约束状态下聚能杆流对混凝土作用的实验研究

聚能杆流是多级串联战斗部次级装药的常用聚能侵彻体.基于两种典型的聚能装药结构,设计加工了有不同直径和深度预制约束孔的C35混凝土靶板,开展了(Φ60mm亚半球和K装药在不同约束状态侵彻毁伤混凝土对比实验研究.结果表明,两种聚能杆流都可在混凝土孔约束状态下形成大且深的侵彻孔;随约束孔径增大,侵彻深度先减小而后增加;随约束...     

杆弹侵彻钢纤维混凝土实验研究

采用DOP实验方法,进行了35CrMnSiA杆弹对不同钢纤维体积含量的钢纤维混凝土的侵彻实验.分别研究了杆弹着速和钢纤维体积含量对钢纤维混凝土杭侵彻性能的影响.实验表明,随着弹速增加,不同钢纤维含量的钢纤维混凝土侵彻深度都会增加,但钢纤维混凝土中弹体便深增加较素混凝土缓慢;而钢纤维能增强混凝土的抗侵彻性能,且随钢纤维体...     

长杆高速侵彻的特征控制参量分析

针对理想长杆侵彻,通过对长杆侵彻Alekseevskii-Tate模型近似解进行分析,指出单一的无量纲速度衰减系数α（deceleration index）不足以完全表征长杆高速侵彻的准定常阶段。在此基础上,重新定义了2个无量纲特征参量:Johnson破坏数Φ_Jp和特征时间系数β,2个参量之间的关系为α=β/Φ_Jp。分析表明,Φ_Jp和β（或α和β）可实现对长杆高速侵彻准定常阶段的弹尾速度的完全表征;若再引入长杆弹相对临界速度v_c*,则可完全表征长杆侵彻的准定常阶段。此外,还证明了α能够判定侵彻过程偏离定常状态的程度,并指出通过确定Φ_Jp和β（或α和β）,可针对攻防需求对长杆弹侵彻设计进行指导。     

A novel analog fuzzy controller for intelligent sensors

A new analog fuzzy logic controller implemented in CMOS technology is described. The chosen membership function generator keeps the needed area for the inference engine very small while giving a big flexibility in the configuration of the membership function. The proposed solution for defuzzification gives an additional area reduction over earlier implementations. High speed, low power fuzzy controller hardware make the chip appropriate for intelligent sensor application. Simulation results as well as test measurements are presented and discussed to illustrate the properties and robustness of the proposed circuit.     

MgB2超导薄膜的微波测量

报道了利用蓝宝石介质谐振器技术测量MgB2超导薄膜的微波表面电阻Rs、OK时的穿透深度λ(O)和超导能隙△(O)．λ(O)和△(O)的值是通过先测量样品穿透深度λ(T)的变化量△λ(T)，然后由BCS理论模型拟合△λ（T)的实验数据得到的．测试样品是利用化学气相沉积技术在MgO(111)基片上制备的c轴织构的MgB2超导薄膜，薄膜的超导转变温度和转变宽度分别为38K和0．1K．微波测试结果表明在10K，18GHz下MgB2薄膜的Rs约为100μΩ，可以和高质量的YBCO薄膜的Rs值相比拟；BCS理论拟合得到的MgB2超导薄膜的λ(0)=102nm，△(0)：1．13kTc．     

超导体磁场穿透深度测量中的数据分析问题

讨论了目前在超导体磁场穿透深度λ测量中常用的几种数据分析方法.着重指出对于那些只能测量λ随温度的变化值Δλ(T),而无法测量其绝对值的实验而言,一种合适的数据分析方法对于我们从实验中得出正确的结论尤其重要.而微分归一法将有效地克服目前此类实验中常用数据处理方法的不足,从而实现理论与实验间的无参量比较. 关键词： 超导体 磁场穿透深度     

Magnetic measurement of transport AC losses in Bi-2223/Ag tapes

Magnetic nature of the losses in superconducting wire carrying AC current implies that it should be possible to determine these losses in a contactless way. Ribbon-like samples are quite favorable for such an experiment, because a notable portion of magnetic flux related to losses ‘escapes' the sample volume and can be detected by an appropriate pick-up coil. In this case, a model describing the AC current penetration into the tape, based, e.g., on the critical state model, allows one to derive the losses from the pick-up coil signal. Because this signal is proportional to the number of coil turns, extension of the accessible range of measured voltages (and losses) can be achieved. We demonstrate the data obtained on a 1 cm long portion of a low-loss multifilamentary tape carrying AC current with frequency 35 Hz. The pick-up coil technique allowed us to reach loss level more than one order below the experimental limit for direct measurements.     

快速制取人体组织病理切片的超声波法

本文介绍了用超声波方法快速制妈人体组织病理切片的基本原理，实验步骤和试验结果。结果表明，用超声波处理后快速制取的病理切片完全怀可常规石蜡切片相媲美，在临床外检快速病理诊断应用上，超声处理仪有可能取代价格昂贵的恒温式冷冻切片机。     

An approach to high-speed micro-HPLC

The possibility of high-speed micro-HPLC has been investigated using a short micro-column (35 mm × 0.5 mm i.d.) packed with 3 μm ODS particle. The results indicate that this approach has considerable potential for good separations with short analysis time. A typical example shows only three minutes is required with a plate count of 3,800 to separate seven PAHs.