Laurdan in Fluid Bilayers: Position and Structural Sensitivity

Laurdan (2-dimethylamino-6-lauroylnaphthalene) is a hydrophobic fluorescent probe widely used in lipid systems. This probe was shown to be highly sensitive to lipid phases, and this sensitivity related to the probe microenvironment polarity and viscosity. In the present study, Laurdan was incorporated in 1,2-dipalmitoyl-sn-glycero-3-[phospho-rac-(1-glycerol)] (DPPG), which has a phase transition around 41°C, and DLPC (1,2-dilauroyl-sn-glycero-3-phosphocholine), which is in the fluid phase at all temperatures studied. The temperature dependence of Laurdan fluorescent emission was analyzed via the decomposition into two gaussian bands, a short- and a long-wavelength band, corresponding to a non-relaxed and a water-relaxed excited state, respectively. As expected, Laurdan fluorescence is highly sensitive to DPPG gel–fluid transition. However, it is shown that Laurdan fluorescence, in DLPC, is also dependent on the temperature, though the bilayer phase does not change. This is in contrast to the rather similar fluorescent emission obtained for the analogous hydrophilic probe, Prodan (2-dimethylamino-6-propionylnaphthalene), when free in aqueous solution, over the same range of temperature. Therefore, Laurdan fluorescence seems to be highly dependent on the lipid bilayer packing, even for fluid membranes. This is supported by Laurdan fluorescence anisotropy and spin labels incorporated at different positions in the fluid lipid bilayer of DLPC. The latter were used both as structural probes for bilayer packing, and as Laurdan fluorescence quenchers. The results confirm the high sensitivity of Laurdan fluorescence emission to membrane packing, and indicate a rather shallow position for Laurdan in the membrane.     

基于超分子结构共掺杂纳米复合薄膜的制备与荧光特性

为改善功能分了的特性,提出一种基于金属纳米粒子-偶氮染料复合物共掺杂超分子结构功能材料的设计新方法.并依照此方法制备出复合材料,观测了其显微结构,测量了其紫外-可见光吸收,研究了该超分子结构复合体系的荧光特性.实验发现,由于金属银纳米粒子的掺杂,使得超分子结构复合体系中功能分子甲基橙在溶液态体系的荧光强度增强近5倍,而在两种不同结构(共混结构和包覆结构)的薄膜态超分子结构体系中,其荧光强度分别被猝灭15%和20%.研究结果表明,复合膜中采用超分子结构完全能够改善功能分子的特性.     

Electrical conduction and optical properties of amorphous (Sb2Se3)100−xSnx thin films

The variation of DC electrical conductivity and the optical properties of thermally evaporated a- (Sb₂Se₃)_100−xSn_x thin films with temperature have been studied. It is found that the thermal activation energy decreases, while the optical gap first increases (up to x=1) and then decreases, with the increase in Sn content. These results have been explained by taking into consideration the structural modifications induced by the incorporation of Sn into the parent alloy. The variation in the conductivity prefactor (σ_o) with Sn addition indicates a change in the dominant conduction transport mechanism from extended states to localized states. An experimental correlation between the activation energy and the pre-exponential factor has been observed, indicating the validity of Meyer–Neldel rule in the studied samples.     

Fe_3O_4单晶薄膜磁性电场调控的微磁学仿真研究

磁性薄膜磁学特性电场调控的相关研究对开发新型低功耗磁信息器件具有突出意义.本文基于电场调控磁性的基本理论,以OOMMF(Object Oriented Micro-Magnetic Frame)微磁学仿真软件为工具,研究了电场对生长于PZN-PT单晶衬底上Fe_3O_4单晶薄膜磁学特性的调控.研究结果显示:无外加电场时,薄膜表现出典型的软磁特性;沿衬底[001]方向施加的外加电场可以使得薄膜矫顽力、矩形比等磁学特性发生显著改变:当外加磁场沿[100]([010])时,施加正值(负值)电场强度可以显著增大薄膜的矫顽力与矩形比,当电场强度不小于0.6 MV/m时薄膜矩形比达到1.这是因为外加电场导致薄膜产生单轴应力各向异性,使得薄膜的等效磁各向异性发生了从无外电场下的面内四重磁晶各向异性向高电场下的近似单轴磁各向异性的过渡.外加1 MV/m与-1 MV/m的电场时等效易磁化轴分别沿[100]与[010]方向.另外,外加1 MV/m(-1 MV/m)的电场强度可以使得铁磁共振的频率增大(减小)接近1 GHz.     

基于BiFeO_3/ITO复合膜表面钝化的黑硅太阳电池性能研究

采用金属银辅助化学刻蚀法在制绒的硅片表面刻蚀纳米孔形成微纳米双层结构,以期获得高吸收率的太阳能电池用黑硅材料.鉴于微纳米结构会在晶硅表面引入大量的载流子复合中心,利用磁控溅射技术在黑硅太阳电池表面制备了BiFeO_3/ITO复合膜,并对其表面性能和优化效果进行了探索.实验制备的具有微纳米双层结构的黑硅纳米线长约180—320 nm,在300—1000 nm波长范围内入射光反射率均在5%以下.沉积BiFeO_3/ITO复合薄膜后的黑硅太阳能电池反射率略有提高,但仍然具有较强的光吸收性能;采用BiFeO_3/ITO复合膜的黑硅太阳能电池开路电压和短路电流密度分别由最初的0.61 V和28.42 mA/cm~2提升至0.68 V和34.57 mA/cm~2,相应电池的光电转化效率由13.3%上升至16.8%.电池综合性能的改善主要是因为沉积BiFeO_3/ITO复合膜提高了电池光生载流子的有效分离,从而增强了黑硅太阳电池短波区域的光谱响应,表明具有自发极化性能的BiFeO_3薄膜对黑硅太阳能电池的表面性能可起到较好的优化作用.     

