WO3/(TiO2-SiO2)催化剂的表面分散状态及催化性能的研究

用气相流动吸附法制备复合载体,用浸渍法制备WO3/(TiO2-S iO2)催化剂.应用LRS和TPR技术研究WO3在复合载体TIO2-S iO2表面的分散状态,发现TiO2在S iO2表面的分散可增强WO3与载体之间的相互作用,提高WO3在载体表面的分散阈值.另外TPR实验证明,TiO2的存在不仅大大改善WO3的分散状态,而且使WO3在TiO2-S iO2的还原温度升高,WO3与载体之间的作用增强.负载于经TiO2调变的S iO2上的催化剂其HDS、HYD、BHD活性高于负载于单纯S iO2上的催化剂的活性.     

Direct measurement of gas solubility and diffusivity in poly(vinylidene fluoride) with a high-pressure microbalance

We present solubility and diffusion data for the gases methane and carbon dioxide in the polymer poly(vinylidene fluoride). The polymer was cut from extruded piping intended for use in offshore oil and gas applications. Measurements were carried out using a purpose-built high-pressure microbalance. These properties were determined in the temperature range 80-120 °C and in the pressure range 50-150 bar for methane and 20-40 bar for carbon dioxide. In general, good agreement was obtained for similar measurements reported in the literature. Solubility follows a Henry’s law (linear) dependence with pressure. Diffusion coefficients for each of the gases in the polymer were also measured using the balance. Activation energies for diffusion and heats of solution for the two gases in the polymer were also determined.     

Investigation of Tomato Plant Defence Response to Tobacco Mosaic Virus by Determination of Methyl Salicylate with SPME-Capillary GC-MS

Headspace SPME was applied to investigation of tomato plant defence response to tobacco mosaic virus (TMV) by determination of compounds emitted from tomato plants at the extraction conditions of 25 °C and 15 min. It was found that TMV-inoculated tomato plant released large amount of methyl salicylate (MeSA) as response to TMV and MeSA concentration changed dramatically with time after inoculation. Gaseous MeSA as a signaling compound could induce in surrounding tomato plants to produce salicylic acid (SA) and synthesize and release MeSA. These results show that MeSA might be an airborne plant-signalling molecule in tomato plant response to TMV. The present method provided low detection limit of 2.0 ng L^–1 and needed little sample preparation time (15 min), so the method makes it easy to find the critical times of tomato plant response to TMV by fast determination of MeSA released from tomato plant.     

Liquid–solid disk extraction followed by supercritical fluid elution and gas chromatography of phenols from water

A method combining the techniques of liquid – solid disk extraction (LSDE) and supercritical fluid elution (SFE) has been developed for the phenols regulated by the Clean Water Act. LSDE uses a disk or membrane made of polytetrafluoroethylene (PTFE) fibrils impregnated with small particles, e.g. styrene divinylbenzene (SDB) resin, to extract phenols from water. After disk extraction the retained analytes are eluted from the disk using SFE. SFE is used as an alternative to liquid solvent elution with an organic solvent. Analytes are separated, identified, and quantified using gas chromatography – ion trap detector mass spectrometry (GC-ITDMS). The method is capable of sub parts per billion detection limits, and precision of 5–28% RSD. Evaluation of various disks or membranes, such as C₁₈-silica disks, SDB disks, and ion exchange membranes, has also been performed for the extraction of phenols from water. The results obtained from the in-situ aqueous acetylation of phenols and extraction of their acetates are quantitative. The utilization of LSDE and SFE techniques has proven to be a more effective approach than liquid – liquid extraction in minimizing air pollution and solvent waste.     

GAS PERMEABILITY OF COPOLY(1-TRIMETHYL-SILYL-1-PROPYNE-PENTAMETHYL-DISILYL-1-PROPYNE) MEMBRANE

The permeability of copoly (1-trimethylsilyl-1-propyne-pentamethyldisilyl-1-propyne) membrane for twelve gases (0_2, N_2, CO_2, H_2, D_2, He, At, CH_4, C_2H_4, C_2H_6, C_3H_6 and C_3H_8) was examined. The basic laws of solution and diffusion of the gases in the membrane were expounded preliminarily. It was found that a linear relationship between logarithm of diffusion coefficient (D) and critical molar volume (V_c) of the gases. The permeation characteristics of the gases in the copoly (1-trimethylsilyl-1-propyne-pentamethyldisilyl-1-propyne) membrane was also discussed.     

