YIHn: A New Family of Metal‐rich Hydride Halides

The graphite‐like yttrium hydride halides, YIH_n (0.8 ? n ? 1.0), have been prepared in quantitative yields by heating either YI₃, YH₂ (1:2) or stoichiometric YI₃, YH₂, Y mixtures in sealed Ta ampoules at 900°C. A lower limit of the homogeneity range, n ≈ 2/3, has been determined from dehydrogenation experiments. All YIH_n phases adopt the ZrBr‐type heavy‐atom structure. The hydrogen variation is accompanied by a change in the c lattice constant from 31.162(3) to 31.033(1) Å for n = 0.61(3) to 1.02(3). The YIH_n phases reversibly react with hydrogen at 400‐600°C to form the light green transparent compound YIH₂. However, increasing the reaction temperature above 700°C causes decomposition to an unidentified phase being in equilibrium with YH₂ and YI₃. The arrangement of the heavy atoms in YIH₂ (P m1; a = 3.8579(3) Å, c = 10.997(1) Å) corresponds to a four‐layer I‐Y‐Y‐I slab with the stacking sequence (AbaB) as was found by x‐ray powder diffraction data refinement with the Rietveld method. A miscibility gap exists between YIH and YIH₂. Samples YIH_n (n ? 1.0) show metallic conductivity at room temperature, which changes into semiconducting behavior with decreasing temperature as n approaches its lower value ≈ 2/3.     

人参皂苷的基质辅助激光解吸质谱研究

利用MALDI-TOFMS测定了八种人参皂苷的分子量, 并分析了西洋参总皂苷的组成。同时, 进行了灵敏度实验, 并探讨了基质及碱金属离子的影响, 证明该方法灵敏度高, 重复性好, 结果准确。是测定极性小分子分子量的有效方法。     

Optimization of the extraction of paclitaxel from Taxus baccata L. by the use of microwave energy

A simple and rapid microwave-assisted extraction (MAE) procedure was developed and optimized for the extraction of paclitaxel (Taxol) from the needles of yew trees Taxus baccata L. grown in Iranian habitats. The samples, immersed in a methanol-water mixture, were irradiated with microwaves in a closed-vessel system. The method was evaluated using a factorial design approach based on parameters such as extraction time, temperature, methanol concentration in water (v/v), and the ratio of grams of sample to 10 mL of solvent. Statistical treatment of the results revealed that the selected parameters were all significant except the extraction time. Optimum conditions would be 1.5 g samples in 10 mL solvent (90% methanol), an extraction temperature of 95 degrees C, and an extraction time of 7 min. The extracts has been analyzed by reverse-phase high-performance liquid chromatography with UV detection (LC/UV) at 227 nm for quantification. Liquid chromatography-tandem mass spectrometry (LC-MS/MS) was used for confirmation. The main advantage of the proposed MAE method versus conventional solvent extraction (CSE) are the considerable reductions in time (7 min versus 16 h) and in solvent consumption (20 mL versus 150 mL). The MAE procedure yielded extracts that could be analyzed directly without any preliminary clean-up or solvent exchange steps. Both extraction methods show RSDs lower than 10% and lead to comparable recoveries of paclitaxel (87-92%).     

Deviation from Ohm's law in electric field assisted capillary liquid chromatography

Earlier studies of electric field assisted LC (EF-LC) have shown that the effect on charged analytes of the application of an electric field over a capillary LC column is relatively small. Charged analytes can only be affected by the electric field while present in the mobile phase, which makes the effective time for influence of the electric field t(0) independent of retention time. Because the charged analytes only can be affected for a short time the electric field strength ought to be high in order to increase the impact of the electric field on the separation. We have, however, found that only a relatively low electric field strength can be used in EF-LC when pressure is used as main driving force. The useful field strength was limited by a dramatic increase in the current. This increase in current was found to origin from an increased concentration of buffer ions that have an electrophoretic mobility towards the pumped flow.     

A comparison between different techniques for the isolation of rosemary essential oil

Traditional hydrodistillation (HD), supercritical fluid extraction (SFE), organic solvent extraction (SE), and water microwave assisted hydrodistillation (MAHD) techniques were compared and evaluated for their effectiveness in the isolation of rosemary essential oil. The microwave assisted hydrodistillation technique was optimized in terms of both delivered power and time duration. The extracts/distillates were analyzed by GC and GC-MS. Microwave distillation, which exploits the physical action of microwaves on plants, showed a series of advantages over the other approaches: low cost, use of water in sample pre-treatment step, greatly reduced isolation time, and attainment of high quality essential oil distillate. Moreover, the absence of environmental impact of this innovative technique was also emphasized.     

