GTSP重钙工艺减少反应料浆含水量的初步研究

1 引言 我国耕地严重缺磷的面积所占比例高达2/3,而目前施肥的磷/氮比例又远远低于国际平均水平,如此的比例失调将严重影响农业增产.在当前施用的磷肥中,普钙和重钙占了很大的比例.由于重钙是用磷酸而非硫酸酸解磷矿,所以不含硫酸钙杂质,有效五氧化二磷的含量也由16～21%提高到45～52%,肥效比普钙提高两到三倍.为此国家\"八五\"重点项目引进了Hy dro GTSP工艺2×40万吨/年重钙装置.该装置于1999年3月试车以来难以达到满负荷生产. 作者通过对生产工艺各环节的分析,指出反应料浆含水量偏高是影响装置生产负荷的主要因素.料浆中水分的重要来源之一是二次球磨.     

球磨法对不同基质上转换发光的影响

分别利用高温固相法和高能球磨法,在反应温度为1100℃、反应时间为2h的条件下合成了以Y₂O₃、La₂O₃、LiTaO₃为基质的双掺和三掺Tm³⁺、Er³⁺、Yb³⁺发光粉。XRD测试结果表明,高能球磨法制备的Y₂O₃、La₂O₃、LiTaO₃材料的相纯度高于高温固相法。用980nm红外激光分别对两种合成方法制得的样品粉末进行发光性质的检测,结果表明高能球磨法制得样品的发光强度高于高温固相法样品。不同基质样品的上转换发光性质表现为：Tm³⁺、Yb³⁺掺杂呈蓝光;Er³⁺、Yb³⁺掺杂呈黄光;Tm³⁺、Er³⁺、Yb³⁺三掺样品的发光减弱,颜色可调。     

一种新的振动叠加气动耦合加载技术

飞机机动飞行时,机体结构受到随机振动叠加气动的耦合载荷作用,有可能迅速产生破坏。为了考核在这种振动环境下飞机的结构强度及使用寿命能否达到设计要求,需要提供有效的地面试验验证手段和可靠的试验数据。本文研究了一种振动叠加气动的耦合载荷加载技术,通过液压球头传递振动载荷,同时通过气囊施加气动载荷,并设计进行了原理性验证试验。试验结果表明,这种耦合载荷加载技术可以避免过多改变试件自身的振动特性,同时可精确实现振动叠加气动的耦合载荷加载,真实模拟试验件的振动工作环境。此项技术可应用于现代战机的地面结构强度研究。     

Simple formulas for lattice paths avoiding certain periodic staircase boundaries

There is a strikingly simple classical formula for the number of lattice paths avoiding the line x=ky when k is a positive integer. We show that the natural generalization of this simple formula continues to hold when the line x=ky is replaced by certain periodic staircase boundaries—but only under special conditions. The simple formula fails in general, and it remains an open question to what extent our results can be further generalized.     

Nodeless variable finite element method for heat transfer analysis by means of flux-based formulation and mesh adaptation

Based on flux-based formulation, a nodeless variable element method is developed to analyze two-dimensional steady-state and transient heat transfer problems. The nodeless variable element employs quadratic interpolation functions to provide higher solution accuracy without necessity to actually generate additional nodes. The flux-based formulation is applied to reduce the complexity in deriving the finite element equations as compared to the conventional finite element method. The solution accuracy is further improved by implementing an adaptive meshing technique to generate finite element mesh that can adapt and move along corresponding to the solution behavior. The technique generates small elements in the regions of steep solution gradients to provide accurate solution, and meanwhile it generates larger elements in the other regions where the solution gradients are slight to reduce the computational time and the computer memory. The effectiveness of the combined procedure is demonstrated by heat transfer problems that have exact solutions. These problems are: (a) a steady-state heat conduction analysis in a square plate subjected to a highly localized surface heating, and (b) a transient heat conduction analysis in a long plate subjected to a moving heat source. The English text was polished by Yunming Chen.     

Construction of wavelet bases with vanishing movement

IntroductionFourieranalysisisanimpotenttoolinpuremath.andappliedmath.,fromwhichOrthogonalbasesinspaceLZcanbeconstl'Uctedstartingfrome'".Nevertheless,e'"hasnolocality,soFourieranalysiscannotbeusedtolocalityanalysis.Asacontrast,waveletpreservestheadvantagesofFourieranalysis,andmeanwhileamendsthedisadvantages,fromwhich,orthogonalbasesofspaceLZcanbebuildedstartingfromamotherwavelethavingnormalityandlocality,whichmakestheProjectonthebasesofsomenormaloperators,lineColderon-Zygmundoperator,almost…     

Calculating parameters for infiltration equations from soil hydraulic functions

Simple equations for predicting infiltration of water into soil are valuable both for hydrological application and for investigating soil hydraulic properties. Their value is greatly enhanced if they involve parameters that can be related to more basic soil hydraulic properties. In this paper we extend infiltration equations developed previously for positive surface heads to negative heads. The equations are then used to calculate infiltration into a sand and a clay for a range of initial and surface conditions. Results show errors of less than three percent compared with accurate numerical solutions. Analytical approximations to parameters in the equations are developed for a Brooks and Corey power law hydraulic conductivity-water content relation combined with either a Brooks and Corey or a van Genuchten water retention function. These are compared with accurate numerical values for a range of hydraulic parameters encompassing the majority of soil types and a range of initial and boundary conditions. The approximations are excellent for a wide range of soil parameters.An important attribute of the infiltration equations is their use of dimensionless parameters that can be calculated from normalised water retention and hydraulic conductivity functions. These normalised functions involve only parameters that it may be possible to estimate from surrogate data such as soil particle size distribution. Application of the equations for predicting infiltration, or their use in inferring hydraulic properties, then involves only simple scaling parameters.     

多关节人体上肢运动的优化轨迹预测

研究了手端无约束条件下,多关节人体上肢点到点运动优化轨迹的预测. 首先建立了多关节上肢平面运动的动力学模型,根据最小功准则提出优化目标函数,将上肢点到点运动的优化轨迹求解问题转化为两点边值问题,设计了寻优的迭代算法,求得了上肢运动的优化轨迹与相应的速度变化曲线. 仿真结果表明: 平衡点位置或关节力矩平滑地变化,避免了肢体出现急加速-急减速的运动形式,减少了肢体运动时的能量消耗;手端的运动轨迹为近似直线,速度为单峰的钟形曲线,这与上肢优化运动的特征相吻合,也表明最小功准则可以有效预测多关节上肢运动的优化轨迹.      

Ball spin generation for oblique impacts with a tennis racket

In this paper, we describe an experimental investigation of the oblique impact between a tennis ball and head clamped tennis racket. It was found that the magnitude of the ball rebound spin was not a function of the material, gage or tension of the string used in the tennis racket. Furthermore, it was concluded that all strings exhibit a sufficiently large friction coefficient that the ball begins to roll during impact. There is anecdotal evidence from tennis players that suggests that a high string tension or a rough string surface enable them to impart more spin to the ball. For example, players have been quoted as saying that a high string tension makes the strings “bite” into the ball, giving more spin. The data reported in this study do not support these observations. Analysis of the experimental data has shown that the balls are rebounding from the surface with more spin than would typically be associated with rolling. A second experiment showed that the balls commenced rolling at the mid-point of the impact. This information was used in a theoretical model to show that the spin that acts on the ball during the impact can be higher than the value of the rolling spin at the end of the impact.