This letter reviews the adhesive and frictional properties of the first mushroom-shaped adhesive microstructure (MSAMS), which has come a long way from inspiration by the attachment devices evolved in beetles to a large-scale industrial production. It was shown to have an that about twice higher pull-off force compared to a smooth control made from the same material measured on smooth substrates. Pull-off forces measured underwater are even higher than those in air. Moreover, it retained adhesive performance over thousands of attachment cycles and initial adhesive capability could be recovered by washing after being contaminated. In shearing, MSAMS exhibits reduced and stabilized friction in comparison with a smooth control, which demonstrated pronounced stick-slip motion, and shows zero pull-off force in a sheared state, allowing the adhesion to be switched on and off. The presence of a fluid in the contact zone showed adhesion enhancement on both smooth and rough substrates. All these features lead us to conclude that MSAMS may have practical potential in a variety of applications. 相似文献
Platelets play a fundamental role in thrombus formation and in the pathogenesis of arterial thrombosis. Patterning surfaces for controlled platelet adhesion paves the way for adhesion and activation mechanisms in platelets and detection of platelet functional defects. Here, a new and simple method based on controlled polymerization of 2‐methacryloyloxyethyl phosphorylcholine (MPC) on the surface of styrene‐block‐(ethylene‐co‐butylene)‐block‐styrene (SEBS) is shown. The competition between polymerization and degradation enables platelet adhesion on SEBS to be switched on and off. The adhesive sites of the platelets can be down to single cell level, and the dysfunctional platelets can be quantitatively detected.
A robust and effortless procedure is presented, which allows for the microstructuring of standard cell culture dishes. Cell adhesion and proliferation are controlled by three‐dimensional poly(ethylene glycol)‐dimethacrylate (PEG‐DMA) microstructures. The spacing between microwells can be extended to millimeter size in order to enable the combination with robotic workstations. Cell arrays of microcolonies can be studied under boundary‐free growth conditions by lift‐off of the PEG‐DMA layer in which the growth rate is accessible via the evolution of patch areas. Alternatively, PEG‐DMA stencils can be used as templates for plasma‐induced patterning.
In lyotropic systems, the sponge and the lamellar phases possess the same local structure: a membrane made of a bilayer of surfactants. In the quasiternary lyotropic system CPCl/brine/hexanol, the bilayer is continuous through the interface between the lamellar and the sponge phases. A model based on this phenomenon has predicted a very low value of the interfacial free energy. The study of hydrodynamic relaxation time of distorted spherical lamellar droplets gives an estimation of the interfacial tension value. Results confirm the validity of the model and the dependence on membrane volume fraction is explained by a simple scaling law. 相似文献
The effect of solvent purity on the synthesis and yield of bisphenol A tetrachlorocyclotriphosphazene (BATCCP) has not been described in the literature. The purpose of this research was to synthesize BATCCP hybrid monomers and to evaluate the effect of solvent purity on the BATCCP production. BATCCP monomers were prepared by an interfacial procedure in a water/toluene system as a function of time with the assistance of a phase transfer catalyst, tetraoctylammonium bromide. 1H and 31P NMR confirmed the production of BATCCP monomer by the appearance of chemical shifts at 7.18 and 5.35 ppm in the 1H NMR and 23.4 and 13.9 ppm in the 31P NMR, respectively. Distillation of the toluene, not suggested in previous reports of HCCP hybrid synthesis, resulted in an improvement of actual % yield to 40% and stability of the product throughout the 1440 min reaction as confirmed by MALDI, compared with an 11% actual yield at 15 min, decaying to 2% over a 1440 min reaction when the synthesis was performed with ‘anhydrous toluene’ as provided commercially without further distillation. 相似文献