Crystal structure of hexagonal SrAl2O4 at 1073 K

The crystal structure of SrAl₂O₄ at 1073 K was determined from conventional X-ray powder diffraction data using direct methods, and it was further refined by the Rietveld method. The structure was hexagonal (space group P6₃, Z=6) with a=0.89260(3) nm, c=0.84985(2) nm and V=0.58639(3) nm³. Final reliability indices were R_wp=7.87%, R_p=5.87% and R_B=4.19%. The [AlO₄] tetrahedra are linked to form trigonally distorted rings and they are joined in layers. These layers are stacked with a two-layer repeat and connected by the tetrahedral apices. All of the Sr atoms occupy the centers of the rings when viewed along the c-axis. The structure is described as a stuffed derivative of tridymite.     

丙烯环氧化制环氧丙烷Fe-Al-P-O催化剂的研究

用溶胶-凝胶法制得了Fe-Al-P-O催化剂，采用IR、XRD、TEM、BET、TPR和微反等技术研究了催化剂的物化性质和反应性能。实验结果表明，Fe1/2-Al1/2-PO4由10 nm左右 FePO4和AlPO4微晶组合而成，其晶格氧的活泼性大于单纯FePO4，AlPO4在Fe1/2-Al1/2-PO4中起到分散FePO4微晶的作用；Fe1/2-Al1/2-PO4的反应性能与原料气组成密切相关，丙烯与O2的选择氧化产物主要是丙烯醛，原料气中加入H2后，反应产物以环氧丙烷为主，同时还有部分丙烯醛，原料气中引入水蒸气后，可进一步增加环氧丙烷的选择性及减少丙烯醛的产率；在0.1 MPa、200 ℃、C3H6/O2/H2/H2O/N2=1∶1∶1∶1∶6（mol比）和空速1 200 h－1条件下，丙烯的转化率为8.9％，环氧丙烷的选择性为81.0％。     

相转移催化法合成糖苷化合物

糖苷化合物广泛存在于生物体内，中草药和天然药物中的许多抗病活性化合物也是糖苷化合物。根据糖苷化合物分子结构中的配糖体与糖环碳原子相连的原子类型可把糖苷化合物分为氧苷、氮苷、硫苷和碳苷等。未作特殊说明的糖苷化合物均指氧苷，且配糖体为羧酸的糖苷化合物亦称为糖酯。有关糖苷（酯）化合物和其合成方法的研究很多，其中应用相转移催化法较为常见。我们曾用相转移催化法合成过许多糖酯化合物并对其生理活性进行研究报道。本文在原合成糖酯的基础上通过相转移催化法，选用不同于文献报道催化剂及溶剂体系，     

Quantum scattering LCAC-SW theory studies on reaction probabilities of three-dimensional H + H2 (v, j) → H2 (v′, j′) + H reaction

Upon the Liu, Siegbahn, Truhlar, Horowitz (LSTH) potential energy surface, the reaction probabilities of the three-dimensional (3-D) state-to-state H + H₂ (v, j) →H ₂(v′, j′) + H reaction are calculated with the linear combination of arrangement channels-scattering wavefunction (LCAC-SW) method. In the calculation, the vibration function of H₂ and the radial propagating wave functions are expanded by the real Gauss functions. The calculated threshold energy and the resonating structure are consistent with the results of the accurate quantum scattering calculations, which shows the accuration, simplicity and practicability of the LCAC-SW method. Project supported by the National Natural Science Fondation of China and the Doctoral Foundation of the State Education Commission of China.     

Variational transition state theory without the minimum-energy path

In this paper we propose a method for carrying out variational transition state theory calculations without first obtaining a converged minimum-energy path (MEP). We illustrate the method in two ways, first of all by employing an unconverged MEP and secondly by using a dynamically optimized distinguished reaction path. Preliminary tests of the algorithm for the reactions OH+H₂→H₂O+H and C₂H₅→C₂H₄+H are very encouraging. Received: 22 January 1997 / Accepted: 11 March 1997     

