Hydroxyapatite coating on porous silicon substrate obtained by precipitation process

Hydroxyapatite Ca₁₀(PO₄)₆(OH)₂ (HAP) is known as a bioactive and biocompatible material, HAP coatings were used to improve the biocompatible of substrate by many researcher, In this work, HAP thin films on porous silicon (PS) substrates have been prepared by aqueous precipitation method with rapid thermal annealing (RTA) processes. The HAP films had been prepared under the annealing temperature ranging from 300 to 1000 °C. By the measurement of X-ray diffraction (XRD), it was found that for the crystallinity optimization, the heat-treatment at 850–950 °C for 1 h would be favorable. Atomic force microscopy (AFM) and scanning electron microscope (SEM) measurements reveal a dense and smooth surface of the HAP film, and tightly adherence of the coating on porous silicon substrate after sintered. Thus, by this method, porous silicon could be increased its bioactivity and so that could be used in the biomedical area.     

On the origin of 1.5 μm luminescence in porous silicon coated with sol–gel derived erbium-doped Fe2O3 films

Sol–gel derived Fe₂O₃ films containing about 10 wt% of Er₂O₃ were deposited on porous silicon by dipping or by a spin-on technique followed by thermal processing at 1073 K for 15 min. The samples were characterized by means of PL, SEM and X-ray diffraction analyses. They exhibit strong room-temperature luminescence at 1.5 μm related to erbium in the sol–gel derived host. The luminescence intensity increases by a factor of 1000 when the samples are cooled from 300 to 4.2 K. After complete removal of the erbium-doped film by etching and partial etching the porous silicon, the erbium-related luminescence disappears. Following this, luminescence at 1.5 μm originating from optically active dislocations (“D-lines”) in porous silicon was detected. The influence of the conditions of synthesis on luminescence at 1.5 μm is discussed.     

Fractal porous media III: Transversal Stokes flow through random and Sierpinski carpets

The transversal Stokes flow of a Newtonian fluid through random and Sierpinski carpets is numerically calculated and the transversal permeability derived. In random carpets derived from site percolation, the average macroscopic permeability varies as (- _c)^3/2, close to the critical porosity _c. This exponent is found to be slightly different from the conductivity exponent. Results for Sierpinski carpets are presented up to the fourth generation. The Carman equation is not verified in these two model porous media.     

Zircon SHRIMP age of Mesoarchaean meta-argilloarenaceous rock in the Anshan area and its geological significance

In order to better understand the early continental evolution of the Anshan area, one ofthe typical Precambrian distribution areas of the North China Craton, the geochronology and REEcomposition of the zircons from the meta-argillo-arenaceous rock occurred as enclave in 3.1 GaLishan trondhjemite are studied by using SHRIMP ll ion microprobe. It is indicated that the Pa-leoarchaean is a very important continental formation period in the Anshan area and 3.2 Ga can beregarded as the boundary between the Paleoarchaean and Mesoarchaean.     

多孔硅的电化学制备

单晶硅在氢氟酸溶液中阳极氧化可制得多孔硅, 多孔硅是一种以新形态存在的硅, 与单晶硅相比, 它表现出独特的物理性质和化学活性。荧光光谱峰的蓝移表明, 在p-型低掺杂衬底硅上形成的多孔硅中存在量子尺寸效应, 新近获得的Raman光谱也证实了这一点。     

快速响应的温敏性聚(N-异丙基丙烯酰胺)水凝胶 Ⅰ.以CaCO_3为成孔剂制备方法、表征及动力学研究

以不同粒径的CaCO3粒子为成孔剂 ,合成了快速响应的温敏性聚 (N 异丙基丙烯酰胺 ) (PNIPA)水凝胶 .利用扫描电镜观察到水凝胶具有特殊的孔状结构 ,得到水凝胶的孔径大小为几十微米左右 .动力学研究表明 ,该水凝胶在温敏膨胀或收缩时 ,具有快速的响应速率 ,在 10min内的失水率可达 90 % .比较了干凝胶和4 0℃下失水后的凝胶两种不同状态下水凝胶的膨胀曲线 ,发现两者的溶胀动力学曲线明显不同 ,前者的曲线有拐点 .同时发现与失水收缩速率相比 ,水凝胶具有较慢的吸水膨胀速率 .     

Copolymer of Di (methacryloyloxymethyl) naphthalene and divinylbenzene as a column packing for high-performance liquid chromatography

Summary A new porous polyaromatic ester packing was synthetized for high performance liquid chromatography. The relationship between retention and chain length of the members of homologous series of alkylbenzenes, N-alkylanilines, alkylarylethers, alkylbenzoates and alkylarylketones on this new stationary phase using different eluents was investigated. Using the alkylarylketone scale the retention indices of the homologues and test compounds were calculated. The results were compared with those obtained for poly (styrene-divinylbenzene) polymers. For both types of packing the first members of each homologous series gave non-linear behaviour. The methylene group index increments are different for the studied homologous series; thus there is no simple additivity of the retention indices. The efficiency of the porous polymeric columns is a function of the capacity factor of the solute and the organic component of the eluent.     

Studies on the porous structure of di(methacryloyloxymethyl) naphthalene-divinylbenzene copolymers by inverse exclusion chromatography

Summary Using inverse exclusion chromatography the porous structure of the copolymers of di(methacryloyloxymethyl)naphthalenes and divinylbenzene was investigated.In order to determine the pore size distributions of the copolymers, toluene, alkylphenones, phthalates and polystyrene standards were used as the probes.The measurements proved that the existence of micropores depend on the method of copolymerization. The copolymers obtained by suspension and emulsion methods are more or less microporous, but the copolymer prepared by thermal polymerization in mass does not include micropores in its internal structure.     

Rapid analysis of triterpenic acids by liquid chromatography using porous graphitic carbon and evaporative light scattering detection

An original system which uses Porous Graphitic Carbon as support and a mixture of organic solvents as mobile phase is proposed for the analysis of triterpenic acids by liquid chromatography. The separation of betulinic acid, ursolic acid, oleanolic acid, and 18alpha- and 18beta-glycyrrhetinic acids was carried out within a short time and monitored by evaporative light scattering detection as universal detection method. Molecular modelling studies show that the main contribution to the selectivity comes from the electrostatic interaction characterised by the dipole moment of the products.