微流控技术制备微胶囊负载钯催化剂

采用微流控技术结合悬浮聚合方法实现了百微米级含膦配体聚苯乙烯微胶囊的可控制备, 微胶囊尺寸在320~420 μm范围内可调, 且单分散性好. 扫描电子显微镜、能量散射光谱和电感耦合等离子发射光谱结果证实了其形貌和组成的均匀性及钯负载的可控性和有效性. 以溴代芳烃与苯硼酸的Suzuki偶联反应为模型反应评价了负载Pd(PPh₃)₄的百微米级微胶囊的催化性能, 发现其性能与文献报道的7~8 μm的同类催化剂微胶囊接近, 且均优于均相催化剂; 该催化剂经简单过滤后, 可实现多次循环使用, 未发现活性物种的流失. 该法实现了连续制备, 因而有助于提高制备的效率和可控性. 另外, 所制百微米级催化剂微胶囊在固定床反应器内具有较高催化剂浓度和机械性能, 且优于浆态床中使用的微米级催化剂微胶囊.     

分散第二相Al_2O_3对高分子固体电解质电性能的影响

于固体电解质PEO＿NaSCN络合物中加入Al2O3绝缘体作为第二相,分别研究了Al2O3的粒径,含量对该固体电解质电性能的影响.发现当Al2O3的粒径小于1μm时,离子电导率比纯的固体电解质的电导率高,大于1μm时,则比纯样品的低,即临界粒径约为1μm.当Al2O3的含量达到约25%时,电导率达到极大值.此外,样品的高频极化和低频极化也随Al2O3的粒径的增大而越显著.     

INFLUENCES OF ACID POST-TREATMENT ON THE MORPHOLOGY OF SOAPFREE P（MMA-EA-MAA） PARTICLES PREPARED BY SEEDED EMULSION POLYMERIZATION

Soap-free poly（methyl methacrylate-ethyl acrylate-methacrylic acid） latex particles with narrow size distribution were synthesized by seeded emulsion polymerization, and the porous particles were created by a stepwise alkali/acid treatment method. Effects of acid treatment conditions on the particle morphology were investigated. Results show that one to three pores were formed inside most of particles after post-treatment. At pH 7.0, when the treatment temperature was lower than 70℃, the size of particles and the volume of pores remained almost unchanged, and these two values increased significantly when the temperature was higher than 70℃. Both the particle size and the pore volume decreased with the increase of initial pH value and treatment time in the acid treatment. As the pH was below 4.0 and the treatment time was longer than 180 min, the particles shrunk in size.     

功能单体α-烯烃磺酸钠用于无皂乳液共聚合

用工业原料α-烯烃磺酸钠(AOS)作为功能单体与甲基丙烯酸甲酯(MMA)和丙烯酸丁酯(BA)进行了乳液共聚合,通过测定AOS与MAA的竞聚率,确定了适宜的聚合方式为连续加料法.使用5%AOS制备了高固含量(>60%)的胶乳,并与用十二烷基硫酸钠(SDS)作乳化剂时该体系的乳液共聚合进行了比较.AOS是影响乳液稳定性和胶粒大小的主要因素,当AOS含量为单体总质量的1%时可以得到固含量大于40%粒径小于100 nm的乳液;当AOS含量为5%时可以得到固含量大于60%的乳液.两种情况下胶粒粒径分散性均较窄,明显优于同样条件下用SDS制备的胶乳.使用1%AOS制得的胶乳静置1年后粒径及其分布基本保持不变.     

CE characterization of semiconductor nanocrystals encapsulated with amorphous silicium dioxide

The electrophoretic mobility of silica-encapsulated semiconductor nanocrystals (quantum dots) dependent on the pH and the ionic strength of the separation electrolyte has been determined by CE. Having shown the viability of the approach, the electrophoretic mobility mu of the nanoparticles investigated is calculated for varied zeta potential zeta, particle radius r, and ionic strength I employing an approximate analytical expression presented by Ohshima (J. Colloid Interface Sci. 2001, 239, 587-590). The comparison of calculated with measured data shows that the experimental observations exactly follow what would be expected from theory. Within the parameter range investigated at fixed zeta and I there is an increase in mu with r which is a nonlinear function. This dependence of mu on size parameters can be used for the size-dependent separation of particles. Modeling of mu as function of I and zeta makes it possible to calculate the size distribution of nanoparticles from electrophoretic data (using the peak shape of the particle zone in the electropherogram) without the need for calibration provided that zeta is known with adequate accuracy. Comparison of size distributions calculated via the presented method with size histograms determined from transmission electron microscopy (TEM) micrographs reveals that there is an excellent matching of the size distribution curves obtained with the two independent methods. A comparison of calculated with measured distributions of the electrophoretic mobility showed that the observed broad bands in CE studies of colloidal nanoparticles are mainly due to electrophoretic heterogeneity resulting from the particle size distribution.     

