Dual‐mode hydrophilic interaction normal phase and reversed phase liquid chromatography of polar compounds on a single column

Adopting a stationary phase convention circumvents problematic definition of the boundary between the stationary and the mobile phase in the liquid chromatography, resulting in thermodynamically consistent and reproducible chromatographic data. Three stationary phase definition conventions provide different retention data, but equal selectivity: (i) the complete solid phase moiety; (ii) the solid porous part carrying the active interaction centers; (iii) the volume of the inner column pores. The selective uptake of water from the bulk aqueous‐organic mobile phase significantly affects the volume and the properties of polar stationary phases. Some polar stationary phases provide dual‐mode retention mechanism in aqueous‐organic mobile phases, reversed‐phase in the water‐rich range, and normal‐phase at high concentrations of the organic solvent in water. The linear solvation energy relationship model characterizes the structural contributions of the non‐selective and selective polar interactions both in the water‐rich and organic solvent‐rich mobile phases. The inner‐pore convention provides a single hold‐up volume value for the retention prediction on the dual‐mode columns over the full mobile phase range. Using the dual‐mode monolithic polymethacrylate zwitterionic micro‐columns alternatively in each mode in the first dimension of two‐dimensional liquid chromatography, in combination with a short reversed‐phase column in the second dimension, provides enhanced sample information.     

1H NMR和GC-MS法分析表征煤液化油

采用经典柱色谱法对煤液化循环油和“加氢”后的循环油进行族组成分离,将其分离成饱和烃、芳香烃和极性物3个组分,并用核磁共振波谱仪对各个组分进行定性分析,同时用气质联用分析方法初步确定了饱和烃和芳香烃两个馏分的主要物质组成。结果表明:循环油饱和烃部分主要由C12~C27直链烷烃组成,芳香烃部分主要组成是烷基取代的氢化单环芳烃及少量的多环芳烃。而循环油经420℃“加氢”后饱和烃部分除了含C12~C27的直链烷烃,还有一些直链烷烃的异构体和环烷烃,芳香烃部分主要是双环、三环、四环芳烃,单环芳烃则完全消失。     

Simulation of Organic Liquid Product Deoxygenation through Multistage Countercurrent Absorber/Stripping Using CO2 as Solvent with Aspen-HYSYS: Process Modeling and Simulation

In this work, the deoxygenation of organic liquid products (OLP) obtained through the thermal catalytic cracking of palm oil at 450 °C, 1.0 atmosphere, with 10% (wt.) Na₂CO₃ as a catalyst, in multistage countercurrent absorber columns using supercritical carbon dioxide (SC-CO₂) as a solvent, with an Aspen-HYSYS process simulator, was systematically investigated. In a previous study, the thermodynamic data basis and EOS modeling necessary to simulate the deoxygenation of OLP was presented. This work addresses a new flowsheet, consisting of 03 absorber columns, 10 expansions valves, 10 flash drums, 08 heat exchanges, 01 pressure pump, and 02 make-ups of CO₂, aiming to improve the deacidification of OLP. The simulation was performed at 333 K, 140 bar, and (S/F) = 17; 350 K, 140 bar, and (S/F) = 38; 333 K, 140 bar, and (S/F) = 25. The simulation shows that 81.49% of OLP could be recovered and that the concentrations of hydrocarbons in the extracts of absorber-01 and absorber-02 were 96.95 and 92.78% (wt.) on a solvent-free basis, while the bottom stream of absorber-03 was enriched in oxygenated compounds with concentrations of up to 32.66% (wt.) on a solvent-free basis, showing that the organic liquid products (OLP) were deacidified and SC-CO₂ was able to deacidify the OLP and obtain fractions with lower olefin contents. The best deacidifying condition was obtained at 333 K, 140 bar, and (S/F) = 17.     

强亚正交矩阵及其性质

推广正交矩阵得到了强亚正交矩阵的概念并讨论了它的性质.     

3D X-ray Micro-CT Analysis of Rebar Corrosion in Reinforced Concrete Subjected to a Chloride-Induced Environment

The paper presents experimental investigations of the concrete covers’ protective ability to counteract rebar corrosion in reinforced concrete cubes. The concrete sample was subjected to a chloride-induced environment to get corroded and combined with an un-corroded sample. The chloride-accelerated technique can induce a high degree of corrosion within a controlled time. Moreover, detailed and thorough experimental measurements and analyses of reinforcement loss due to corrosion and its influence on concrete microstructure, were studied through 3D X-ray micro-computed tomography. The rebar outside the concrete was heavily corroded due to the chloride-accelerated test, whereas, only local surface corrosion products appeared inside the concrete. It turned out that the concrete cover showed protective ability to counteract the reinforcing-steel corrosion mechanism despite the accelerated corrosion environment. Moreover, the bond strength between the reinforcement rebar and concrete was not visibly affected since the failure force in the pull-out test and failure mechanisms, observed by 3D X-ray micro-CT, were similar for corroded and un-corroded samples. The failure occurred due to radial cracks with a maximum width equal to approximately 0.25 mm.     

基于修正压力场理论的再生混凝土梁抗剪承载力计算方法研究

基于修正压力场理论分析有腹筋再生混凝土梁的剪切破坏机理,建立了更接近有腹筋再生混凝土梁实际受力的抗剪模型,并通过考虑再生骨料有效粒径和受箍筋作用下的裂缝宽度与构件裂缝处应力的联系,分析了再生骨料咬合力对梁斜截面抗剪性能的影响,提出了再生混凝土梁极限抗剪承载力的计算方法.此外,本文将理论结果与课题组自制的6根再生混凝土梁...     

