Stochastic resonance characteristic analysis of new potential function under Levy noise and bearing fault detection

Based on the output saturation of classcial bistable stochastic resonance (CBSR), a new type of piecewise nonlinear bistable stochastic resonance (PNBSR) system is constructed. The mean signal-to-noise ratio gain is regarded as an index to measure the stochastic resonance phenomenon. The laws for the resonant output of piecewise nonlinear bistable system governed by l, c, a, b and D of Levy noise are explored under different characteristic index α and symmetry parameter β of Levy noise. The results show that the output of PNBSR system has increased 4?dB by comparing with the output signal-to-noise ratio of CBSR system. And the stochastic resonance phenomenon can be induced by adjusting the piecewise nonlinear system's parameters under any α or β of Levy noise. The interval of the parameters of system which induces good stochastic resonance is roughly the same. And the output signal waveform of resonance is very similar to the input signal waveform, which has some reference value for the signal recovery. Moreover, we can find the good stochastic resonance interval of the system parameters do not change with D of Levy noise under the different noise intensity D of Levy noise. On the basis of this, adjusting the intensity amplification factor D of Levy noise, which induces good stochastic resonance, and the interval does not change with α or β. At last, the piecewise nonlinear bistable system is applied to detect bearing fault signals, which achieves better performance compared with the classical bistable system.     

Effects of duty ratio at low frequency on growth mechanism of micro-plasma oxidation ceramic coatings on Ti alloy

The aim of this work is to study the effects of duty ratio on the growth mechanism of the ceramic coatings on Ti-6Al-4V alloy prepared by pulsed single-polar MPO at 50 Hz in NaAlO₂ solution. The phase composition of the coatings was studied by X-ray diffraction, and the morphology and the element distribution in the coating were examined through scanning electron microscopy and energy dispersive spectroscopy. The thickness of the coatings was measured by eddy current coating thickness gauge. The corrosion resistance of the coated samples was examined by linear sweep voltammetry technique in 3.5% NaCl solution. The changes of the duty ratio (D) of the anode process led to the changes of the mode of the spark discharge during the pulsed single-polar MPO process, which further influenced the structure and the morphology of the ceramic coatings. The coatings prepared at D = 10% were composed of a large amount of Al₂TiO₅ and a little γ-Al₂O₃ while the coatings prepared at D = 45% were mainly composed of α-Al₂O₃ and γ-Al₂O₃. The coating thickness and the roughness were both increased with the increasing D due to the formation of Al₂O₃. The formation of Al₂TiO₅ resulted from the spark discharge due to the breakdown of the oxide film, while the formation of Al₂O₃ resulted from the spark discharge due to the breakdown of the vapor envelope. The ceramic coatings improved the corrosion resistance of Ti-6Al-4V alloy. And the surface morphology and the coating thickness determined the corrosion resistance of the coated samples prepared at D = 45% was better than that of the coated samples prepared at D = 10%.     

光学外差探测信噪比研究

对于光学外差探测系统而言,为了有效利用回波信号,需要对信噪比这一表征系统性能的重要指标进行研究。从理论分析了信噪比,给出了计算信噪比的一般公式。理论分析表明,当探测器光敏面上本振光与信号光的振幅、相位、偏振都满足严格的匹配时,外差效率最大。对场分布为艾里函数的光外差信噪比进行研究和数值模拟。结果表明,当艾里斑尺寸的比例系数控制在0.8~1.2内,并使信号光斑主轴偏移量x0控制在0.5以下,探测器的尺寸在(0.6~0.8)λf/d内时,可获得大于0.7ηPs/hνB的信噪比。     

地面目标红外特性及其隐身技术研究

随着红外搜索与制导技术的飞速发展,对于地面目标红外特征及其隐身技术的研究具有越来越重要的军事意义.在简化目标传热模型的基础之上,计算出目标的瞬时温度变化,并与背景的温度比较发现,目标与背景在一天之中均存在明显温差,最大温差可达10℃.从目标与背景的辐射对比度出发,分析了辐射对比度与目标表面发射率以及目标与背景温差的关系,发现了当目标与背景温差控制在±4℃之内时,采用固定发射率涂料可以使目标达到红外隐身的目的.     