均三氮苯类除草剂结构与活性的理论研究

利用Gaussian03程序包中的B3LYP方法,选择6-31G基组对均三氮苯类除草剂及类似衍生物2-(4-溴苄氨基)-4-甲基-6-三氟甲基-1,3,5-三氮苯进行了量子化学计算,从理论上讨论了它们的空间结构、电子结构特征与活性的关系.计算结果表明:三氮苯环与N(7)和N(8)原子形成了共轭结构,分子活性大小与LUMO轨道的得电子能力以及在LUMO轨道中占主要成分的原子有重要关系.N(7)和N(8)连接单个具有推电子能力的基团,有利于生物活性的提高.对于2-(4-溴苄氨基)-4-甲基-6-三氟甲基-1,3,5-三氮苯中,N(8)和C(9)是重要的活性部位,和传统的均三氮苯类除草剂分子相比,与D1蛋白上不同的氨基酸残基发生了键合作用.     

Isomers of C20: an energy profile III

Semiempirical calculations, at the PM3 level provided within the Winmopac v2.0 software package, are used to geometrically optimize and determine the absolute energies (heats of formation) of a variety of C(20) isomers that are predicted to exist in and around the ring and cage isomers. Using the optimized Cartesian coordinates for the ring and the cage isomers, a saddle-point calculation was performed. The resulting energy profile, consisting of a series of peaks and valleys, is used as a starting point for the identification and location of fifteen additional isomers of C(20) that are predicted to be energetically stable, both via geometry optimizations and force constant analysis. These additional isomers were subsequently determined to lie adjacent to one another on the potential surface and establish a step-wise transformation between the ring and the cage. Transition-state optimization of the Cartesian coordinates at the saddle point between adjacent isomers was performed to quantify the energy of the transition state. The step-wise process from one isomer to another, which extends out over the three-dimensional surface, is predicted to require approximately 15% less energy than that of the direct, two-dimensional transformation predicted in the bowl-cage profile. However, the net atomic rearrangement for the step-wise process is about four times greater than that of the direct process. Although less in energy, the amount of atomic rearrangement in the step-wise process would make the occurrence of such a route prohibitive. Utilizing the direct distance separating the three primary isomers (ring, bowl, cage), the method of triangulation is performed to quantitatively position other C(20) structures on the potential surface, relative to the ring, bowl, and cage isomers.     

Rapid Synthesis of Nanocrystalline TiO2/SnO2 Binary Oxides and Their Photoinduced Decomposition of Methyl Orange

A rapid and simple method, the so-called stearic acid method (SAM) was developed to prepare nanostructured TiO₂/SnO₂ binary oxides by combustion of stearic acid precursors. The preparative process was studied by Fourier transform infrared spectroscopy (FT-IR). During the preparative process, metal precursors were dispersed in stearic acid at molecular level. Microstructure of the samples was investigated by X-ray diffraction (XRD), transmission electron microscopy (TEM), BET specific surface area measurement and the results were compared with those obtained by conventional sol-gel method. The photocatalytic decomposition of methyl orange was used as a model system to determine the relative influences of the preparation method and the concentration of SnO₂ on the photocatalytic activities. It was found that preparative methods affected the crystalline structure of TiO₂/SnO₂ powders and the anatase phase of TiO₂ was stabilized by the addition of SnO₂ in SAM. The samples prepared by SAM showed better dispersity, larger specific surface area and the TiO₂/SnO₂ (r=0.15, SAM) catalyst showed higher photocatalytic activity than Degussa P25.     

Role of isoconversional methods in varying activation energies of solid-state kinetics: I. isothermal kinetic studies

Solid-state kinetics was developed from kinetic concepts for reactions in homogeneous phase systems, which has created considerable debate over issues such as variable activation energy. This behavior has been viewed by some as a violation of basic chemical kinetic principles. Variation in activation energy has been detected by isoconversional or ‘model-free’ calculation methods. The relationship between different calculation methods and the occurrence of variable activation energy was investigated in this work by employing model-fitting and isoconversional methods to analyze simulated isothermal data. In addition, these approaches were applied for sulfameter-dioxolane solvate desolvation data. We showed that variable activation energy is of two types—a true variation that results from the complex nature of the solid-state process and an artifactual one resulting from the use of some isoconversional methods.