热处理对二氧化锰电化学行为的影响

以高锰酸钾和醋酸锰为前驱体, 通过液相沉淀法合成得到二氧化锰. 在不同温度热处理条件下研究二氧化锰的结构转变及其作为超级电容器电极材料的电化学行为. 采用X射线衍射(XRD), 扫描电镜(SEM), 氮气物理吸附和热重(TG)等手段表征产物的结构特点; 采用循环伏安和恒流充放电等方法表征其电化学行为. 结果表明: 合成的二氧化锰是具有中孔特征的α-MnO₂, 比表面积为253 m²·g^-1, 颗粒尺寸在50-100 nm之间. 350 °C以下的低温热处理使氧化锰仍能保持α-MnO₂的晶体结构, 比表面积为170 m²·g^-1左右, 单电极比电容值由原来未热解时的267 F·g^-1增加到250 °C热处理后的286 F·g^-1. 高温热处理(>450 °C)导致氧化锰逐渐过渡为α-Mn₂O₃, 且表面积下降约为30 m²·g^-1, 比电容急剧下降. 低温热处理后氧化锰的电化学稳定性明显提高, 在50 mV·s^-1的快速扫描速率下, 电极具有良好的倍率特性.     

高密度烃燃料四环[9.2.1.02,10.13,8]十四烷的合成及热裂解

以双环戊二烯和茚为原料,经D-A反应及催化加氢合成高密度烃燃料四环[9.2.1.02,10.13.8]十四烷(TDTD).采用裂解器及色质联用进行了四环[9.2.1.02.10.1 3.8]十四烷的热裂解研究,考察了不同温度及时间对热裂解转化率的影响,结果显示,温度对转化率影响较大.分析裂解产物,推测了裂解机理,以裂解...     

Synthesis and properties of a novel polyester containing bithiazole

A novel Schiff base type polyester containing 2,2’-diamino-4,4’-bithiazole(DABT) was prepared by low-temperature interface polycondensation of 1,4-benzenedicarbonyl dichloride with 4,4’-(4,4’-bithiazole-2,2’-diylbis(imine-2,1-diyl)diphenol(BDDP), which is derived from a 2,2’-diamino-4,4’-bithiazole(DABT) Schiff base reacted with a 4-hydroxybenzaldehyde monomer.The newly generated polyester was evaluated based on characterization of its solubility,FTIR spectroscopy,elemental analysis,X-ray diffraction measurements and thermogravimetric analysis(TGA) studies.     

Synthesis and characterization of a methacrylate polymer with side chain ketone and its derivatives

A new type of methacrylate monomer,2-(4-benzoylphenoxy)-2-oxoethyl methylacrylate(BOEMA) was synthesized.The radical homopolymerization of BOEMA was performed at 65℃in a 1,4-dioxane solution with benzoyl peroxide as an initiator.The oxime and thiosemicarbazone derivatives of poly[2-(4-benzoylphenoxy)-2-oxoethyl methylacrylate]poly(BOEMA) were prepared with hydroxylamine hydrochloride,and thiosemicarbazone hydrochloride, respectively.The monomer and its homopolymer were characterized with Fourier transform infrared and NMR techniques. The thermal stabilities of poly(BOEMA) and its derivatives were investigated with thermogravimetric analysis and differential scanning calorimetry.The ultraviolet stability of the polymers was compared.The antibacterial and antifungal effects of the monomer and the polymer and its derivatives were also investigated on various bacteria and fungi.The activation energies of the thermal degradation of the polymers were calculated with the Ozawa and Kissinger methods.     

V2O5负载量对V2O5/Al2O3氧化活化正庚烷催化裂解反应的影响

采用X射线衍射, 低温氮气吸脱附, 氨气程序升温脱附和吡啶吸附红外光谱分析方法对不同活性组分负载量V2O5/Al2O3的性质进行了表征. 根据表面VOx单元密度, 推测V2O5负载量为20%-25% (w)对应着V2O5/Al2O3表面达单层覆盖状态; V2O5的负载使Al2O3表面Lewis酸量减少, 并出现Br?nsted酸, 对应着氧化态VOx单元中的V―OH; 随着负载量的增加, Brφnsted酸量增加至负载量为20%时达到最大值. 对V2O5/Al2O3中活性组分负载量对其氧化活化正庚烷催化裂解反应的影响进行了考察. 结果表明, 在V2O5负载量为20%-25%时,V2O5/Al2O3的引入对正庚烷在HZSM-5平衡剂上催化裂解反应的促进作用最明显, 此时VOx单元在V2O5/Al2O3表面形成单层覆盖状态, 可提供最大量的表面晶格氧, 因而对正庚烷具有最强的氧化活化作用; V2O5负载量继续增加形成体相的V2O5和AlVO4, 不利于晶格氧参与正庚烷的转化, 因而反应性能有所下降.     

