Thermal conductance for single wall carbon nanotubes

We report a theoretical analysis of the phonon thermal conductance, κ(T), for single wall carbon nanotubes (SWCN). In a range of low temperatues up to 100 K, κ(T) of perfect SWCN is found to increase with temperature, approximately, in a parabolic fashion. This is qualitatively consistent with recent experimental measurements where the tube-tube interactions are negligibly weak. When the carbon-carbon bond length is slightly varied, κ(T) is found to be qualitatively unaltered which implies that the anharmonic effect does not change the qualitative behavior of κ(T). Received 12 June 2001     

关于半线性热方程的死角性质

本文考虑下述问题：这里，．本文证明了在发生死角时只有有限个死角点．     

Matrix effects in the determination of butyltin compounds in environmental samples by GC AA after hydride generation

Experiments for the determination of mono-, di and tri-butyltin (MBT, DBT and TBT) by hydride generation/gas chromatography/atomic absorption spectrometry in various matrices (sediment, suspended matter, mussel, algae and water) have revealed that poor butyltin recoveries are obtained in sediments displaying high sulphur and hydrocarbon contents; very poor recoveries were also observed for TBT in sediments with high chlorophyll pigment contents as well as in algal samples. It was however not clear whether the hydride generatin was inhibited by these infering compounds, as was previously assumed in the case of hydrocarbons, or whether interferences affected the atomization rate. Further studies were performed to solve this problem in order to validate this method in the case of analyses of, for example, oil-contaminated sediment and algae. This paper presents the results obtained. It is concluded here that the poor recoveries were due to an inhibition of hydride generation rather than to interference at the atomization stage.     

用激活性非线性介质Nd：MgO：LiNbO3产生二次谐波

以Nd:MgO:LiNbO_3同时兼作激活介质和非线性光学材料,研究自倍频激光器。用小型氙灯泵浦,在室温下获得二次谐波激光(0.547μm) 阈值小于4.8'J,最大输出400μJ/shot,工作温度范围大于20℃～45℃,无光损伤。     

Laser pulse heating of steel surface and flexural wave analysis

Laser gas-assisted material processing finds wide application in industry. The modelling of heating, elastic response of the substrate material, and the wave analysis gives insight into the laser workpiece interaction. In the present study, laser gas-assisted heating of steel is considered. The normal component of the thermal stress is taken as the source of load for the flexural wave generation in the material. The flexural wave generated is simulated and the wave characteristics are analyzed at four locations at the workpiece surface. The numerical scheme employing a control volume approach is introduced when solving the governing equations of flow and heat transfer while finite element and spectran element methods are used when solving the stress and wave equations. It is found that the normal component of the stress is tensile. The dispersion effect of the workpiece material, interference of the reflected beam, and partial overlapping of second mode of the travelling wave enable to identify a unique pattern in the travelling wave in the substrate.     

回旋管输出窗热性质的研究

一、引 言 输出窗是回旋管的能量输出端口,它的特性直接影响到回旋管的性能和寿命。输出窗的设计包括电特性和热特性的研究。当输出功率增加时,热特性的研究变得非常重要以便寻求合理有效的冷却措施。 输出窗由波导和介质片(块)两部分组成。回旋管的输出波导是圆波导,介质一般做成     

A floating-point genetic algorithm for solving the unit commitment problem

This paper proposes a floating-point genetic algorithm (FPGA) to solve the unit commitment problem (UCP). Based on the characteristics of typical load demand, a floating-point chromosome representation and an encoding–decoding scheme are designed to reduce the complexities in handling the minimum up/down time limits. Strategic parameters of the FPGA are characterized in detail, i.e., the evaluation function and its constraints, population size, operation styles of selection, crossover operation and probability, mutation operation and probability. A dynamic combination scheme of genetic operators is formulated to explore and exploit the FPGA in the non-convex solution space and multimodal objective function. Experiment results show that the FPGA is a more effective technique among the various styles of genetic algorithms, which can be applied to the practical scheduling tasks in utility power systems.     

钯作基体改进剂FIA－HG－GFAAS法测定锗及其机理研究

采用钯，钯－镁作基体改进剂，ＦＩＡ－ＨＧ－ＧＦＡＡＳ法成功地测定了锗。灵敏度、精密度和分析速度都得到很大的提高。峰值吸收的特征质量８．０ｐｇ，检出限１０．９ｐｇ，相对标准偏差０．３４％，同时探讨了基体改进剂钯的稳定作用机理及锗在石墨管中的原子化机理。     

Pointwise and L2 bounds in some nonstandard problems for the heat equation

We consider some initial-boundary value problems for the linear and nonlinear heat equation where the gradient of the solution is prescribed on the boundary. Assuming that a solution exists, we obtain bounds for the solution and its gradient by maximum principle arguments or by means of differential and integral inequalities.     

The solution existence of general variational inclusion problems

We propose general variational inclusion problems which are slightly different from corresponding problems considered in several recent papers in the literature and show that they are advantageous. Sufficient conditions for the solution existence are established. As applications we derive consequences for several special cases of variational inclusion problems, quasioptimization problems, equilibrium problems and implicit variational inequalities and show that they improve the results of some recent existing papers.