3D X-ray Micro-CT Analysis of Rebar Corrosion in Reinforced Concrete Subjected to a Chloride-Induced Environment

The paper presents experimental investigations of the concrete covers’ protective ability to counteract rebar corrosion in reinforced concrete cubes. The concrete sample was subjected to a chloride-induced environment to get corroded and combined with an un-corroded sample. The chloride-accelerated technique can induce a high degree of corrosion within a controlled time. Moreover, detailed and thorough experimental measurements and analyses of reinforcement loss due to corrosion and its influence on concrete microstructure, were studied through 3D X-ray micro-computed tomography. The rebar outside the concrete was heavily corroded due to the chloride-accelerated test, whereas, only local surface corrosion products appeared inside the concrete. It turned out that the concrete cover showed protective ability to counteract the reinforcing-steel corrosion mechanism despite the accelerated corrosion environment. Moreover, the bond strength between the reinforcement rebar and concrete was not visibly affected since the failure force in the pull-out test and failure mechanisms, observed by 3D X-ray micro-CT, were similar for corroded and un-corroded samples. The failure occurred due to radial cracks with a maximum width equal to approximately 0.25 mm.     

基于修正压力场理论的再生混凝土梁抗剪承载力计算方法研究

基于修正压力场理论分析有腹筋再生混凝土梁的剪切破坏机理,建立了更接近有腹筋再生混凝土梁实际受力的抗剪模型,并通过考虑再生骨料有效粒径和受箍筋作用下的裂缝宽度与构件裂缝处应力的联系,分析了再生骨料咬合力对梁斜截面抗剪性能的影响,提出了再生混凝土梁极限抗剪承载力的计算方法.此外,本文将理论结果与课题组自制的6根再生混凝土梁...     

考虑塑性变形发展程度系数的RC梁开裂弯矩改进计算公式

针对RC梁开裂荷载计算方法尚未统一的现状,首先,结合18根RC梁试验数据对比了已有的6种RC梁开裂弯矩计算公式,发现开裂弯矩理论计算值与试验值的偏差大小和混凝土强度有关;然后,通过提出塑性变形发展程度系数k,推导新的RC梁开裂弯矩计算公式,并进一步基于k值和塑性影响系数计算值γ_k进行改进;最后,选取12根RC试验梁验证改进公式的准确性,证明改进公式的计算值与试验值吻合更好且偏于安全。     

NONLINEAR UNIFIED STRENGTH MODEL OF GEOMATERIALS

将材料的破坏归结为剪切破坏,每种材料对应于特定的剪切滑动面,抗剪强度为滑动面上正应力的函数,基于不同材料的强度特性将一系列的剪切滑动面统一起来,建立了岩土材料的非线性统一强度模型.非线性统一强度模型的滑动面为β应力空间内的等倾面,在β应力空间内的强度面为圆锥面;在普通应力空间内的强度面为一系列连续光滑、外凸的锥面,在偏平面上强度曲线涵盖了从下限Matsuoka-Nakai曲线到上限Drucker-Prager圆之间的所有区域,子午面上强度线为直线.非线性统一强度模型只有3个材料参数,参数都具有明确的物理意义,通过与国内外学者已取得的岩土类材料真三轴强度试验结果的比较,表明模型可适用于多种类型的材料,并合理描述其非线性强度特性.     

水泥聚苯模壳格构式混凝土墙体的抗侧性能试验及分析

论文介绍6片不同高宽比的水泥聚苯模壳格构式混凝土墙体在轴压力和水平往复侧推力作用下的试验,分析这种墙体的抗侧强度、刚度和延性等力学性能.试验表明,高宽比大于1的墙体破坏时表现为墙体跟部的单一水平裂缝,其他部位完好;高宽比3∶4的墙体破坏时存在多条通过格构梁柱的斜向裂缝,墙体裂缝分布密集,变形能力好.     