Sol-gel polyimide-silica composite membrane: gas transport properties

The effect of introduction of silica particles prepared by the sol-gel technique on the gas transport properties of a polyimide film was studied. The sorption and permeation of N₂, O₂, CO₂, H₂ and CH₄ were studied and correlated with morphological changes in the polymer structure. From sorption isotherms, we observed that the composite membrane presents higher solubility coefficients than the polyimide one. The solubility coefficient ratio between the composite and the polyimide is about 1.5–2.0. The isotherms were analyzed in terms of the dual mode sorption. The Henry's coefficient and the Langmuir's affinity and saturation constants were obtained allowing to calculate the Langmuir to Henry concentration ratios as function of the gas pressure. These ratios decrease until zero within a certain pressure range as long as the Langmuir's mode is acting and they are higher for the polyimide membrane when compared with the composite one. This study was completed with calorimetric measurements during the sorption. The gas interaction energy in kJ/mol decreases within the same pressure range as previously described. The measured energies are higher for the polyimide film when compared with the composite one because the polyimide membrane presents a stronger energetic effect caused by a higher Langmuir's contribution. From permeation studies at 3.15⁵ Pa, the composite membrane showed higher permeability coefficients and permselectivities than the polyimide one. All these results were explained, taking into account the difference on the imidization degree of both membranes and the morphological changes which may be induced by the silica nodules in the organic/inorganic interphases.     

Fluidized-bed extraction of polycyclic aromatic hydrocarbons from contaminated soil samples

Summary Due to the carcinogenity and ubiquity of polycyclic aromatic hydrocarbons in the environment they are of ongoing interest to analytical chemistry. In this study, a comparison of the classic Soxhlet extraction and, fluidized-bed extraction, has been conducted. The extraction of polycyclic aromatic hydrocarbons by this technique has been optimized considering as experimental variables the variation of the number of extraction cycles and the holding time after reaching the heating temperature by means of a surface response design. The significance of the operational parameters of the fluidized-bed extraction on the performance characteristics has been investigated. For the determination of the analytes a selective clean-up of the extracts followed by a fast gas chromatography method with mass spectrometric detection was used, resulting in low limits of detection (0.2 pg μL⁻¹). The accuracy of the complete analytical method was established by extraction and analysis of reference materials.     

On-column injection onto capillary columns. Part 2: Study of sampling conditions; practical recommendations

During one year continuous use of on-column injection, the typical advantages described in our first report have fully been confirmed. In addition the analysis of large sample volumes has proved promising. Only minor modifications have been applied to the on-column injector device. Broad evidence has been gathered showing that full separation efficiency of the capillary columns after on-column injection is attained only when cold trapping or the solvent effect, as band shortening mechanisms, are working- While, under the conditions of on-column injection, cold trapping is less efficient than with other injection techniques, the opposite holds true for the solvent effect. Compared with splitless injection, the danger of excessive solvent condensation on the column is increased. A working rule is presented for establishing the optimal chromatographic conditions for handling large sample volumes while ensuring full separation efficiency yet avoiding harm to the column.     

Analysis of carboxylic acids by gas chromatography of acetonyl esters. Application to aromatic,dicarboxylic and higher fatty acids

Summary The gas chromatographic analysis of the acetonyl esters of aromatic, dicarboxylic and higher fatty acids is reported and discussed together with their electron impact and chemical ionisation mass spectra. An improved method for the preparation of acetonyl esters is discussed.     

Der Gaskomplex MnAlF5 und sein Einfluß auf die sublimative Reinigung von AlF3

The Gas Complex MnAlF₅ and its Influence on the Purification of AlF₃ by Sublimation The gas complex MnAlF₅ has been determined mass spectroscopically by the ions MnAlF₅⁺ and MnAlF₄⁺. The gas complex MnAlF₅ is formed above 973 K by heating up mixtures of AlF₃/MnF₂ or AlF₃ · 3 H₂O endowed with Mn²⁺ or by heating up solid MnAlF₅ too. At 1 008 K the enthalpie of dissociation is 197 kJ/mole. The equilibrium structures of the high spin molecule MnAlF₅ (S = 5/2) were examined with ab initio calculations at the HF-level by comlete gradient optimizing. Two minimum structures were found on the potential energy surface. A bidentate fluorine bridged structure was found to be the most stable at the HF-level. Vibrational frequencies and thermodynamic functions of complex formation were estimated for both minimum structures. The importance of the formation of the gas complex for the separation of MnF₂ and AlF₃ by sublimation is discussed.