Microfluidic differential resistive pulse sensors

This study demonstrates an on-chip resistive pulse-sensing scheme with a design of symmetric mirror channels, which significantly reduces the noise and achieves better signal-to-noise ratio. Polystyrene particles of different sizes have been detected with the developed sensing scheme and a record low volume ratio of the particle to the sensing channel, or 0.0004%, has been detected with particles of 520 nm in diameter in a sensing aperture of 50x16x20 microm3. This volume ratio is about ten times lower than the lowest volume ratio reported in the literature including that specified for commercial Coulter counters.     

泡沫铝夹芯双圆管结构的准静态轴向压缩性能研究

对泡沫铝夹芯双圆管结构的准静态轴压性能进行了实验研究,发现该新型结构的比质量吸能效率远远高于传统的泡沫铝夹芯单管,并接近甚至超过相应的空管结构;其内外管变形模式均与空管不同且受内外管组合的影响.本文讨论了它的变形机理,分析了外管壁厚对其压缩行为的影响,发现增大外管壁厚有利于增大结构的行程利用率,提高结构的比质量能量吸收...     

高分子溶液壁湍流减阻机理的TRPIV实验研究

利用高时间分辨率粒子图像测速技术(TRPIV)对回流式水槽中低浓度高分子溶液壁湍流的减阻机理进行实验研究。通过对比分析高分子溶液和纯水平板湍流边界层在相同来流速度下的平均速度剖面、湍流强度和雷诺应力,发现高分子溶液的壁面摩擦阻力减小了21.77%,并且其缓冲层增厚,按对数律外移,雷诺应力减小;高分子聚合物主要在近壁区起到抑制湍流脉动的作用,而在主流区的作用不太明显。用流向局部平均多尺度速度结构函数和相干结构条件采样方法,检测并对比了高分子溶液和水的壁湍流相干结构“喷射”和“扫掠”事件中的脉动速度、展向涡量、雷诺应力等物理量的二维拓扑形态,发现高分子溶液近壁区相干结构在猝发时的脉动速度减小,涡量受到抑制,雷诺应力明显减小,说明高分子溶液湍流近壁区相干结构“喷射”和“扫掠”的强度变弱,猝发频率降低,动量和能量的输运减弱,揭示出高分子溶液减阻的重要机理。     

Identification and control of nonlinear systems by a dissimilation particle swarm optimization-based Elman neural network

In this paper, we first present a learning algorithm for dynamic recurrent Elman neural networks based on a dissimilation particle swarm optimization. The proposed algorithm computes concurrently both the evolution of network structure, weights, initial inputs of the context units, and self-feedback coefficient of the modified Elman network. Thereafter, we introduce and discuss a novel control method based on the proposed algorithm. More specifically, a dynamic identifier is constructed to perform speed identification and a controller is designed to perform speed control for Ultrasonic Motors (USM). Numerical experiments show that the novel identifier and controller based on the proposed algorithm can both achieve higher convergence precision and speed than other state-of-the-art algorithms. In particular, our experiments show that the identifier can approximate the USM's nonlinear input–output mapping accurately. The effectiveness of the controller is verified using different kinds of speeds of constant, step, and sinusoidal types. Besides, a preliminary examination on a randomly perturbation also shows the robust characteristics of the two proposed models.     

海冰动力学数值模拟中改进的PIC方法

为了准确地模拟海冰的动力过程,需要建立精确有效的数值方法。本文结合质点网格法(PIC)和光滑质点流体动力学方法(SPH)发展了一种改进的PIC方法。该方法在欧拉坐标下对海冰动量方程进行差分计算,在拉格朗日坐标下进行海冰质点位移、厚度和密集度计算,并采用Gauss函数进行欧拉网格点与拉格朗日质点间海冰参数的交互插值。采用改进的PIC方法对规则区域内的海冰堆积过程进行了数值试验,对渤海海冰的动力过程进行了72小时数值模拟。计算结果均表明改进的PIC方法具有计算量小,计算结果平稳精确的优点,可很好地适用于海冰动力作用过程的数值模拟。