基于BP网络的混凝土耗能器骨架曲线拟合

结合5种混凝土延性柱耗能器在低周期反复荷载作用下的试验数据研究,利用神经网络的工作原理,通过建立神经网络的输入层、隐含层、输出层,确定输入单元、输出单元和隐含层节点数,从而建立了BP神经网络的模型,并根据已有的部分试验数据数据.对网络进行训练,对各种混凝土延性柱耗能器骨架曲线进行了预测拟合,实现混凝土延性柱耗能器骨架曲线的数字化,使其成为具有分析和判断的拟合曲线功能,完整的描绘混凝土延性柱耗能器的骨架曲线,为后续混凝土延性柱耗能器性能研究的仿真模拟提供了可靠的数据模型.结果表明,这种方法是可行的.     

含孔隙混凝土二维细观建模方法研究

根据混凝土的细观组成和结构特点,对传统二维建模方法加以继承与改进,提出了一种高效的分步入侵判定算法.将孔隙直观地反映在模型中,建立了不同的含孔隙混凝土细观模型.对含圆形、椭圆形、多边形骨料与圆形、椭圆形孔隙的混凝土标准试件分别进行了建模研究,结果表明本文的算法具有较强适用性.同时,通过对不同面积率与多种形状骨料/孔隙混凝土的大量建模进一步验证了该算法的效率.模拟了混凝土试件在单轴压缩下的准静态力学性能,分析了混凝土内部孔隙对其裂纹扩展的主要路径、破坏模式以及宏观力学性能的显著影响.     

复合材料弹侵彻混凝土靶的研究

 利用碳纤维复合材料壳体和金属弹头组成的复合弹体,对混凝土靶进行了高速侵彻实验,弹体分别以336、447和517 m/s的速度对强度为30 MPa、厚度为200 mm的混凝土靶进行正侵彻和30°斜侵彻。实验结果表明：碳纤维复合材料壳体具有较高的强度,在高速侵彻靶体的过程中弹体结构能够保持完整,复合材料壳体没有纤维分层和断裂产生。相对于同样结构尺寸的金属弹体（将复合材料壳体替换为密度7.8 g/cm³的金属材料）,复合材料弹填充物的质量分数（18.5%）约为金属弹体的两倍,因此采用轻质高强复合材料替代高密度金属弹身,不仅可以提高弹体装填比、增加比毁伤威力,而且还具有较高的侵彻能力。     

Behavior of concrete cylinders confined by carbon-composite tapes and prestressed yarns 1. Experimental data

The results of a comprehensive test program for the mechanical behavior of round concrete specimens confined by carbon-fiber epoxy tapes and prestressed carbon yarns are reported. Five different concrete batches of compressive strength from 20 to 100 MPa and the confinement of various thickness and pretension level were investigated. The specimens, which were subjected to monotonic or repeated compressive loadings, showed a nonlinear stress-strain behavior with a significant ductility and increased ultimate strength, in contrary to the brittle behavior of plain concrete. The limit of linearity on the stress-strain diagrams of the confined concrete roughly coincided with the ultimate strength of plain concrete. Above this limit, the damage accumulation and plastic deformations proceeded in the confined specimens. This fact was evidenced by the increasing slope of deformation diagrams in unloadings and repeated loadings and by the pronounced residual strains. The limit of linearity could be raised significantly by pretension of the carbon yarns during their winding. Russian translation published in Mekhanika Kompozitnykh Materialov, Vol. 42, No. 1, pp. 21–44, January–February, 2006.     

混凝土中的声发射波速特性及其在源定位中的应用

利用声发射技术监测受载混凝土裂缝发展特征的首要任务是对声发射源的准确定位.为了解混凝土中声发射波速特性,提高声发射源定位精度,该文开展了一系列室内试验,构建了考虑衰减现象的声发射波速修正模型,优化建立了基于修正波速的区域穷举定位法.结果表明:水灰比越小,基准波速越大,波速随距离的衰减越大.骨料粒径越大,基准波速越大,波...