Deposition of ZnS thin film by ultrasonic spray pyrolysis: effect of thickness on the crystallographic and electrical properties

Zinc sulfide (ZnS) thin films have been deposited on Si (1 0 0) substrate using ultrasonic spray pyrolysis. X-ray diffraction (XRD) analysis revealed that the films are (0 0 2) preferentially oriented with c-axis-oriented wurtzite structure. The crystallinity has been found to improve with film thickness in the 180–6000 nm range. Film structure has been analyzed by XRD, scanning electron microscope, FTIR, and Raman spectroscopies, while the stoichiometry has been verified by energy-dispersive spectroscopy and particle-induced X-ray emission techniques. Electrical properties of the grown films were characterized by current–voltage and capacitance–voltage measurements where, the films show better conducting behavior at higher thickness.     

Chitosan loaded with silver nanoparticles,CS‐AgNPs,using thymus syriacus,wild mint,and rosemary essential oil extracts as reducing and capping agents

The present study describes the green method for the preparation of chitosan loaded with silver nanoparticles (CS‐AgNPs) in the presence of 3 different extracted essential oils. The essential oils play dual roles as reductant and capping agents. The reducing power and DPPH (2,2‐diphenyl‐1‐picrylhydrazyl) assay for the 3 essential oils—Thymus syriacus (T), wild mint (M), and rosemary (R)—have been reported. The preparation of CS‐AgNPs was performed by 2 steps. The 3 previously extracted essential oils have been used as reducing and capping agent in the first step, while in the second step, silver nanoparticles were integrated in chitosan. The integration of AgNPs in the structure of chitosan was confirmed by ultraviolet‐visible, Fourier transform infrared spectroscopy, scanning electron microscopy techniques, and energy dispersive X‐ray. Surface plasmon resonance confirmed the formation of CS‐AgNPs with maximum absorbance at λ_max between 405 ‐ 410 and 410 ‐ 430 nm for colloidal and films of CS‐AgNPs, respectively. The intensity of bands at 3408 cm^?1 in the fourier transform infrared spectroscopy measurements was decreased substantially and shifted slightly to lower frequency (?υ = 43 cm^?1). Scanning electron microscopy shows a spherical morphology of AgNPs with size of 62 nm for both colloidal and film samples, and energy dispersive X‐ray analysis shows peaks confirming AgNPs formation.     

Conduction mechanism of metal-TiO2–Si structures

The conduction model has been proposed for the metal-TiO₂–Si (MIS) structures. Rutile films have been prepared on Si substrates by magnetron sputtering of TiO₂ target and annealing in the air at temperatures T?=?800 and 1050 K. The current-voltage (CVC) and capacitance-voltage characteristics of the structures have been measured over the range of T?=?283–363 K. At positive potentials on the gate, the conductivity of the MIS structures is determined by the space charge-limited current in the dielectric layer.     

Lowering the driving voltage and improving the luminance of blue fluorescent organic light-emitting devices by thermal annealing a hole injection layer of pentacene

We chose pentacene as a hole injection layer (HIL) to fabricate the high performance blue fluorescent organic light-emitting devices (OLEDs). We found that the carrier mobility of the pentacene thin films could be efficiently improved after a critical annealing at temperature 120 °C. Then we performed the tests of scanning electron microscopy, atomic force microscopy, and Kelvin probe to explore the effect of annealing on the pentacene films. The pentacene film exhibited a more crystalline form with better continuities and smoothness after annealing. The optimal device with 120 ℃ annealed pentacene film and n-doped electron transport layer (ETL) presents a low turn-on voltage of 2.6 V and a highest luminance of 134800 cd/m² at 12 V, which are reduced by 26% and improved by 50% compared with those of the control device.     

Effective dielectric constant model of electromagnetic backscattering from stratified air–sea surface film–sea water medium

Studies of surface film medium on the sea surface are carried out in this paper for developing the technology to automatically detect and classify sea surface films, and an effective dielectric constant model of electromagnetic backscattering from a stratified air–ocean interface. Numerical results of the new model show the characteristics of effective dielectric constants for the air–sea surface film–sea water medium as follows. The effective dielectric constants decrease with increasing relative dielectric constants of the sea surface films. The effective dielectric constants decrease in horizontal polarization(abbr. HH polarization) and increase in VV vertical polarization(abbr. VV polarization) with increasing radar incident angle. Effective dielectric constants vary with relative sea surface film thickness as a cosinusoidal function of sea surface film thickness. Effective dielectric constant of VV polarization is larger than that of HH polarization. Two potential applications are found with our model, i.e., the retrieval of dielectric constants from the sea surface film, and the film thickness retrieval with our model. Our model has a highly significant influence on improving the technology related to the remote sensing of sea surface films.