a hydrodynamic model with experimental data. Hydrodynamic coupling is shown to be the dominating effect, while the electrostatic influence may often be neglected. Some observations, however, can be explained only by means of a combined electrostatic–hydrodynamic model, which is derived in this work. The combined model is able to predict not only the attractive force between particles of similar charge close to a charged plate but also the change to a purely repulsive force once the sphere‐plate distance is further reduced. This prediction matches qualitatively results of experiments reported in the literature.