具有可调紫外滤光性能的富勒烯胺/壳聚糖共混膜的研究

通过溶液共混及流涎成膜法制备了一系列不同C60乙醇胺含量的壳聚糖共混膜。以及含Cu（Ⅱ）的C60乙醇胺/壳聚糖共混膜。研究表明，C60乙醇胺/壳聚糖共混膜具有优异的可调紫外滤光性能，随着C60乙醇胺含量的增加，其紫外滤光波长从200nm红移至400nm左右。在该复合体系中引入Cu（Ⅱ）能有效改善膜的紫外光学性能，同时还初步探讨了这类复合材料的紫外滤光机制。     

γ-辐照对纯Y_2SiO_5和Eu~(3+)∶Y_2SiO_5晶体光谱性能的影响

研究了γ-辐照前后纯Y2SiO5和Eu3+掺杂的Y2SiO5晶体吸收光谱的变化,辐照后,未退火和氢气退火的纯Y2SiO5晶体在260~270 nm和320 nm波段产生了附加吸收峰,分别是由F心和O-心的吸收引起的;经过空气退火的纯YSO晶体中,由于消除了氧空位,因此辐照后没有出现色心吸收峰。在Eu3+∶Y2SiO5晶体中,不但有相同的F心和O-心吸收峰,而且还有Eu2+离子在300 nm和390 nm的吸收峰。随着辐照剂量的增加,色心附加吸收峰增强。空气退火能减少Eu3+∶Y2SiO5晶体中的色心,而氢气退火能增加色心。     

Survivability in IP-over-WDM Networks: WDM Lightpath Protection versus IP LSP Protection

This article compares the performance of WDM lightpath protection and IP LSP protection schemes for IP-over-WDM networks. A mathematical formulation of the maximum throughput problem is presented and analytical expressions for recovery time are derived for both schemes. The throughputs and recovery times are analyzed and compared. Results show that the IP LSP protection scheme presents higher throughputs then WDM lightpath protection. The IP LSP protection scheme, providing individual IP LSP protection has, however, scalability problems. This scheme presents high recovery times when a failure affects many lightpaths and many hops are allowed for the primary routes of IP LSPs.     

机载海洋激光测深系统参量设计与最大探测深度能力分析

详细讨论了机载海洋激光测深系统最大测量深度与相关因子之间的关系，并利用最小可探测信噪比为判据，对机载海洋激光测深系统在白天和晚上工作进行了数值模拟，通过比较最大测量深度与激光脉冲峰值功率、接收视场角、接收口径和光谱接收带宽等关系，确定了系统的主要参量。以确定的参量建立的系统具有白天49m和晚上65m的最大测深能力，可完全满足在沿岸带以及岛礁的测量要求。     

数码相机CMOS图像传感器的特性参数与选择

介绍了数码相机的核心器件———CMOS图像传感器的特性参数和在数码相机设计过程中CMOS图像传感器的选择。选择CMOS图像传感器,不仅需要考虑包括传感器的尺寸、像素总数和有效像素数、最小照度、动态范围、灵敏度、分辨力、光电响应不均匀性以及光谱响应等在内的特性参数,而且还要考虑电源管理和功耗、模数转换位数、开发的简便性以及成本等因素。     

Hexaphyrin(1.0.1.0.0.0). A new colorimetric actinide sensor

Hexaphyrin(1.0.1.0.0.0) (isoamethyrin) undergoes a significant color change in the presence of UO₂²⁺, PuO₂²⁺, and NpO₂²⁺. The complexation of the first of these dioxo actinide cations was studied in semi-quantitative fashion in 1:1 MeOH-CH₂Cl₂. Under these conditions, the detection limit for UO₂²⁺ was found to be ca. 5.8 ppm by naked eye monitoring and <28 ppb by UV-vis spectroscopy. Isoamethyrin does not undergo a color change in the presence of most transition metals or when exposed to Gd(III). Isoamethyrin thus constitutes an attractive alternative to 2,2′(1,8-dihydroxy-3,6-disulfonaphthylene-2,7-bisazo)-bisbenzenarsonic acid (AzIII) and 2-(5-bromo-2-pyridylazo)-5-(diethylamino)phenol (BrPADAP), systems currently used as actinide cation sensors.     

光纤传感振动检测系统及其实验研究

实际工程结构中的振动检测是十分重要的，也是十分复杂的，常用的结构振动检测传感器易受工程现场恶劣环境的影响．而光纤传感器具有小巧、抗电磁干扰、灵敏度高、适合长期监测等优点。本文建立了基于马赫—曾德(Mech-Zehnder)干涉原理的光纤传感振动检测系统．研制了运用先进的数字信号处理技术采集和处理数据的专用软件，并在典型结构件——钢制悬臂梁结构上进行了外加信号作用下的强迫振动检测和冲击载荷作用下的自由衰减振动检测，测量了该结构件的频率及振幅，其结果与同时进行的成熟的电测结果相近，说明光纤传感器用于结构件的振动测量是可靠的。本文为光纤传感器应用于实际工程的振动检测提供了新的技术装置，具有工程应用前景。     

Photorefractive Four-Wave Mixing Switches Utilizing Pockels Effect -Longitudinal and Lateral Switches-

We carried out detailed calculations for photorefractive wave-mixing switches based on one of three crystals with high electro-optic coefficients, namely, BaTiO₃, Strontium Barium Niobate (SBN (0.75)), and Potasium Sodium Strontium Barium Niobate (KNSBN). A comparison of results for the three crystals shows that a 0_-cut BaTiO³ crystal is suitable for a longitudinal switch and requires a voltage of about 80 for a 2-mm-thick crystal to induce sufficient phase mismatch. The electrodes must be transparent for the incident and diffracted beams. A 45_-cut SBN (0.75) crystal, however, is suitable for a lateral switch and requires a voltage of about 150 for a 1-mm-wide crystal. The electrodes do not need to be transparent.     

Measurements of Time-Varying Characteristics of Optical Signals and Inhomogeneities of Tested Substances with Additional Phase Modulation

The problem of investigation of the amplitude and phase structure of a time-varying probing optical signal and the structure of time-varying inhomogeneities of a substance tested by this signal is considered. The analysis is concerned, in particular, with determination of the structure of signals and processes with resolution in the pico- and femtosecond range. The scheme used for the analysis is based on registration of four spatially separated spectra of the studied radiation. The spectra are formed in a four-channel scheme with a twin-wave Michelson interferometer and a spectral device. Modulators based on electrooptical crystals (perovskites) are placed in the channels. The sum spectra are formed: without modulators, with the effect of either of the modulators, and with both of them affecting the radiation. The effect of the studied substance implies either modulating the radiation (in this case it is described by multiplication) or redistributing the radiation (then it is described by convolution).     

Φ520mmF/1.6椭球面反射镜加工

介绍了一块Φ520mm大相对孔径(F/1.6)轻量化椭球面反射镜的加工与检测方法。镜面的有效口径为Φ502mm,顶点曲率半径为1600mm,非球面系数k=-0.9663,面形精度要求优于0.025λ(RMS)。镜子背面有54个大小深浅不一的不通孔,用于减轻镜子的重量。采用WYKO干涉仪检测得到镜面面形误差达RMS0.02λ,λ=632.8nm。