Advanced Materials Processing by Adsorption Control

Precise control and knowledge of surface structures are essential inorder to meet the requirements of today's and future materials. One possiblegrowth technique capable of meeting the requirements is atomic layer epitaxy(ALE). ALE is based on sequentially applied saturated gas-solid reactions,which provide the means for adsorption controlled material deposition atatomic layer level. In this paper the potentiality of the use of porousmaterials in a detailed study of adsorption controlled growth is discussed.At the same time the study promotes the application of adsorption controlledmaterials processing for advanced catalysts manufacturing.     

Scanning tunneling lithography of silicon nanoparticle films

Monolayer and bi-layer silicon nanoparticle (SiNP) films with wide band gaps (up to 4 eV) have been produced in UHV with narrow size distributions of particles with 2-4 nm diameters and were studied using scanning tunneling microscopy (STM) and spectroscopy (STS). The films then were manipulated by applying different values for the tunneling resistance. Nanoparticle fusion and fission processes allow to shape the particles in the films in various ways and to write in white and black on the film template.     

单轴晶体包层啁啾光纤光栅中电光效应和弹光效应的理论研究

提出了以单轴晶体材料为包层,光轴平行于光栅主轴(z轴)的新型啁啾光纤光栅模型,应用耦合模理论和传输矩阵方法在理论上分析了该类光纤光栅中的电光效应和弹光效应,理论研究发现在包层施加沿光栅轴向的电场和应变场可以改变布拉格波长和反射谱。得到了3种不同单轴晶体为包层时布拉格波长λB和反射光谱随外加电场和应变场变化的曲线。研究结果表明当轴向外加电场从1×107V/m变化到8×107V/m时λB减小0.12nm,当外加应变场从0变化到0.04时,λB减小0.45nm。     

Hybrid passive/active absorbers for flow ducts

A new type of acoustic liner developed for broadband noise reduction in flow ducts is considered in this paper. It combines passive absorbent properties of a porous layer and active control at its rear face. The complete design procedure of this hybrid passive/active liner is developed here. The passive part is first considered with the determination of a suitable porous material and the cut-off frequency separating the active low frequency regime from the passive high frequency one. The control system is then presented: a digital adaptive feedback control is performed independently cell by cell, allowing an easy subsequent increase of the liner surface. The entire optimization process has been successfully applied to a laboratory flow duct: both predictions and measurements show the interest of the hybrid liner to reduce the noise radiation.     

固体材料反斯托克斯荧光制冷的理论研究及其最新进展

本文首先回顾了反斯托克斯荧光制冷的历史发展,简单讨论了激光制冷的循环过程及其制冷条件;其次,概述了反斯托克斯Raman散射、反斯托克斯荧光制冷的热力学理论和热力学限制,重点介绍了适用于各种制冷材料(如稀土离子掺杂玻璃、半导体和晶体等)反斯托克斯荧光制冷研究的理论模型,并简单讨论了激光制冷实验中各种测量温度变化的实验方法及其基本原理。最后,就反斯托克斯荧光制冷的一种最新应用及其前景进行了简单介绍与展望。     

Size-dependent linear and non-linear optical response of single carrier two-dimensional quantum dots

We explore the pattern of size dependence of linear and non-linear optical (NLO) responses of one-electron quantum dots in two dimensions with or without anharmonicity in the confinement potential. For some fixed values of transverse magnetic field strength (ω_c) and harmonic confinement potential (ω₀), the influence of the size of the dot on the linear (), the first (β) and the second (γ) NLO responses of the system computed through a finite field linear variational route is analysed. Size-dependent maximization is predicted to be feasible for the quadratic hyperpolarizability.     

A new photoluminescence emission peak of ZnO-SiO2 nanocomposites and its energy transfer to Eu ions

This work reports a new photoluminescence (PL) emission peak at about 402 nm from amorphous ZnO nanoparticles in a silica matrix, and the energy transfer from it to Eu³⁺ ions. The amorphous ZnO-SiO₂ nanocomposites were prepared by the sol-gel method, which is verified by X-ray diffraction (XRD) profiles and FT-IR spectra. The luminescence emission spectra are fitted by four Gauss profiles, two of which at longer wavelength are due to the defects of the material and the others to amorphous ZnO nanoparticles and the Zn-O-Si interface state. With the reduction of Zn/Si ratio and diethanolamine, the relative intensities of visible emission decrease. The weak visible emission is due to the reduction of defects after calcined at high temperature. The new energy state at the Zn-O-Si interface results in strong emission at about 402 nm. When Eu³⁺ ions are co-doped, weak energy transfer from ZnO-SiO₂ nanocomposites to Eu³⁺ emission are observed in the excitation spectra.     

Asymmetric electrical properties in Pt/Ba0.5Sr0.5Ti0.99Co0.01O3/Nb-doped SrTiO3 capacitors

Ba_0.5Sr_0.5Ti_0.99Co_0.01O₃ (BSTC) thin films have been fabricated with pulsed laser deposition on Nb-doped SrTiO₃ (STN) substrate. In Pt/BSTC/STN capacitor, we systematically investigated the capacitance, leakage current and polarization versus bias voltage characteristics, and found that curves of capacitance versus voltage and leakage current versus voltage were not symmetric, and polarization hysteresis loop exhibited large relaxation of the remnant polarization at negatively poled state. A detailed analysis of capacitance data demonstrated a difference of the built-in voltage between top Pt/BSTC interface (V_b,t=2.5 V) and bottom BSTC/STN interface (V_b,b=1.1 V). Such different built-in voltages lead to the presence of an internal electric field, which results in asymmetric electric characteristics in Pt/BSTC/STN capacitor.     

光折变材料的带隙结构研究

利用光子晶体的概念和时域有限差分方法计算了当光折变材料的空间折射率呈一维正弦变化时其内部的带隙结构情况,表明在光折变材料中存在极窄的光子带隙。最后讨论了折射率(n)、折射率调制幅度(△n)、周期长度(D)及周期数(N)对光子带隙的影响。     

Structural and optical properties of waveguides in YbVO4 crystals formed by 3.0 MeV Cu-ions implantation

We report on the structural and optical characterization of waveguides formed in YbVO₄ crystals by Cu²⁺-ion implantation with an energy of 3.0 MeV and doses of 3.0×10¹⁴-1.0×10¹⁵ ions/cm². The damage properties are determined by RBS/Channeling measurements with the help of simulation code RUMP. The m-line method is used to characterize the dark-mode spectroscopy in the planar waveguides. According to the reconstructed refractive index profile of the waveguide cross section, a numerical simulation is carried out to investigate the confinement of the light in the waveguides based on the beam propagation method.