Parameter-induced stochastic resonance in an over-damped linear system

Stochastic resonance (SR) in an over-damped linear system subjected to an excitation of bias signal modulated noise with multiplicative and additive noises is investigated. We obtain the exact expressions of the first two moments and the signal-to-noise ratio (SNR) of the output by using linear-response theory. The SNR depends non-monotonically on the intensity and the correlation time of multiplicative noise, the correlation time of additive noise, the intensity of the cross noise between multiplicative and additive noise, as well as the external field frequency. The conventional SR, the SR in a broad sense and the bona fide SR are found in the system. The influences of the asymmetries of multiplicative and additive noise, the correlation rate of the cross noise, the intensity of additive noise, the amplitude of signal and the bias on the SNR are analyzed. Moreover, we pointed out that SR can be realized by tuning the system parameter with fixed noise, i.e., parameter-induced stochastic resonance (PSR) exists.     

冰洲石-玻璃组合平行分束偏光镜的设计研究

为了既节省稀有昂贵的冰洲石晶体材料，又实现偏振光的大剪切差输出，采用冰洲石晶体与光学玻璃组合的方法，设计了一种新型平行分束偏光镜。该棱镜的前后半块分别为ZBaF₃玻璃和冰洲石晶体，由大折射率液态胶合剂溴代萘胶合而成。实验测试表明：该棱镜透射的2束平行光的消光比，o光可达10^－5；尽管受到光学玻璃的影响，e光的消光比仍优于10^－3；透射比均与纯冰洲石晶体材料的棱镜基本相当。理论分析表明：该棱镜自身结构带来的性能影响在一定情况下完全可以忽略，因此具有较好的应用前景。     

Improvement in magnetic properties of La substituted BaFe12O19 particles prepared with an unusually low Fe/Ba molar ratio

In this study, effect of lanthanum substitution on the phase composition, lattice parameters and magnetic properties of barium hexaferrite has been studied in samples synthesized in ammonium nitrate melt. Samples, prepared with different lanthanum amount and having various initial Fe/(Ba+La) ratios in between 12 and 2 {(Ba_1−xLa_x)·n Fe₂O₃, where 0≤x≤1 and 1≤n≤6)}, are sintered at temperatures from 800 to 1200 °C. The lattice parameters, both a and c, decreases with increasing La amount which results in a decrease of the unit cell volume. The scanning electron microscope micrographs show that the pure and La-substituted sample with x=0.3, both calcinated at 1000 °C, have grain sizes smaller than 1 μm. The coercivities of the La-substituted samples increase with increasing La amount and reaches to a maximum value of 5.73 kOe, when x=0.3. Sintering at higher temperatures (above 1000 °C) decreases the coercivity, resembling a transition from single to multi-domain behavior of the particles, while saturation magnetization of the samples continues to increase due to the increasing grain size. Magnetization measurements of the samples prepared with different Fe/(Ba+La) molar ratios, n's, revealed that the specific saturation magnetization slightly increases with decreasing n, while coercivities fluctuates around 5.5 kOe. However, a sharp increase in the saturation magnetization has been observed in the sample having n=1 and washed in HCl. It was measured as 59.2 emu/g at 15 kOe, which is higher than that of the pure sample (57.5 emu/g). Thus, the magnetic parameters are optimized in the sample Ba_0.7La_0.3Fe₁₂O₁₉ so as to maximize both coercivity and specific saturation magnetization in the HCl-washed sample synthesized by starting with an unusually low Fe/(Ba+La) molar ratio of 2 (or n=1).     

类铍离子内壳激发态1s2p3 3P0、3D0及2s2p3 3D0 的俄歇宽度和俄歇分支率

采用鞍点变分方法和鞍点复数转动方法并考虑相对论修正和质量极化效应,计算了类铍离子内壳激发态1s2p3 3P0、3D0和内壳双激发态2s2p3 3D0的俄歇宽度、俄歇分支率和俄歇电子能量.同时还对1s22p2 3Pe态到1s2p3 3P0、3D0态(Z=4~10)的振子强度和辐射跃迁率进行了计算,计算结果与其他理论结果以及实验数据符合得很好.     

基于半导体光放大器的干涉型器件中噪声特性的分析

分析了基于半导体光放大器(SOA)的干涉仪分别处于“开”、“关”两种工作状态时的输出信噪比及噪声指数,发现当干涉仪处于“开”态时输出信噪比有所恶化,并导出了附加噪声因子的表达式。实验结果进一步证明了理论分析的正确性。