Use of blowing catalysts for integral skin polyurethane applications in a controlled molecular architectural environment: Synthesis and impact on ultimate physical properties

Polyurethane elastomers of a controlled molecular architecture were synthesized using a two‐step polymerization technique. The building blocks of the elastomeric materials included urea–urethane prepolymers end‐capped with diisocyanate groups and had an exact number of urea groups at both ends. Two‐dimensional bifurcated hydrogen‐bonding networks incorporating the urea groups were, with differential scanning calorimetric and dynamic mechanical thermal analyzer techniques, responsible for the increase in the glass‐transition temperature (T_g) of the hard block and sharp interface morphology between the pure “hard” domains and pure “soft” domains. The higher extent of the phase separation between the two phases contributed to higher elastic moduli for the hard blocks and higher tensile strength for the elastomeric samples. Higher elongation values were attributed to the liberation of the elastomeric chain ends that otherwise would have been constrained in the interface region. The higher T_g values of the hard blocks corresponded to an increase in the hardness values and a decrease in the tear‐strength values. The increase in the amount of urea groups within the hard segments, as a result of the increased amount of water and blowing catalyst, resulted in elastomeric foams with higher open‐cell content. This resulted in lower resilience values as measured using the pendulum rebound test and was attributed to the ability of the open cells to absorb and dissipate energy. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 2526–2536, 2002     

Synthesis and properties of novel poly(amide-imide)s containing pendent diphenylamino groups

A new dicarboxylic acid, 2,4-bis(N-trimellitoyl)triphenylamine, bearing two preformed imide rings was synthesized from the condensation of 2,4-diaminotriphenylamine and trimellitic anhydride at 1:2 molar ratio. A series of poly(amide-imide)s (PAIs) with inherent viscosities of 0.38-0.66 dl/g were prepared by triphenyl phosphite-activated polycondensation from the diimide-dicarboxylic acid with various aromatic diamines. All the resulting PAIs were readily soluble in a variety of organic solvents and formed strong and tough films via solution casting. These PAIs have useful levels of thermal stability associated with moderately high glass-transition temperatures (259-314 °C) and 10% weight loss temperatures in excess of 530 °C in nitrogen or in air.     

Glucose utilization by lysine-producing fluoroacetate-sensitive mutants ofCorynebacterium glutamicum

A fluoroacetate-sensitive mutant was isolated fromCorynebacterium glutamicum, ATCC 21513, following mutagenesis with NTG. Batch fermentations show that in terms of growth kinetics, glucose utilization, and lysine formation, there are significant differences between the mutant and the parent. The mutant’s specific growth rate (0.22/h) is lower than that for the parent (0.34/h). Also, the yield expressed as lysine/glucose consumed does not alter as a function of the glucose concentration for the mutant, and is about 0.22, whereas for the parent, this coefficient decreases with increasing glucose concentration. The maximum specific rate of lysine production for the mutant is 1.3 g/L/h that is about two-fold higher than that for the parent.     

The extraction,antioxidant and against β-amyloid induced toxicity of polyphenols from Alsophila spinulosa leaves

Alsophila spinulosa is a tree-like fern, and many evidences suggested that plant polyphenols had the potential therapeutic for Alzheimer s disease (AD). Herein, polyphenols (ASP) was isolated from A. spinulosa leaves and its major constituent were isoorientin and vitexin. ASP displayed excellent antioxidant activity and obvious anti-lipid peroxidation capacity in vitro. ASP improved the survival rate of C. elegans under high temperature by enhancing the antioxidant enzymes activities and decreasing the lipid peroxidation level. Moreover, ASP alleviated β-amyloid (Aβ) induced paralysis and reduced Aβ deposition, decreased reactive oxygen species (ROS) accumulation and improved the level of skn-1 mRNA. In addition, ASP decreased the levels of pdk-1 and akt-1 mRNA in P13K/AKT signaling pathway. In conclusion, ASP may be a potential ingredient for the alleviation of AD.