Ag负载TiO2纳米管微波辅助水热法制备及其光催化性能

以微波辅助水热法制备了二氧化钛纳米管,然后通过浸渍法在其表面负载了银纳米颗粒.所得样品用X射线衍射(XRD)、扫描电镜(SEM)、透射电镜(TEM)、氮吸附、X射线光电子能谱(XPS)、紫外-可见漫反射等测试方法表征.微波加热处理可以大大缩短反应时间,产物为无定型纳米管,经高温焙烧后转变成锐钛矿型二氧化钛.所得纳米管的外径为7-8 nm,内径为5-6 nm,管长约200 nm,比表面积可达371 m2·g-1.负载的银分散在纳米管的表面,对纳米管的结构与晶型没有影响,但是拓宽了二氧化钛的光吸收范围,使吸收边红移至可见光区,并且有效抑制了光生电子空穴的复合.在可见光降解罗丹明B的实验过程中,与Ag负载的P25及纯二氧化钛纳米管相比,Ag负载二氧化钛纳米管具有更高的可见光催化活性,并且当Ag/Ti 物质的量的比为0.5%时,可见光催化性能最好.     

[Cu2(C2O4)(C12H8N2)2(C3H7NO)2](ClO4)2配合物的合成及其热分解

以邻菲罗啉、2,5二羟基-1,4-二噻烷和Cu(ClO4)2.6H2O为原料,合成了中心对称的双核配合物[Cu2(C2O4)(C12H,N2)2(C3 H7NO)2](ClO4)2(1).通过红外光谱、元素分析等分析测试手段对其进行了表征;借助TG-DTG技术在氮气气氛下研究了配合物的热分解情况,并根据热分析结果确定了...     

Comparative study of the adsorption performance of an active multi-sorbent bed tube (Carbotrap, Carbopack X, Carboxen 569) and a Radiello(®) diffusive sampler for the analysis of VOCs

A simple comparison is made to evaluate the relative performance of active and passive sampling methods for the analysis of volatile organic compounds (VOCs) in ambient air. The active sampling is done through a multi-sorbent bed tube (Carbotrap, Carbopack X, Carboxen 569) created in our laboratory and the passive sampling through the Radiello^® diffusive sampler specified for thermal desorption (filled with Carbograph 4). Daily duplicate samples of multi-sorbent bed tubes were taken during a period of 14 days. During the same period of time, quadruplicate samples of Radiello^® tubes were taken during 3 days, 4 days, 7 days and 14 days. The sampling was carried out indoors during the months of February and March 2010 and outdoors during the month of July 2010 in La Canonja (Tarragona, Spain). The analysis was performed by automatic thermal desorption (ATD) coupled with capillary gas chromatography (GC)/mass spectrometry detector (MSD). The analytical performance of the two sampling approaches was evaluated by describing several quality assurance parameters. The results show that the analytical performances of the methodologies studied are quite similar. They display low limits of detection, good precision, accuracy and desorption efficiency, and low levels of breakthrough for multi-sorbent bed tubes. However, the two monitoring methods produced varying air-borne concentration data for most of the studied compounds, and the Radiello^® samplers generally gave higher results. Sampling rates (Q_k) were determined experimentally, and their values were higher than those supplied by the producer. As the experimental calculation of Q_k values is generally carried out by the suppliers in exposure chambers with only the target compounds present in the air samples, as well as in concentrations dissimilar to those found in ambient air, the use of constant settled Q_k can lead to inaccurate results in complex samples.     

Formation of double helix self-assembled monolayers of ethynylhelicene oligomer disulfides on gold surfaces

Optically active ethynylhelicene pentamers and hexamers linked by disulfide bonds were synthesized. They formed self-assembled monolayers (SAMs) with double helix structure on gold surfaces, which were analyzed by infrared reflection-absorption spectroscopy (IR-RAS), quartz crystal microbalance (QCM), surface plasmon resonance (SPR), and circular dichroism (CD). Double helix SAMs could be formed on gold surfaces either from double helices or random coils in solution. The double helices on the surface were more stable than in solution. This result suggested the presence of strong intercomplex interactions between double helix complexes on the surface.     

Improved functionality and control in the isomerization of a calix[4]arene-capped azobenzene

An improved azobenzene core capped by two calix[4]arene units isomerizes readily between trans and cis configurations via photochemical and/or thermal means. In addition, the presence of acid (particularly HCl) increases the rate of thermal cis→trans conversion. These enhancements to the functional response, control, and understanding of calixarene-capped azobenzene isomerization are important for future application in the dynamic encapsulation of small chemical species.