Pressure drop effects on selectivity and resolution in packed column supercritical fluid chromatography

The influence of pressure drop on retention, selectivity, plate height and resolution was investigated systematically in packed supercritical fluid chromatography (SFC) using pure carbon dioxide as the mobile phase. Numerical methods developed previously which enabled the prediction of pressure gradients, diffusivities, capacity factors, plate heights and resolutions along the length of the column were used for the model calculations. The effects of inlet pressure and supercritical fluid flow rate on selectivity and resolution are studied. In packed column SFC with pure carbon dioxide as the mobile phase, the pressure drop can have a significant effect on resolution. The flow rate is shown to have a larger effect than generally realized. The calculated data are shown to be in good agreement with the experimental results. Finally, the variation of the chromatographic parameters along a 5.5 meter long model SFC column is illustrated. The possibilities and limitations of using long packed columns in SFC are discussed. It is demonstrated that long columns with large plate numbers do not necessarily yield better separations.     

组合式十字形钢管混凝土柱偏压力学性能试验研究

设计了一种由槽钢和方形钢管拼焊形成的组合式十字形钢管混凝土柱,将其灵活地布置在框架结构的中节点,可使柱肢与填充墙等厚,有效地提高建筑使用面积。共制作了6根组合式十字形钢管混凝土柱试件,考虑了偏心距和长细比两种变化参数。通过对其进行偏心受压试验研究,考察了试件的破坏形态和荷载-挠度曲线,并分析了其在不同偏心距和长细比下的荷载-应变曲线发展规律。结果表明:组合式十字形钢管混凝土柱中钢管和槽钢对混凝土的约束作用强,表现为较高的延性系数;偏心距或长细比越大,试件的极限承载力及弹性刚度越小,且偏心距越大延性越好,长细比对延性影响不显著;在受拉侧纵向应变基本上符合平截面假定,在受压侧纵向应变不符合平截面假定。     

不同材料弹体超声速侵彻钢筋混凝土靶的结构破坏对比实验

设计了超声速钻地结构弹,采用203 mm口径的火炮,开展了25 kg量级弹体在1100~1300 m/s速度范围内侵彻钢筋混凝土靶的实验研究,应用数值仿真对弹体侵彻钢筋混凝土靶的过程进行了模拟计算。基于实验和仿真结果,对超声速侵彻条件下两种金属材料弹体的结构响应、质量损失等问题进行了分析。结果表明:在超声速侵彻钢筋混凝土靶的过程中,两种金属材料的弹体结构变形破坏形式主要为头部侵蚀和侧壁磨蚀,头部侵蚀量的大小与弹体壳体材料有关,高强度G50钢材料更适合用于1200 m/s速度量级的超声速侵彻环境。对出现的“径缩”现象作了初步分析,并对今后工程应用的结构弹体设计提出了指导意见。     

烧结烟气脱硫脱硝用活性炭混合钢渣复合材料的光谱学分析

钢渣是冶金工业中产生的主要固体废弃物,其产量约为每年粗钢产量的15%~20%。由于技术的局限,导致我国钢渣利用率较低,仅为年钢渣产量的10%,同时加之管理制度的不健全,导致钢渣大量露天堆放,对土地资源、地下水源,以及空气质量形成严重影响。固体废弃物再利用是资源可持续发展的重要途径之一,钢渣的主要化学成分为CaO, SiO2, Al2O3, MgO, Fe2O3, MnO, f-CaO等。面对上述问题,利用冶金固体废弃物与活性炭开发一种价格低廉且性能优越的活性炭混合钢渣复合材料,既是冶金固体废弃物的高附加值利用与资源可持续发展的重要途径之一,也是大幅降低改性活性炭生产成本与提高经济效益的重要途径之一。该研究创新性以活性炭与钢渣为研究对象,利用钢渣中含有的金属氧化物对活性炭进行改性处理制备用于烧结烟气脱硫脱硝的活性炭混合钢渣复合材料,通过搭建实验反应装置对活性炭混合钢渣复合材料的脱硫脱硝性能进行测试。利用X射线荧光光谱仪(XRF)对钢渣的化学成分进行测试与分析,比表面积及孔径测定仪(BET)对活性炭混合钢渣复合材料的孔结构进行测试与分析,傅里叶变换红外光谱仪(FTIR)对钢渣的结构组成进行测试与分析,扫描电子显微镜(SEM)对活性炭混合钢渣复合材料的微观结构进行测试与分析,以揭示活性炭与钢渣制备活性炭混合钢渣复合材料的机理,以及活性炭混合钢渣复合材料对烧结烟气脱硫脱硝的机理。结果表明:当钢渣为电炉热泼渣、钢渣与活性炭质量比为2∶4、钢渣与活性炭细度为400目时,活性炭混合钢渣复合材料具有良好的脱硫脱硝性能与合理的经济性,即脱硫效率为100%、脱硝效率为58%。活性炭混合钢渣复合材料具有的多孔结构对SO2和NO进行有作用,钢渣中Fe2O3与MnO2促使活性炭官能团进行催化还原反应提高脱硫脱硝性能,其中吸附作用是主导与前提,催化还原反应是辅助与协同。以期为高附加值的钢渣利用提供新途径,实现钢铁企业以废治废、以废增效的目的。